High-Performance Uncooled 1.3-pm AlxGayIn 1 - Ix: - As/InP Strained-Layer Quantum-Well Lasers for Subscriber Loop Applications

Design considerations for fabricating highly efficient uncooled semiconductor lasers are discussed. The parameters investigated include the temperature characteristics of threshold current, quantum efficiency, and modulation speed. To prevent carrier overflow under high-temperature operation, the electron con6nement energy is increased by using the Al,Ga,Inl-,-, AshP material system instead of the conventional Ga,In1-,AsyP1-,/InP material system. To reduce the transparency current and the carrier-density-dependent loss due to the intervalence-band absorption, strained-layer quantum wells are chosen as the active layer. Experimentally, 1.3-pm compressive-strained five-quantum-well lasers and tensile-strained three-quantum-well lasers were fabricated using a 3-pm wide ridge-waveguide laser structure. For both types of lasers, the intrinsic material parameters are found to be similar in magnitude and in temperature dependence if they are normalized to each well. Specifically, the compressive-strained five-quantum-well lasers show excellent extrinsic temperature characteristics, such as small drop of 0.3 dB in differential quantum efficiency when the heat sink temperature changes from 25 to lOO"C, and a large small-signal modulation bandwidth of 8.6 GHz at 85°C. The maximum 3 dB modulation bandwidth was measured to be 19.6 GHz for compressive-strained lasers and 17 GHz for tensile-strained lasers by an optical modulation technique. The strong carrier confinement also results in a small Ic-factor (0.25 ns) which indicates the potential for high-speed modulation up to 35 GHz. In spite of the aluminum-containing active layer, no catastrophic optical damage was observed at mm temperature up to 218 mW for compressive-strained five-quantum-well lasers and 103 mW for tensile-strained three-quantum-well lasers. For operating the compressive- strained five-quantum-well lasers at 85°C with more than 5 mW output power, a mean-time-to-failure (MTTF) of 9.4 years is projected from a preliminary life test. These lasers are highly attractive for uncooled, potentially low-cost applications in the subscriber loop.

[1]  K. Uomi,et al.  Ultralow chirp and high-speed 1.55 mu m multiquantum well lambda /4-shifted DFB lasers , 1990, IEEE Photonics Technology Letters.

[2]  R. Glew,et al.  Very low threshold current density SCH-MQW laser diodes emitting at 1.55 mu m , 1989 .

[3]  R. Olshansky,et al.  Frequency response of 1.3µm InGaAsP high speed semiconductor lasers , 1987 .

[4]  L. F. Tiemeijer,et al.  High-performance 1.5 mu m wavelength InGaAs-InGaAsP strained quantum well lasers and amplifiers , 1991 .

[5]  R. D. Yadvish,et al.  High temperature characteristics of InGaAsP/InP laser structures , 1993 .

[6]  L. Coldren,et al.  Refractive indexes of (Al,Ga,In)As epilayers on InP for optoelectronic applications , 1992, IEEE Photonics Technology Letters.

[7]  John E. Bowers,et al.  High speed semiconductor laser design and performance , 1987 .

[8]  A. R. Adams,et al.  Band-structure engineering for low-threshold high-efficiency semiconductor lasers , 1986 .

[9]  E. O’Reilly,et al.  Improved performance due to suppression of spontaneous emission in tensile-strain semiconductor lasers , 1991 .

[10]  M. Pilkuhn,et al.  Quantitative evaluation of gain and losses in quaternary lasers , 1985 .

[11]  Mitsuo Fukuda,et al.  Reliability and degradation of semiconductor lasers and LEDs , 1991 .

[12]  Amnon Yariv,et al.  Scaling laws and minimum threshold currents for quantum-confined semiconductor lasers , 1988 .

[13]  Norihiro Iwai,et al.  High temperature operation of 1.3 mu m GaInAsP/InP GRINSCH strained-layer quantum well lasers , 1993 .

[14]  I. Joindot,et al.  Intervalence band absorption coefficient measurements in bulk layer, strained and unstrained multiquantum well 1.55 mu m semiconductor lasers , 1993 .

[15]  C. Zah,et al.  Low-threshold 1.5 mu m compressive-strained multiple- and single-quantum-well lasers , 1991 .

[16]  L. Tiemeijer,et al.  Improved performance of compressively as well as tensile strained quantum‐well lasers , 1992 .

[17]  Eli Yablonovitch,et al.  Band structure engineering of semiconductor lasers for optical communications , 1988 .

[18]  Rajaram Bhat,et al.  Very low threshold current density 1.5 μm GaInAs/AlGaInAs graded‐index separate‐confinement‐heterostructure strained quantum well laser diodes grown by organometallic chemical vapor deposition , 1991 .

[19]  W. J. Fritz,et al.  Analysis of aluminum gallium arsenide laser diodes failing due to nonradiative regions behind the facets , 1989 .

[20]  Niloy K. Dutta,et al.  Long wavelength semiconductor lasers , 1988, Technical Digest., International Electron Devices Meeting.

[21]  Rajaram Bhat,et al.  1.5 mu m compressive-strained multiquantum-well 20-wavelength distributed-feedback laser arrays , 1992 .

[22]  R. Bhat,et al.  Growth of high quality AlInAs by low pressure organometallic chemical vapor deposition for high speed and optoelectronic device applications , 1991 .

[23]  Y. Uematsu,et al.  Analysis and application of theoretical gain curves to the design of multi-quantum-well lasers , 1985, IEEE Journal of Quantum Electronics.

[24]  R. W. Glew,et al.  Intervalence band absorption in strained and unstrained InGaAs multiple quantum well structures , 1992 .

[25]  Van de Walle Cg.  Band lineups and deformation potentials in the model-solid theory. , 1989 .

[26]  L. Tiemeijer,et al.  Submilliamp threshold current (0.62 mA at 0 degrees C) and high output power (220 mW) 1.5 mu m tensile strained InGaAs single quantum well lasers , 1992 .

[27]  H. Sakaki,et al.  Multidimensional quantum well laser and temperature dependence of its threshold current , 1982 .