An analytical approach to predict web-warping and longitudinal strain in flexible roll formed sections of variable width

To reduce weight and improve passenger safety there is an increased need in the automotive industry to use Ultra High Strength Steel (UHSS) for structural and crash components. However, the application of UHSS is restricted by their limited formability and the difficulty of forming them in conventional stamping. An alternative method of manufacturing structural auto body parts from UHSS is the flexible roll forming process, which allows the manufacture of metal sheet with high strength and limited ductility into complex and weight-optimized components. One major problem in the flexible roll forming of UHSS is the web-warping defect, which is the deviation in height of the web area over the length of the profile. It has been shown that web-warping is strongly dependant to the permanent longitudinal strain formed in the flange of the part. Flexible roll forming is a continuous process with many roll stands, which makes numerical analysis extremely time intensive and computationally expensive. An analytical model of web-warping is therefore critical to improve design efficiency during the early process design stage before FEA is applied. This paper establishes for the first time an analytical model for the prediction of web-warping for the flexible roll forming of a section with variable width. The model is based on evaluating longitudinal edge strain in the flange of the part. This information is then used in combination with a simple geometrical model to investigate the relationship between web-warping and longitudinal strain with respect to process parameters.

[1]  Peter Groche,et al.  Development and verification of a one-step-model for the design of flexible roll formed parts , 2011 .

[2]  Hiroshi Ona,et al.  On Strain Distributions in the Formation of Flexible Channel Section Development of Flexible Cold Roll Forming Machine , 2008 .

[3]  Elizabeth A. Peck,et al.  Introduction to Linear Regression Analysis , 2001 .

[4]  Woo Chang Jeong,et al.  Application of hot press forming process to manufacture an automotive part and its finite element analysis considering phase transformation plasticity , 2009 .

[5]  Michael Lindgren,et al.  Cold roll forming of a U-channel made of high strength steel , 2007 .

[6]  Peter Groche,et al.  Self-Adjustment in Flexible Roll-Forming Lines , 2009 .

[7]  Jon Larrañaga,et al.  Geometrical accuracy improvement in flexible roll forming lines , 2011 .

[8]  Michael Lindgren,et al.  Roll forming of partially heated cold rolled stainless steel , 2009 .

[9]  Peter Groche,et al.  A Study on Flexible Roll Formed Products Accuracy by Means of FEA and Experimental Tests , 2011 .

[10]  Peter Groche,et al.  Analytic one-step-model for the design of flexible roll formed parts , 2006 .

[11]  Peter Groche,et al.  New tooling concepts for future roll forming applications , 2003 .

[12]  Kevin Eugene Dr. Sweeney,et al.  The application of roll forming for automotive structural parts , 2003 .

[13]  Sebastian Berner,et al.  Strategien zur Qualitätssteigerung flexibler Rollprofile , 2012 .

[14]  Peter Groche,et al.  Cold rolled profiles for vehicle construction , 2008 .

[15]  Joseba Mendiguren,et al.  The effect of process parameters on web-warping in the flexible roll forming of UHSS , 2013 .

[16]  S. M. Panton,et al.  Fundamental deformation types and sectional properties in roll forming , 1994 .

[17]  Joseba Mendiguren,et al.  The effect of tooling design parameters on web-warping in the flexible roll forming of UHSS , 2013 .