Time-dependent performance and constitutive model of EPDM rubber gasket used for tunnel segment joints

Abstract The waterproofing performance of rubber gaskets degrades with time and exerts a great influence on the water resistance of tunnel segment joints. As such, the time-dependent performance of rubber gaskets is an important study topic. Based on the service environment of tunnel segment joints, an accelerated ageing test was performed for EPDM rubber in groundwater environment to obtain the rule of its performance degradation. In this study, a time-dependent constitutive model of an ethylene propylene diene monomer (EPDM) rubber gasket used for segment joints was proposed according to the change rule of the mechanical properties of materials after ageing, and the results of laboratory-scale ageing tests were used to obtain expressions of the time-dependent parameters of the rubber gasket in the model. The transformation relations between time and temperature of material ageing in the laboratory and service environment were subsequently established. Finally, the established model was used to analyse the time-dependent parameters of EPDM and determine the attenuation rule of its mechanical properties. When the increase rate of model parameters exceeded the degradation speed of material performance, stress relaxation influenced the performance degradation of segment joints.

[1]  Dana R Rottach,et al.  A New Constitutive Model for the Chemical Aging of Rubber Networks in Deformed States , 2008 .

[2]  Edward J. Cording,et al.  Concrete segment tunnel lining sealant performance under earthquake loading , 2012 .

[3]  Mary C. Boyce,et al.  Constitutive modeling of the large strain time-dependent behavior of elastomers , 1998 .

[4]  Martin Kroon,et al.  A constitutive model for strain-crystallising Rubber-like materials , 2010 .

[5]  R. M. Natal Jorge,et al.  A Comparative Study of Several Material Models for Prediction of Hyperelastic Properties: Application to Silicone‐Rubber and Soft Tissues , 2006 .

[6]  Pierre Charrier,et al.  Identification of constitutive model for rubber elasticity from micro-indentation tests on natural rubber and validation by macroscopic tests , 2011 .

[7]  S. Logan,et al.  The Origin and Status of the Arrhenius Equation , 1982 .

[8]  Y. G. Hsuan,et al.  Aging of Geomembranes Used in Hydraulic Structures , 2008 .

[9]  Moussa Nait-Abdelaziz,et al.  Modelling large deformation behaviour under loading-unloading of semicrystalline polymers: Application to a high density polyethylene , 2010 .

[10]  M. Santare,et al.  Effect of Time-Dependent Material Properties on the Mechanical Behavior of PFSA Membranes Subjected to Humidity Cycling , 2012 .

[11]  Michael H. Santare,et al.  Time-dependent mechanical response of a composite PFSA membrane , 2013 .

[12]  Reza Naghdabadi,et al.  A hyperelastic constitutive model for rubber-like materials , 2013 .

[13]  P. Charrier,et al.  A continuum damage model for the high-cycle fatigue life prediction of styrene-butadiene rubber under multiaxial loading , 2011 .

[14]  Moussa Nait-Abdelaziz,et al.  A visco-hyperelastic damage model for cyclic stress-softening, hysteresis and permanent set in rubber using the network alteration theory , 2014 .

[15]  V. Popov,et al.  A new constitutive model of rubber , 2007 .

[16]  R. Rajapakse,et al.  On the constitutive relations for catalyst coated membrane applied to in-situ fuel cell modeling , 2014 .

[17]  Sylvain Calloch,et al.  Limits in the validity of Arrhenius predictions for field ageing of a silica filled polychloroprene in a marine environment , 2014 .

[18]  M. Patel,et al.  Thermal ageing studies on room-temperature vulcanised polysiloxane rubbers , 2001 .

[19]  Tuan Ngo,et al.  Strain rate dependent constitutive model for predicting the material behaviour of polyurea under high strain rate tensile loading , 2014 .

[20]  Faisal I. Shalabi.  Behavior of Gasketed Segmental Concrete Tunnel Lining , 2001 .

[21]  Yann Marco,et al.  Ageing mechanism and mechanical degradation behaviour of polychloroprene rubber in a marine environment: Comparison of accelerated ageing and long term exposure , 2012 .

[22]  K. Gillen,et al.  Accelerated aging and lifetime prediction: Review of non-Arrhenius behaviour due to two competing processes , 2005 .

[23]  Xiao Longge,et al.  Experiment Study and Design on the Watertight Seal for Reinforced Concrete Segment Joint of Wuhan Yangtze River Tunnel , 2008 .

[24]  L. J. Ernst,et al.  Application of the network alteration theory for modeling the time-dependent constitutive behaviour of rubbers. Part I. General theory , 1998 .

[25]  M. Boyce,et al.  Stress–strain behavior of thermoplastic polyurethanes , 2005 .

[26]  F. Zaïri,et al.  A finite strain thermo-viscoelastic constitutive model to describe the self-heating in elastomeric materials during low-cycle fatigue , 2014 .

[27]  J. Arghavani,et al.  A visco-hyperelastic constitutive model for rubber-like materials: A rate-dependent relaxation time scheme , 2014 .

[28]  L. J. Ernst,et al.  Application of the network alteration theory for modeling the time-dependent constitutive behaviour of rubbers. Part II. Further evaluation of the general theory and experimental verification , 1998 .

[29]  M. Mooney.  A Theory of Large Elastic Deformation , 1940 .

[30]  D. Choqueuse,et al.  Durability of polydicyclopentadiene under high temperature, high pressure and seawater (offshore oil production conditions) , 2013 .

[31]  Thomas W. Dakin,et al.  Electrical Insulation Deterioration Treated as a Chemical Rate Phenomenon , 1948, Transactions of the American Institute of Electrical Engineers.

[32]  Guy Evrard,et al.  Accelerated ageing of polyurethanes for marine applications , 2007 .