Effect of projectile shape during ballistic perforation of VARTM carbon/epoxy composite panels

The use of carbon/epoxy composites in aircraft, marine, and automotive structural applications is steadily increasing. Robust composite structures processed using low-cost techniques with the purpose of sustaining high velocity impact loads from various threats are of great interest. An example of a low-cost process is the out-of-autoclave, vacuum assisted resin transfer molding (VARTM) technique. The present study evaluates the perforation and damage evolution created by various projectile geometries in VARTM processed carbon/epoxy laminates. A series of ballistic impact tests have been performed on satin weave carbon/epoxy laminates of 3.2 and 6.5 mm thickness, with projectile geometries representing hemispherical, conical, fragment simulating and flat tip. A gas-gun with a sabot stripper mechanism was employed to impact the samples with 50-caliber projectiles of the different shapes. The perforation mechanism, ballistic limit, and damage evolution of each laminate has been studied. The influence of projectile shape in the VARTM carbon/epoxy laminates under high velocity impact followed the analytical predictions by Wen [Compos. Struct. 49 (2000) 321; Compos. Sci. Technol. 61 (2001) 1163]. The conical shaped projectile resulted in highest ballistic limit, followed by the flat, hemispherical and the fragment simulating.

[1]  Mark L. Wilkins,et al.  Mechanics of penetration and perforation , 1978 .

[2]  Gao Qing Lu,et al.  On the optimisation of two-component plates against ballistic impact , 1996 .

[3]  Gregory M. Glenn,et al.  Fiber-reinforced composites , 1988 .

[4]  Gabi Ben-Dor,et al.  A model for predicting penetration and perforation of FRP laminates by 3-D impactors , 2002 .

[5]  H. Wen,et al.  Predicting the penetration and perforation of FRP laminates struck normally by projectiles with different nose shapes , 2000 .

[6]  Jonas A. Zukas,et al.  Impact effects in multilayered plates , 2001 .

[7]  Z. Aboura,et al.  Prediction of the elastic behaviour of hybrid and non-hybrid woven composites , 1998 .

[8]  N. K. Naik,et al.  Prediction of on-axes elastic properties of plain weave fabric composites , 1992 .

[9]  Sun-Pui Ng,et al.  Numerical and experimental determination of in-plane elastic properties of 2/2 twill weave fabric composites , 1998 .

[10]  Stephen J. Cimpoeru,et al.  A study of the effect of target thickness on the ballistic perforation of glass-fibre-reinforced plastic composites , 2000 .

[11]  Gabi Ben-Dor,et al.  Optimization of the nose shape of an impactor against a semi-infinite FRP laminate , 2002 .

[12]  J. G. Hetherington,et al.  An investigation into the energy absorbed during ballistic perforation of composite armours , 1991 .

[13]  H. M. Wen,et al.  Penetration and perforation of thick FRP laminates , 2001 .

[14]  C. Sun,et al.  Dynamic penetration of graphite/epoxy laminates impacted by a blunt-ended projectile , 1993 .