Convective heat transfer measurements from a NACA 0012 airfoil in flight and in the NASA Lewis Icing Research Tunnel

Local heat transfer coefficients from a smooth and roughened NACA 0012 airfoil were measured using a steady state heat flux method. Heat transfer measurements on the specially constructed 0.533 meter chord airfoil were made both in flight on the NASA Lewis Twin Otter Research Aircraft and in the NASA Lewis Icing Research Tunnel (IRT). Roughness was obtained by the attachment of small, 2 mm diameter, hemispheres of uniform size to the airfoil surface in four distinct patterns. The flight data was taken for the smooth and roughened airfoil at various Reynolds numbers based on chord in the range of 1.24x10(exp 6) to 2.50x10(exp 6) and at various angles of attack up to 4 degrees. During these flight tests the free stream velocity turbulence intensity was found to be very low (less than 0.1 percent). The wind tunnel data was taken in the Reynolds number range of 1.20x10(exp 6) to 4.52x10(exp 6) and at angles of attack from -4 degrees to +8 degrees. The turbulence intensity in the IRT was 0.5 to 0.7 percent with the cloud making spray off. Results for both the flight and tunnel tests are presented as Frossling number based on chord versus position on the airfoil surface for various roughnesses and angle of attack. A table of power law curve fits of Nusselt number as a function of Reynolds number is also provided. The higher level of turbulence in the IRT versus flight had little effect on heat transfer for the lower Reynolds numbers but caused a moderate increase in heat transfer at the higher Reynolds numbers. Turning on the cloud making spray air in the IRT did not alter the heat transfer. Roughness generally increased the heat transfer by locally disturbing the boundary layer flow. Finally, the present data was not only compared with previous airfoil data where applicable, but also with leading edge cylinder and flat plate heat transfer values which are often used to estimate airfoil heat transfer in computer codes.

[1]  Tuncer Cebeci,et al.  Effects of enviromentally imposed roughness on airfoil performance , 1987 .

[2]  Kenneth J. Witt,et al.  Measurement of local convective heat transfer coefficients from a smooth and roughened NACA-0012 airfoil - Flight test data , 1988 .

[3]  S. J. Kline,et al.  Describing Uncertainties in Single-Sample Experiments , 1953 .

[4]  J. K. Hardy,et al.  Protection of Aircraft Against Ice , 1947, The Journal of the Royal Aeronautical Society.

[5]  Gary A. Ruff,et al.  Users Manual for the NASA Lewis Ice Accretion Prediction Code (LEWICE) , 1990 .

[6]  A D Young,et al.  Aircraft Excrescence Drag , 1981 .

[7]  B. L. Messinger Equilibrium Temperature of an Unheated Icing Surface as a Function of Air Speed , 1953 .

[8]  R. I. Vachon,et al.  The effect of turbulence on heat transfer from heated cylinders , 1975 .

[9]  H. Schlichting,et al.  Experimental Investigation of the Problem of Surface Roughness , 1937 .

[10]  R. J. Shaw,et al.  Ice shapes and the resulting drag increase for a NACA 0012 airfoil , 1984 .

[11]  Carr B. Neel,et al.  The Calculation of the Heat Required for Wing Thermal Ice Prevention in Specified Icing Conditions , 1948 .

[12]  G. James Vanfossen,et al.  Convective heat transfer measurements from a NACA 0012 airfoil in flight and in the NASA Lewis Icing Research Tunnel , 1990 .

[13]  Robert E. Wilson,et al.  Fundamentals of momentum, heat, and mass transfer , 1969 .

[14]  Y. S. Touloukian,et al.  Tables of thermal properties of gases , 1955 .

[15]  R. J. Simoneau,et al.  Heat transfer distributions around nominal ice accretion shapes formed on a cylinder in the NASA Lewis Icing Research Tunnel , 1984 .

[16]  James P. Lewis,et al.  Comparison of Heat Transfer from Airfoil in Natural and Simulated Icing Conditions , 1951 .