The feasibility of downsizing a 1.25 liter normally aspirated engine to a 0.43 liter highly turbocharged engine

In this paper, performance, efficiency and emission experimental results are presented from a prototype 434 cm, highly turbocharged (TC), two cylinder engine with brake power limited to approximately 60 kW. These results are compared to current small engines found in today’s automobile marketplace. A normally aspirated (NA) 1.25 liter, four cylinder, modern production engine with similar brake power output is used for comparison. Results illustrate the potential for downsized engines to significantly reduce fuel consumption while still maintaining engine performance. This has advantages in reducing vehicle running costs together with meeting tighter carbon dioxide (CO2) emission standards. Experimental results highlight the performance potential of smaller engines with intake boosting. This is demonstrated with the test engine achieving 25 bar brake mean effective pressure (BMEP). Results are presented across varying parameter domains, including engine speed, compression ratio (CR), manifold absolute pressure (MAP) and lambda (λ). Engine operating limits are also outlined, with spark knock highlighted as the major limitation in extending the operating limits for this downsized engine.

[1]  David James Scholl,et al.  Air-Fuel Ratio Dependence of Random and Deterministic Cyclic Variability in a Spark-Ignited Engine , 1999 .

[2]  Richard Murphy,et al.  Turbocharging Concepts for Downsized DI Gasoline Engines , 2004 .

[3]  Harry C. Watson,et al.  Compression Ratio Effects on Performance, Efficiency, Emissions and Combustion in a Carbureted and PFI Small Engine , 2007 .

[4]  Edward S. Taylor,et al.  The internal combustion engine , 1961 .

[5]  S. M. Shahed,et al.  Advanced Gasoline Engine Turbocharging Technology for Fuel Economy Improvements , 2004 .

[6]  Richard Stone,et al.  Introduction to Internal Combustion Engines , 1985, Internal Combustion Engines.

[7]  Harry C. Watson,et al.  SI Engine Lean-Limit Extension Through LPG Throttle-Body Injection for Low CO2 and NOx , 2006 .

[8]  Eric W. Schneider,et al.  Effect of Break-In and Operating Conditions on Piston Ring and Cylinder Bore Wear in Spark-Ignition Engines , 2004 .

[9]  U. Spicher,et al.  Knock Behavior of SI-Engines: Thermodynamic Analysis of Knock Onset Locations and Knock Intensities , 2006 .

[10]  Harry C. Watson,et al.  Design and development of a gasketless cylinder head / block interface for an open deck, multi cylinder, highly turbocharged small engine , 2006 .

[11]  Bertrand Lecointe,et al.  Downsizing a Gasoline Engine Using Turbocharging with Direct Injection , 2003 .

[12]  Yoshio Nakamura.  Small High-Speed, High-Performance Gasoline Engine , 1964 .

[13]  Dean Tomazic,et al.  Future Potential and Development Methods for High Output Turbocharged Direct Injected Gasoline Engines , 2006 .

[14]  Alasdair Cairns,et al.  Exhaust Gas Recirculation for Improved Part and Full Load Fuel Economy in a Turbocharged Gasoline Engine , 2006 .

[15]  Markus Schwaderlapp,et al.  Downsizing of Diesel Engines: 3-Cylinder / 4-Cylinder , 2000 .

[16]  Harry C. Watson,et al.  Highly Turbocharging a Restricted, Odd Fire, Two Cylinder Small Engine - Design, Lubrication, Tuning and Control , 2006 .

[17]  Harry C. Watson,et al.  Development of a 430cc Constant Power Engine for FSAE Competition , 2006 .

[18]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[19]  Heinz Heisler,et al.  Advanced Engine Technology , 1985 .

[20]  N. Watson,et al.  Turbocharging the internal combustion engine , 1982 .

[21]  Harry C. Watson,et al.  Comparing the Performance and Limitations of a Downsized Formula SAE Engine in Normally Aspirated , 2006 .

[22]  Harry C. Watson,et al.  Highly Turbocharging a Flow Restricted Two Cylinder Small Engine - Turbocharger Development , 2007 .

[23]  C. F. Taylor,et al.  The internal-combustion engine in theory and practice , 1985 .

[24]  Horst Schulte,et al.  The Technical Ramifications of Downsizing HSDI Diesel Technology to the 300 cc Displacement Class , 1998 .

[25]  Marco Badami,et al.  Influence of Late Intake-Valve Opening on the S.I. Engine-Performance in Idle Condition , 1996 .

[26]  John B. Heywood,et al.  An Investigation of Gasoline Engine Knock Limited Performance and the Effects of Hydrogen Enhancement , 2006 .