Dynamic In-Situ Observation on the Failure Mechanism of Flax Fiber through Scanning Electron Microscopy

In order to develop and improve bio-inspired fibers, it is necessary to have a proper understanding of the fracture behavior of bio-fibers such as flax fibers from an individual fiber down to the constituent micro-fibrils and nano-fibrils. For investigating the failure mechanism of individual and technical flax fibers, a tensile test bench was placed within a scanning electron microscope, and the entire process of fiber failure was investigated through the capture of an SEM movie. Next, fractographic analysis was performed on the failure surface of single fibers as well as meso-fibrils that failed at a displacement rate of 0.25 mm/min, 0.75 mm/min, and 1.6 mm/min. The analysis also enabled visualization of a few internal details of flax fiber such as the arrangement of meso-fibrils and micro-fibrils (nano-fibrils). It was shown that the crack bridging mechanism and successive fiber pull-out contributed to the high work of fracture of flax fiber and the value may reach as high as 10 6 J / m 2 .

[1]  A. Peterlin,et al.  Morphology of Secondary Wall Fibrils in Cotton , 1970 .

[2]  M. Asgharipour,et al.  The effects of growth and storage conditions on dislocations in hemp fibres , 2008, Journal of Materials Science.

[3]  O. Okoli,et al.  Failure modes of fibre reinforced composites: The effects of strain rate and fibre content , 1998 .

[4]  A. Błędzki,et al.  Composites reinforced with cellulose based fibres , 1999 .

[5]  C. Hill,et al.  An investigation into the effects of micro-compressive defects on interphase behaviour in hemp-epoxy composites using half-fringe photoelasticity , 2000 .

[6]  A. Donald,et al.  A small-angle X-ray scattering study of the effect of hydration on the microstructure of flax fibers. , 2001, Biomacromolecules.

[7]  Peter Schwartz,et al.  Effects of Strain Rate and Gauge Length on the Failure of Ultra-High Strength Polyethylene Fibers , 1986 .

[8]  C. Baley.  Influence of kink bands on the tensile strength of flax fibers , 2004 .

[9]  Peter Fratzl,et al.  Biomimetic materials research: what can we really learn from nature's structural materials? , 2007, Journal of The Royal Society Interface.

[10]  L. Gibson.  The hierarchical structure and mechanics of plant materials , 2012, Journal of The Royal Society Interface.

[11]  Norman A. Fleck,et al.  Mechanisms of crack bridging by composite and metallic rods , 2004 .

[12]  P. K. Rastogi,et al.  Micromechanics of wood subjected to axial tension , 1995, Wood Science and Technology.

[13]  Erich Adler,et al.  Lignin chemistry—past, present and future , 1977, Wood Science and Technology.

[14]  N. Carpita,et al.  Structural models of primary cell walls in flowering plants: consistency of molecular structure with the physical properties of the walls during growth. , 1993, The Plant journal : for cell and molecular biology.

[15]  T. Gorshkova,et al.  Development of Cellulosic Secondary Walls in Flax Fibers Requires β-Galactosidase1[C][W][OA] , 2011, Plant Physiology.

[16]  Chad A. Ulven,et al.  Influence of Stem Diameter on Fiber Diameter and the Mechanical Properties of Technical Flax Fibers from Linseed Flax , 2018 .

[17]  Camille Goudenhooft,et al.  Investigation of the Mechanical Properties of Flax Cell Walls during Plant Development: The Relation between Performance and Cell Wall Structure , 2018 .

[18]  L. Clements.  Fractography of unidirectional graphite-epoxy as a function of moisture, temperature and specimen quality , 1986 .

[19]  R. Joffe,et al.  Strength distribution of elementary flax fibres , 2005 .

[21]  A. Donald,et al.  In situ ESEM study of the deformation of elementary flax fibres , 1999 .

[22]  E. Spārniņš,et al.  The effect of mechanical defects on the strength distribution of elementary flax fibres , 2009 .

[23]  M. Clifford,et al.  Why do we observe significant differences between measured and ‘back-calculated’ properties of natural fibres? , 2016, Cellulose.

[24]  P. Fratzl,et al.  Mineralized collagen fibrils: a mechanical model with a staggered arrangement of mineral particles. , 2000, Biophysical journal.

[25]  Huajian Gao,et al.  Materials become insensitive to flaws at nanoscale: Lessons from nature , 2003, Proceedings of the National Academy of Sciences of the United States of America.

[26]  J. Bréard,et al.  Mechanical Properties of Flax Fibers and of the Derived Unidirectional Composites , 2010 .

[27]  T. Baskin.  Anisotropic expansion of the plant cell wall. , 2005, Annual review of cell and developmental biology.

[28]  M. Gomina,et al.  Investigation of the internal structure of flax fibre cell walls by transmission electron microscopy , 2015, Cellulose.

[29]  D. M. Bruce,et al.  Effect of Environmental Relative Humidity and Damage on the Tensile Properties of Flax and Nettle Fibers , 1998 .

[30]  E. Spārniņš,et al.  Strength and Damage of Elementary Flax Fibers Extracted from Tow and Long Line Flax , 2009 .

[31]  C. Riekel,et al.  Direct observation of microfibril arrangement in a single native cellulose fiber by microbeam small-angle X-ray scattering , 1998 .

[32]  Edward A. Bayer,et al.  Shi-You Ding Enzymatic Digestibility ? How Does Plant Cell Wall Nanoscale Architecture Correlate , 2012 .

[33]  K. Charlet,et al.  Direct Insights on Flax Fiber Structure by Focused Ion Beam Microscopy , 2010, Microscopy and Microanalysis.

[34]  S. Huo,et al.  Natural Fiber Reinforced Composites , 2012 .

[35]  Christopher K.Y. Leung,et al.  Effect of fiber inclination on crack bridging stress in brittle fiber reinforced brittle matrix composites , 1992 .

[36]  Himadri S. Gupta,et al.  On the role of interface polymers for the mechanics of natural polymeric composites , 2004 .

[37]  D. Himmelsbach,et al.  Building flax fibres: more than one brick in the walls , 2003 .

[38]  H. Bos,et al.  Tensile and compressive properties of flax fibres for natural fibre reinforced composites , 2002 .

[39]  D J Cosgrove,et al.  Assembly and enlargement of the primary cell wall in plants. , 1997, Annual review of cell and developmental biology.

[40]  J. E. Gordon,et al.  Work of fracture of natural cellulose , 1974, Nature.

[41]  C. Baley.  Analysis of the flax fibres tensile behaviour and analysis of the tensile stiffness increase , 2002 .

[42]  R. A. Tait,et al.  Fracture mechanism of plant fibres , 1980 .

[43]  J. Hearle.  The fine structure of fibers and crystalline polymers. III. Interpretation of the mechanical properties of fibers , 1963 .

[44]  V. Placet,et al.  Relationships between micro-fibrillar angle, mechanical properties and biochemical composition of flax fibers , 2013 .

[45]  P. Davies,et al.  Influence of drying on the mechanical behaviour of flax fibres and their unidirectional composites , 2012 .

[46]  J. Karger‐Kocsis,et al.  Tensile fracture and failure behavior of technical flax fibers , 2003 .

[47]  D. Purslow.  Comment on “Fractography of unidirectional graphite-epoxy as a function of moisture, temperature and specimen quality” , 1989 .

[48]  T. Nilsson,et al.  Influence of dislocations and plasticity on the tensile behaviour of flax and hemp fibres , 2007 .