1.3 kW monolithic linearly polarized single-mode master oscillator power amplifier and strategies for mitigating mode instabilities

We report on the high-power amplification of a 1064 nm linearly polarized laser in an all-fiber polarization-maintained master oscillator power amplifier, which can operate at an output power level of 1.3 kW. The beam quality (M2) was measured to be <1.2 at full power operation. The polarization extinction rate of the fiber amplifier was measured to be above 94% before mode instabilities (MIs) set in, which reduced to about 90% after the onset of MI. The power scaling capability of strategies for suppressing MI is analyzed based on a semianalytical model, the theoretical results of which agree with the experimental results. It shows that mitigating MI by coiling the gain fiber is an effective and practical method in standard double-cladding large mode area fiber, and, by tight coiling of the gain fiber to the radius of 5.5 cm, the MI threshold can be increased to three times higher than that without coiling or loose coiling. Experimental studies have been carried out to verify the idea, which has proved that MI was suppressed successfully in the amplifier by proper coiling.

[1]  Cesar Jauregui,et al.  Controlling mode instabilities by dynamic mode excitation with an acousto-optic deflector. , 2013, Optics express.

[2]  Lei Zhang,et al.  A 100 W all-fiber linearly-polarized Yb-doped single-mode fiber laser at 1120 nm. , 2012, Optics express.

[3]  Clint Zeringue,et al.  Gain-tailored SBS suppressing photonic crystal fibers for high power applications , 2012, Other Conferences.

[4]  Almantas Galvanauskas,et al.  Analytical time-dependent theory of thermally induced modal instabilities in high power fiber amplifiers , 2013, Photonics West - Lasers and Applications in Science and Engineering.

[5]  Kunimasa Saitoh,et al.  All-solid photonic bandgap fibers for high power lasers , 2012, Optics/Photonics in Security and Defence.

[6]  Mette Marie Jørgensen,et al.  Modal instability of rod fiber amplifiers: a semi-analytic approach , 2013, Photonics West - Lasers and Applications in Science and Engineering.

[7]  Shanhui Xu,et al.  A 1014 nm linearly polarized low noise narrow-linewidth single-frequency fiber laser. , 2013, Optics express.

[8]  Cesar Jauregui,et al.  Temporal dynamics of mode instabilities in high-power fiber lasers and amplifiers. , 2012, Optics express.

[9]  Frank Becker,et al.  Completely monolithic linearly polarized high-power fiber laser oscillator , 2014, Photonics West - Lasers and Applications in Science and Engineering.

[10]  L. Goldberg,et al.  Single-mode operation of a coiled multimode fiber amplifier. , 2000, Optics letters.

[11]  Arlee V. Smith,et al.  Mode instability in high power fiber amplifiers. , 2011, Optics express.

[12]  Andreas Tünnermann,et al.  High-power linear-polarized narrow linewidth photonic crystal fiber amplifier , 2010, LASE.

[13]  K. Hansen,et al.  167 W, power scalable ytterbium-doped photonic bandgap fiber amplifier at 1178 nm. , 2010, Optics express.

[14]  Kristian Rymann Hansen,et al.  Fiber amplifiers under thermal loads leading to transverse mode instability , 2014, Photonics West - Lasers and Applications in Science and Engineering.

[15]  N. Peyghambarian,et al.  Low-noise narrow-linewidth fiber laser at 1550 nm (June 2003) , 2004, Journal of Lightwave Technology.

[16]  Bryce Samson,et al.  Recent Progress on Power Scaling Narrow Linewidth Fiber Amplifiers and Their Applications , 2013 .

[17]  Arlee V Smith,et al.  Steady-periodic method for modeling mode instability in fiber amplifiers. , 2013, Optics express.

[18]  Kristian Rymann Hansen,et al.  Impact of gain saturation on the mode instability threshold in high-power fiber amplifiers. , 2014, Optics express.

[19]  Marko Laurila,et al.  Distributed mode filtering rod fiber amplifier delivering 292W with improved mode stability. , 2012, Optics express.

[20]  J. Limpert,et al.  The impact of photodarkening on mode instabilities in high-power fiber laser systems , 2014 .

[21]  Kun Liu,et al.  210 W single-frequency, single-polarization, thulium-doped all-fiber MOPA. , 2014, Optics express.

[22]  Kristian Rymann Hansen,et al.  Theoretical analysis of mode instability in high-power fiber amplifiers. , 2013, Optics express.

[23]  Zejin Liu,et al.  Study of Mode Instabilities in High Power Fiber Amplifiers by Detecting Scattering Light , 2014 .

[25]  Liang Dong,et al.  Stimulated thermal Rayleigh scattering in optical fibers. , 2013, Optics express.

[26]  Eric Honea,et al.  Threshold power and fiber degradation induced modal instabilities in high-power fiber amplifiers based on large mode area fibers , 2014, Photonics West - Lasers and Applications in Science and Engineering.

[27]  Jörg Neumann,et al.  Beam quality degradation of a single-frequency Yb-doped photonic crystal fiber amplifier with low mode instability threshold power. , 2012, Optics letters.

[28]  Almantas Galvanauskas,et al.  Polarized, 100 kW peak power, high brightness nanosecond lasers based on 3C optical fiber , 2011, LASE.

[29]  J. H. Cole,et al.  Improved Bend Loss Formula Verified for Optical Fiber by Simulation and Experiment , 2007, IEEE Journal of Quantum Electronics.

[30]  Liang Dong,et al.  Bend performance of leakage channel fibers. , 2008, Optics express.

[31]  Arlee V. Smith,et al.  Increasing mode instability thresholds of fiber amplifiers by gain saturation. , 2013, Optics express.

[32]  K. Hejaz,et al.  Controlling mode instability in a 500 W ytterbium-doped fiber laser , 2014 .

[33]  Dietrich Marcuse,et al.  Curvature loss formula for optical fibers , 1976 .

[34]  Andreas Tünnermann,et al.  Build up and decay of mode instability in a high power fiber amplifier. , 2012, Optics express.

[36]  F. Jansen,et al.  Passive mitigation strategies for mode instabilities in high-power fiber laser systems. , 2013, Optics express.

[37]  Xiao-Jun Wang,et al.  Thermally induced mode distortion and its limit to power scaling of fiber lasers. , 2013, Optics express.

[38]  B. Ward,et al.  Origin of thermal modal instabilities in large mode area fiber amplifiers. , 2012, Optics express.