Experimental Study on Crack Bridging in FRC under Uniaxial Fatigue Tension

This paper presents an experimental study on crack bridging in steel-fiber-reinforced concrete (SFRC) materials under deformation-controlled uniaxial fatigue tension. Two types of commercially available steel fibers, straight steel fiber and hooked end steel fiber, were used separately in this experimental investigation. A total of six series of fatigue tensile tests with constant amplitude between maximum and minimum crack openings were conducted. The experimental results show that the bridging stress decreases with the number of load cycles, and this phenomenon is termed bridging degradation. The general behavior of the bridging degra- dation with the number of cycles in SFRCs is represented by a fast dropping stage (reduction in bridging stress within the first 10-15 cycles) with a decelerated degradation rate, followed by a stable stage with an almost constant degradation rate for straight SFRC, or by several periods with a decelerated rate in each period for hooked SFRC. Although fiber deformation, such as in hooked end fiber, can improve the monotonic crack bridging significantly, faster bridging degradation is found in hooked SFRC than in straight SFRC with the same maximum crack width (>0.1 mm) and minimum load condition.

[1]  Mitsuru Saito,et al.  Direct Tensile Fatigue of Concrete by the Use of Friction Grips , 1983 .

[2]  D. Rouby,et al.  Fatigue behaviour related to interface modification during load cycling in ceramic-matrix fibre composites , 1993 .

[3]  V. Li,et al.  Micromechanics of crack bridging in fibre-reinforced concrete , 1993 .

[4]  Antoine E. Naaman,et al.  PROPERTIES OF STEEL FIBER REINFORCED CONCRETE UNDER CYCLIC LOADING , 1988 .

[5]  Byung Hwan Oh,et al.  Fatigue Analysis of Plain Concrete in Flexure , 1986 .

[6]  C. Ball,et al.  Flexural Fatigue Strength of Steel Fiber Reinforced Concrete Beams , 1972 .

[7]  T. Hsu.  Fatigue of Plain Concrete , 1981 .

[8]  A. Evans,et al.  Fatigue of ceramic matrix composites , 1995 .

[9]  Kent Gylltoft,et al.  Fracture mechanics models for fatigue in concrete structures , 1983 .

[10]  H. Stang,et al.  Evaluation of crack width in FRC with conventional reinforcement , 1992 .

[11]  Colin D. Johnston,et al.  FLEXURAL FATIGUE PERFORMANCE OF STEEL FIBER REINFORCED CONCRETE - INFLUENCE OF FIBER CONTENT, ASPECT RATIO, AND TYPE , 1991 .

[12]  R. Tepfers,et al.  Fatigue Strength of Plain, Ordinary,and Lightweight Concrete , 1979 .

[13]  J. E. Gordon,et al.  A mechanism for the control of crack propagation in all-brittle systems , 1964, Proceedings of the Royal Society of London. Series A. Mathematical and Physical Sciences.

[14]  Hans W. Reinhardt,et al.  Tensile Tests and Failure Analysis of Concrete , 1986 .

[15]  Zhang Jun,et al.  Fatigue Performance in Flexure of Fiber Reinforced Concrete , 1998 .

[16]  D. Hordijk.  Local approach to fatigue of concrete , 1991 .

[17]  L. Rose,et al.  Time- or cycle-dependent crack bridging , 1994 .

[18]  V. Li,et al.  Buckling of bridging fibres in composites , 1994 .

[19]  V. Ramakrishnan,et al.  Flexural Fatigue Strength of Steel Fiber Reinforced Concrete , 1987 .

[20]  Surendra P. Shah,et al.  Softening Response of Plain Concrete in Direct Tension , 1985 .

[21]  Victor C. Li,et al.  FATIGUE CRACK GROWTH ANALYSIS OF FIBER REINFORCED CONCRETE WITH EFFECT OF INTERFACIAL BOND DEGRADATION , 1998 .