Pore-scale observations of supercritical CO2 drainage in Bentheimer sandstone by synchrotron x-ray imaging

a b s t r a c t This work utilizes synchrotron-based x-ray computed microtomography (x-ray CMT) imaging to quantify the volume and topology of supercritical carbon dioxide (scCO2) on a pore-scale basis throughout the primary drainage process of a 6 mm diameter Bentheimer sandstone core. Experiments were performed with brine and scCO2 at 8.3 MPa (1200 psi) and 37.5 ◦ C. Capillary pressure-saturation curves for the scCO2- brine system are presented and compared to the ambient air-brine system, and are shown to overlay one another when pressure is normalized by interfacial tension. Results are analyzed from images with a voxel resolution of 4.65 m; image-based evidence demonstrates that scCO2 invades the pore space in a capillary fingering regime at a mobility ratio M = 0.03 and capillary number Ca = 10 −8.6 to an end-of- drainage brine saturation of 9%. We provide evidence of the applicability of previous two-dimensional micromodel studies and ambient condition experiments in predicting flow regimes occurring during scCO2 injection. © 2014 Elsevier Ltd. All rights reserved.

[1]  B. Metz.  IPCC special report on carbon dioxide capture and storage , 2005 .

[2]  M. Honarpour,et al.  The effects of rock characteristics on relative permeability , 1990 .

[3]  Martin J. Blunt,et al.  Residual CO2 imaged with X‐ray micro‐tomography , 2011 .

[4]  Xiaochun Li,et al.  Experimental study of crossover from capillary to viscous fingering for supercritical CO2-water displacement in a homogeneous pore network. , 2013, Environmental science & technology.

[5]  Christopher H. Pentland,et al.  The influence of pore space geometry on the entrapment of carbon dioxide by capillary forces , 2012 .

[6]  Yildiray Cinar,et al.  An experimental investigation of the balance between capillary, viscous, and gravitational forces during CO2 injection into saline aquifers , 2011 .

[7]  M. Blunt,et al.  Pore-scale imaging and modelling , 2013 .

[8]  Fluid topology, pore size and aspect ratio during imbibition , 1988 .

[9]  S. Bachu,et al.  Interfacial Tension between CO2, Freshwater, and Brine in the Range of Pressure from (2 to 27) MPa, Temperature from (20 to 125) °C, and Water Salinity from (0 to 334 000) mg·L−1 , 2009 .

[10]  R. Ketcham,et al.  Acquisition, optimization and interpretation of X-ray computed tomographic imagery: applications to the geosciences , 2001 .

[11]  Martin J. Blunt,et al.  Design of carbon dioxide storage in aquifers , 2009 .

[12]  D. Broseta,et al.  Are rocks still water‐wet in the presence of dense CO2 or H2S? , 2012 .

[13]  Sally M. Benson,et al.  Microtomography and Pore-Scale Modeling of Two-Phase Fluid Distribution , 2011 .

[14]  Peter J. Eng,et al.  Geoscience applications of x-ray computed microtomography , 1999, Optics & Photonics.

[15]  Philippe Renard,et al.  Connectivity metrics for subsurface flow and transport , 2013 .

[16]  R. Lenormand,et al.  Mechanisms of the displacement of one fluid by another in a network of capillary ducts , 1983, Journal of Fluid Mechanics.

[17]  M. Blunt,et al.  Measurements of the capillary trapping of super‐critical carbon dioxide in Berea sandstone , 2011 .

[18]  Martin J. Blunt,et al.  Immiscible Displacements and Capillary Trapping in CO2 Storage , 2011 .

[19]  M. Blunt,et al.  Residual CO2 trapping in Indiana limestone. , 2013, Environmental science & technology.

[20]  Stig Bakke,et al.  Extending Predictive Capabilities to Network Models , 1998 .

[21]  Dorthe Wildenschild,et al.  Effect of fluid topology on residual nonwetting phase trapping: Implications for geologic CO 2 sequestration , 2013 .

[22]  Cesar Zarcone,et al.  Numerical models and experiments on immiscible displacements in porous media , 1988, Journal of Fluid Mechanics.

[23]  Jay W. Grate,et al.  Influence of Viscous and Capillary Forces on Immiscible Fluid Displacement: Pore-Scale Experimental Study in a Water-Wet Micromodel Demonstrating Viscous and Capillary Fingering , 2011 .

[24]  Ryan T. Armstrong,et al.  Exploring capillary trapping efficiency as a function of interfacial tension, viscosity, and flow rate , 2011 .

[25]  Ioannis Chatzis,et al.  Entrapment and Mobilization of Residual Oil in Bead Packs , 1988 .

[26]  Stefan Bachu,et al.  Effects of in-situ conditions on relative permeability characteristics of CO2-brine systems , 2008 .

[27]  S. Benson,et al.  Capillary pressure and heterogeneity for the CO2/water system in sandstone rocks at reservoir conditions , 2011 .

[28]  D. Wildenschild,et al.  Quantitative Analysis of Flow Processes in a Sand Using Synchrotron‐Based X‐ray Microtomography , 2005, Vadose Zone Journal.

[29]  H. Bertin,et al.  Interfacial tension measurements and wettability evaluation for geological CO2 storage , 2009 .

[30]  S. Benson,et al.  Core-scale experimental study of relative permeability properties of CO2 and brine in reservoir rocks , 2009 .

[31]  Mark L. Rivers,et al.  Using X-ray computed tomography in hydrology: systems, resolutions, and limitations , 2002 .

[32]  Sally M. Benson,et al.  Relative permeability and trapping of CO2 and water in sandstone rocks at reservoir conditions , 2012 .

[33]  Kuldeep Chaudhary,et al.  Pore‐scale trapping of supercritical CO2 and the role of grain wettability and shape , 2013 .

[34]  Morteza Akbarabadi,et al.  Relative permeability hysteresis and capillary trapping characteristics of supercritical CO2/brine systems: An experimental study at reservoir conditions , 2013 .

[35]  D. Wildenschild,et al.  X-ray imaging and analysis techniques for quantifying pore-scale structure and processes in subsurface porous medium systems , 2013 .

[36]  E. Lavernia,et al.  An experimental investigation , 1992, Metallurgical and Materials Transactions A.

[37]  J. Bruining,et al.  Capillary pressure for the sand–CO2–water system under various pressure conditions. Application to CO2 sequestration , 2007 .