Influence of rheological properties of cement mortar on steel fiber distribution in UHPC

Abstract This paper aims to study the distribution of steel fibers in UHPC specimens prepared by different rheological cement mortar. Four levels of superplasticizer dosage were used for every water to binder ratio (0.18, 0.20, 0.22, 0.24) to adjust rheological properties of cement mortar mixtures (without steel fibers). Steel fibers were added by volume of 1%, 2% and 3% for every cement mortar mixture respectively. Cube specimens (70.7 × 70.7 × 70.7 mm3) were cast and cured under the same condition for every mixture and the distribution of steel fibers along casting depth was determined by digital image processing. The experimental results reveal that the flowability of fresh cement mortar increases and the yield stress decreases with the higher water to binder ratio and superplasticizer dosage. The plastic viscosity of fresh mixture is decreased by the higher water to binder ratio and little influenced by the variation of superplasticizer dosage. The fiber distribution along depth mainly depends on rheological parameters of fresh mixture, especially the yield stress. Moderate rheological parameters are necessary for obtaining an uniform distribution of steel fibers in UHPC. On the basis of this study, the optimal yield stress of fresh matrix ranges among 900–1000 Pa, 700–900 Pa and 400–800 Pa respectively for UHPC mixtures with 1%, 2% and 3% fiber volume fraction.

[1]  C. Shi,et al.  A review on ultra high performance concrete: Part I. Raw materials and mixture design , 2015 .

[2]  Fang Liu,et al.  Preparation of Ultra-High Performance Concrete with common technology and materials , 2012 .

[3]  Jan L. Vítek,et al.  UHPC – Development and Testing on Structural Elements , 2013 .

[4]  C. Măgureanu,et al.  Mechanical Properties and Durability of Ultra-High-Performance Concrete , 2012 .

[5]  Stan Wild,et al.  Influence of Superplasticizers on Workability of Concrete , 1999 .

[6]  Hjh Jos Brouwers,et al.  Mix design and properties assessment of Ultra-High-Performance Fibre Reinforced Concrete (UHPFRC) , 2014 .

[7]  D. Koch,et al.  Structure and properties of sheared fiber suspensions with mechanical contacts , 1997 .

[8]  Thierry Sedran,et al.  Mixture-proportioning of high-performance concrete , 2002 .

[9]  Surendra P. Shah,et al.  Correlation of fiber dispersion, rheology and mechanical performance of FRCs , 2007 .

[10]  Sofiane Amziane,et al.  Flowability of fibre-reinforced concrete and its effect on the mechanical properties of the material , 2010 .

[11]  Lucie Vandewalle,et al.  Distribution of steel fibres in rectangular sections , 2005 .

[12]  Phillip Frank Gower Banfill,et al.  Rheology of low carbon fibre content reinforced cement mortar , 2006 .

[13]  Chiara F. Ferraris,et al.  Testing and Modelling of Fresh Concrete Rheology , 2017 .

[14]  Katherine Kuder,et al.  Rheology of fiber-reinforced cementitious materials , 2007 .

[15]  C. Jolicoeur,et al.  The Influence of Temperature on the Rheological Properties of Superplasticized Cement Pastes , 1997, SP-173: Fifth CANMET/ACI International Conference on Superplasticizers and Other Chemical Admixtures in Concrete.

[16]  Victor C. Li,et al.  Rheology, fiber dispersion, and robust properties of Engineered Cementitious Composites , 2013 .

[17]  Phillip Frank Gower Banfill.  The effect of admixtures on the rheology of fresh concrete , 1983 .

[18]  Liberato Ferrara,et al.  Relationships between fibre distribution, workability and the mechanical properties of SFRC applied to precast roof elements , 2005 .

[19]  R. Gettu,et al.  Study of the distribution and orientation of fibers in SFRC specimens , 2005 .

[20]  A. Yahia,et al.  Rheology of belite-cement – Effect of w/c and high-range water-reducer type , 2015 .

[21]  Phillip Frank Gower Banfill,et al.  The rheology of fresh mortar , 1991 .

[22]  S. Hanehara,et al.  Effects of the chemical structure on the properties of polycarboxylate-type superplasticizer , 2000 .

[23]  Patrick Stähli,et al.  On flow properties, fibre distribution, fibre orientation and flexural behaviour of FRC , 2008 .

[24]  Olafur H. Wallevik,et al.  The effect of measuring procedure on the apparent rheological properties of self-compacting concrete , 2002 .

[25]  Parviz Soroushian,et al.  DISTRIBUTION AND ORIENTATION OF FIBERS IN STEEL FIBER REINFORCED CONCRETE , 1990 .

[26]  Eduardo Júlio,et al.  Statistical mixture design approach for eco-efficient UHPC , 2015 .