Preparation and characterization of hybrid Nafion–silica membrane doped with phosphotungstic acid for high temperature operation of proton exchange membrane fuel cells

Abstract Nafion/silicon oxide (SiO2)/phosphotungstic acid (PWA) and Nafion/silicon oxide composite membranes were studied for the H2/O2 proton exchange membrane fuel cells (PEMFCs) operated above 100 °C. The composite membranes were prepared by the recasting procedure, using Nafion solution mixed with SiO2 and PWA/SiO2 mixtures. The physico-chemical properties of these recast composite membranes were studied by means of scanning electron microscopy (SEM), X-ray diffraction (XRD) analysis, thermogravimetry-DTA (TG-DTA) and Fourier transform infrared (FTIR) spectroscopy. These results showed that SiO2 and PWA are compatible with the Nafion membrane. Furthermore, the incorporation of the SiO2 and PWA into the Nafion membrane could increase the crystallinity of the Nafion recast membrane and also improve the initial degradation temperature of the Nafion membrane. It was found that the composite membrane showed a higher uptake of water compared with the Nafion recast membrane. The proton conductivity of the composite membranes appeared to be similar to that of the native Nafion membrane at high temperatures and at 100% relative humidity (RH), however, it was much higher at low RH. When the composite membranes viz. Nafion/SiO2/PWA and Nafion/SiO2 were employed as an electrolyte in H2/O2 PEMFC, the higher current density values (540 and 320 mA/cm2 at 0.4 V, respectively) were obtained than that of the Nafion 115 membrane (95 mA/cm2), under the operating condition of 110 °C and at the humidified temperature of 100 °C.

[1]  Sanjeev Mukerjee,et al.  Oxygen permeation studies on alternative proton exchange membranes designed for elevated temperature operation , 2003 .

[2]  Shuzi Hayase,et al.  Modified Nafion 117 as an Improved Polymer Electrolyte Membrane for Direct Methanol Fuel Cells , 2001 .

[3]  Paola Costamagna,et al.  Nafion® 115/zirconium phosphate composite membranes for operation of PEMFCs above 100 °C , 2002 .

[4]  P. Colomban,et al.  Equilibrium of the protonic species in hydrates of some heteropolyacids at elevated temperatures , 1991 .

[5]  K. Friedrich,et al.  Modified Nafion®-based membranes for use in direct methanol fuel cells , 2002 .

[6]  Robert B. Moore,et al.  TGA–FTi.r. investigation of the thermal degradation of Nafion® and Nafion®/[silicon oxide]-based nanocomposites , 1998 .

[7]  K. Friedrich,et al.  Transport properties of ionomer composite membranes for direct methanol fuel cells , 2002 .

[8]  A. Parthasarathy,et al.  Temperature Dependence of the Electrode Kinetics of Oxygen Reduction at the Platinum/Nafion® Interface—A Microelectrode Investigation , 1992 .

[9]  Michael D. Guiver,et al.  Proton conducting composite membranes from polyether ether ketone and heteropolyacids for fuel cell applications , 2000 .

[10]  Andrew B. Bocarsly,et al.  Silicon Oxide Nafion Composite Membranes for Proton-Exchange Membrane Fuel Cell Operation at 80-140°C , 2002 .

[11]  P. Staiti,et al.  Synthesis and characterization of proton-conducting materials containing dodecatungstophosphoric and dodecatungstosilic acid supported on silica , 1999 .

[12]  Ravindra Datta,et al.  Membrane‐Supported Nonvolatile Acidic Electrolytes Allow Higher Temperature Operation of Proton‐Exchange Membrane Fuel Cells , 1997 .

[13]  Itaru Honma,et al.  High Temperature Proton Conducting Organic/Inorganic Nanohybrids for Polymer Electrolyte Membrane Part II , 2002 .

[14]  Paola Costamagna,et al.  Approaches and technical challenges to high temperature operation of proton exchange membrane fuel cells , 2001 .

[15]  Antonino S. Aricò,et al.  Investigation of a direct methanol fuel cell based on a composite Nafion®-silica electrolyte for high temperature operation , 1999 .

[16]  T. Minami,et al.  Proton-conducting silica-gel films doped with a variety of electrolytes , 1994 .

[17]  V. Antonucci,et al.  Hybrid Nafion-silica membranes doped with heteropolyacids for application in direct methanol fuel cells , 2001 .

[18]  T. Springer,et al.  Water Uptake by and Transport Through Nafion® 117 Membranes , 1993 .

[19]  Bernd Bauer,et al.  Polymeric proton conducting membranes for medium temperature fuel cells (110–160°C) , 2001 .

[20]  R. Savinell,et al.  A Polymer Electrolyte for Operation at Temperatures up to 200°C , 1994 .

[21]  K. Kreuer,et al.  On the development of proton conducting materials for technological applications , 1997 .

[22]  Hiroyuki Uchida,et al.  Self‐Humidifying Polymer Electrolyte Membranes for Fuel Cells , 1996 .

[23]  Oumarou Savadogo,et al.  Parameters of PEM fuel-cells based on new membranes fabricated from Nafion®, silicotungstic acid and thiophene , 2000 .

[24]  Robert F. Savinell,et al.  Thermal Stability of Nafion® in Simulated Fuel Cell Environments , 1996 .