Potential Levels of Soot, NO x , HC and CO for Methanol Combustion

Methanol is today considered a viable green fuel for combustion engines because of its low soot emissions and the possibility of it being produced in a CO2-neutral manner. Methanol as a fuel for combustion engines have attracted interest throughout history and much research was conducted during the oil crisis in the seventies. In the beginning of the eighties the oil prices began to decrease and interest in methanol declined. This paper presents the emission potential of methanol. T-Φ maps were constructed using a 0-D reactor with constant pressure, temperature and equivalence ratio to show the emission characteristics of methanol. These maps were compared with equivalent maps for diesel fuel. The maps were then complemented with engine simulations using a stochastic reactor model (SRM), which predicts end-gas emissions. The SRM was validated using experimental results from a truck engine running in Partially Premixed Combustion (PPC) mode at medium loads. The SRM was able to predict the combustion in terms of pressure trace and rate of heat release. The CO and NOx emissions were matched, however, the HC emissions were underestimated. Finally, the trajectories from the SRM simulations were superimposed on the T-Φ maps to investigate the in engine conditions. The T-Φ map analysis shows that emission of soot are non-existent, formaldehyde can be avoided and that emissions of methane are kept at, compared to diesel combustion, low levels, however CO and NOx levels are similar to diesel combustion. These results were confirmed for engine conditions by the SRM simulations and the engine experiments.

[1]  G. Woschni.  A Universally Applicable Equation for the Instantaneous Heat Transfer Coefficient in the Internal Combustion Engine , 1967 .

[2]  G. Olah.  Beyond oil and gas: the methanol economy. , 2006, Angewandte Chemie.

[3]  T. Nilsson.  Development of a spray evaporation model for SRM simulations , 2012 .

[4]  Yunshan Ge,et al.  Carbonyl compound emissions from passenger cars fueled with methanol/gasoline blends. , 2010, The Science of the total environment.

[5]  Tomoyuki Wakisaka,et al.  A numerical study of the effects of boost pressure and exhaust gas recirculation ratio on the combustion process and exhaust emissions in a diesel engine , 2007 .

[6]  Shenghua Liu,et al.  Study of spark ignition engine fueled with methanol/gasoline fuel blends , 2007 .

[7]  K. Akihama,et al.  Mechanism of the Smokeless Rich Diesel Combustion by Reducing Temperature , 2001 .

[8]  Matthew J. Brusstar,et al.  High Efficiency and Low Emissions from a Port-Injected Engine with Neat Alcohol Fuels , 2002 .

[9]  L. Bromberg,et al.  Methanol as an Alternative Transportation Fuel in the U.S.: Options for Sustainable and/or Energy-Secure Transportation , 2010 .

[10]  Takeyuki Kamimoto,et al.  High Combustion Temperature for the Reduction of Particulate in Diesel Engines , 1988 .

[11]  F. Mauss,et al.  Aspects of 0D and 3D Modeling of Soot Formation for Diesel Engines , 2014 .

[12]  Dimitrios Moshou,et al.  Emissions characteristics of spark ignition engine operating on lower–higher molecular mass alcohol blended gasoline fuels , 2013 .

[13]  Yang Wang,et al.  An overview of methanol as an internal combustion engine fuel , 2015 .

[14]  J. Beckett,et al.  Automotive Materials Engineering Challenges and Solutions for the Use of Ethanol and Methanol Blended Fuels , 2010 .

[15]  Bengt Johansson,et al.  Quantification of the Formaldehyde Emissions from Different HCCI Engines Running on a Range of Fuels , 2005 .

[16]  M. Frenklach,et al.  Detailed modeling of soot particle nucleation and growth , 1991 .

[17]  M. Bergman,et al.  Application of Transient Temperature vs. Equivalence Ratio Emission Maps to Engine Simulations , 2007 .

[18]  Fabian Mauss,et al.  Comprehensive kinetic modeling and experimental study of a fuel-rich, premixed n-heptane flame , 2015 .

[19]  Lu Yang,et al.  The controversial fuel methanol strategy in China and its evaluation , 2014 .

[20]  Richard Pearson,et al.  Drive Cycle Analysis of Load Control Strategies for Methanol Fuelled ICE Vehicle , 2012 .

[21]  B. G. Richards,et al.  Methanol-Fueled Caterpillar 3406 Engine Experience in On-Highway Trucks , 1990 .

[22]  S. Pope.  PDF methods for turbulent reactive flows , 1985 .

[23]  Fabian Mauss,et al.  Analysis of a natural gas fuelled homogeneous charge compression ignition engine with exhaust gas recirculation using a stochastic reactor model , 2004 .

[24]  Martin Tuner,et al.  Gasoline PPC: A parametric study of late cycle mixing conditions using a predictive two-zone SRM modeling tool , 2013 .

[25]  G. Greeves,et al.  Origins of Hydrocarbon Emissions from Diesel Engines , 1977 .

[26]  Ruizhi Song,et al.  Performance and Emissions of a Diesel Engine Fuelled with Methanol , 2008 .

[27]  Mustafa Canakci,et al.  Impact of alcohol-gasoline fuel blends on the exhaust emission of an SI engine , 2013 .

[28]  B. Johansson,et al.  Transition from HCCI to PPC Combustion by Means of Start of Injection , 2015 .

[29]  Fabian Mauss,et al.  Diesel Engine Cycle Simulation with a Reduced Set of Modeling Parameters Based on Detailed Kinetics , 2009 .

[30]  B. Johansson,et al.  Analysis of Soot Particles in the Cylinder of a Heavy Duty Diesel Engine with High EGR , 2015 .

[31]  Martin Tuner,et al.  Diesel-PPC engine: Predictive Full Cycle Modeling with Reduced and Detailed Chemistry , 2011 .

[32]  Fabian Mauss,et al.  Self-Calibrating Model for Diesel Engine Simulations , 2012 .

[33]  Fabian Mauss,et al.  Parameterised Mixing Time Model for Diesel Engines Simulation , 2009 .

[34]  V. Golovitchev,et al.  Numerical Analysis of Combustion and Emissions Formation in a Heavy Duty DME Engine , 2012 .