Experimental investigation and 3D finite element prediction of the heat affected zone during laser assisted machining of Ti6Al4V alloy

An experimental study was conducted to characterize the heat affected zone produced when laser heating a Ti6Al4V alloy plate workpiece. The emissivity and absorptivity of the Ti6Al4V alloy were determined experimentally. A 3D transient finite element method for a moving Gaussian laser heat source was developed to predict the depth and width of the heat affected zone on the Ti6Al4V alloy workpiece. There was a close correlation between the experimental data and the simulation results. It was found that the depth and width of the heat affected zone were strongly dependent on the laser parameters (laser power, laser scan speed, the angle of incidence and the diameter of the laser spot) and material properties (thermal conductivity, specific heat and density). Parametric studies showed that the depth and width of the heat affected zone increased with an increase in the laser power and decreased with an increase of the laser spot size and the laser scan speed. The thermal model can be used to determine the laser parameters for a given cut geometry that will yield no residual heat affected zone in the material after cutting. This provides the basis to optimize and improve laser assisted machining technique.

[1]  Z. G. Wang,et al.  A Review on High-Speed Machining of Titanium Alloys ∗ , 2006 .

[2]  Y. Shin,et al.  Experimental Investigation of Thermo-Mechanical Characteristics in Laser-Assisted Machining of Silicon Nitride Ceramics , 1999, Manufacturing Science and Engineering.

[3]  Frank P. Incropera,et al.  Fundamentals of Heat and Mass Transfer , 1981 .

[4]  M C Anderson,et al.  Laser-assisted machining of an austenitic stainless steel: P550 , 2006 .

[5]  K. Mills.  Recommended Values of Thermophysical Properties for Selected Commercial Alloys , 2001 .

[6]  Shreyes N. Melkote,et al.  Characterization and prediction of the heat-affected zone in a laser-assisted mechanical micromachining process , 2008 .

[7]  N. Dahotre,et al.  Laser Fabrication and Machining of Materials , 2007 .

[8]  P. Coppa,et al.  Normal emissivity of samples surrounded by surfaces at diverse temperatures , 2005 .

[9]  James G. Harris,et al.  Parametric Investigation of Laser‐Assisted Machining of Commercially Pure Titanium , 2008 .

[10]  S. Sun,et al.  Numerical and Experimental Investigation of the Heat-Affected Zone in a Laser-Assisted Machining of Ti-6Al-4V Alloy Process , 2009 .

[11]  V. L. Hill,et al.  Machining aerospace alloys with the aid of a 15 kW laser , 1982 .

[12]  S. Kou,et al.  A Fundamental Study of Laser Transformation Hardening , 1983 .

[13]  Y. Shin,et al.  Laser-assisted machining of Inconel 718 with an economic analysis , 2006 .

[14]  Y. Shin,et al.  Experimental Evaluation of the Laser Assisted Machining of Silicon Nitride Ceramics , 1998, Manufacturing Science and Engineering.

[15]  Michael F. Ashby,et al.  The transformation hardening of steel surfaces by laser beams—I. Hypo-eutectoid steels , 1984 .

[16]  George Chryssolouris,et al.  Laser Assisted Machining: An Overview , 1997 .

[17]  D. Pantelis,et al.  Development and experimental validation of analytical thermal models for the evaluation of the depth of laser-treated zones , 1998 .