Energy efficiency trade‐off with phasing of HCCI combustion

SUMMARY Homogeneous charge compression ignition (HCCI) combustion in diesel engines offers the potential of simultaneous low NOx and soot emissions. However, this is normally accompanied by high hydrocarbon (HC) levels in the exhaust and an early combustion phasing before the top-dead-center (TDC) that may drain out substantial amounts of fuel energy from the engine cycle. Exhaust gas recirculation is usually applied to delay the onset of combustion, thereby shifting the phasing of the heat release close to the TDC. Although the retarded phasing improves the engine energy efficiency, a significant increase in HC and carbon monoxide emissions will deteriorate the combustion efficiency. Therefore, an inherent trade-off exists between the combustion phasing and the combustion efficiency that needs to be minimized for improved energy efficiency. In this work, both theoretical and experimental studies have been carried out to evaluate the combustion efficiency-phasing (CEP) trade-off. Engine tests have been conducted to analyze the losses in combustion (burning) and phasing efficiencies, and along with theoretical analyses, the CEP trade-off has been evaluated in terms of a ‘coefficient of combustion inefficiency’ (CCI). The CCI quantitatively correlates the losses in combustion and phasing efficiencies and provides a reference for improving the combustion phasing of the HCCI operation vis-a-vis the combustibles in the exhaust. The focus of this research is to carry out a quantitative analysis of the energy efficiency of HCCI cycles. Copyright © 2011 John Wiley & Sons, Ltd.

[1]  Patrik Soltic,et al.  Experimental investigation on different injection strategies in a heavy-duty diesel engine: Emissions and loss analysis , 2011 .

[2]  Tadashi Iijima,et al.  Full-Load HCCI Operation with Variable Valve Actuation System in a Heavy-Duty Diesel Engine , 2007 .

[3]  Graham T. Reader,et al.  Heat Release Pattern Diagnostics to Improve Diesel Low Temperature Combustion , 2008 .

[4]  Takeshi Miyamoto,et al.  Approaches to Solve Problems of the Premixed Lean Diesel Combustion , 1999 .

[5]  Ming Zheng,et al.  Thermodynamic modelling and experimental investigation of a synthetic atmosphere diesel engine system , 1993 .

[6]  U. Asad,et al.  Efficacy of EGR and Boost in Single-Injection Enabled Low Temperature Combustion , 2009 .

[7]  Francisco José Jiménez-Espadafor Aguilar,et al.  Experimental study of the performances of a modified diesel engine operating in homogeneous charge compression ignition (HCCI) combustion mode versus the original diesel combustion mode , 2009 .

[8]  Meiping Wang,et al.  Thermal Efficiency Analyses of Diesel Low Temperature Combustion Cycles , 2007 .

[9]  Paul C. Miles,et al.  The Influence of Charge Dilution and Injection Timing on Low-Temperature Diesel Combustion and Emissions , 2005 .

[10]  Rolf D. Reitz,et al.  Effects of Engine Operating Parameters on near Stoichiometric Diesel Combustion Characteristics , 2007 .

[11]  S. M. Aithal,et al.  Impact of EGR fraction on diesel engine performance considering heat loss and temperature‐dependent properties of the working fluid , 2009 .

[12]  Graham T. Reader,et al.  Energy efficiency improvement strategies for a diesel engine in low‐temperature combustion , 2009 .

[13]  Usman Asad,et al.  Fast heat release characterization of a diesel engine , 2008 .

[14]  Xiaoye Han,et al.  Fuel Injection Strategies to Improve Emissions and Efficiency of High Compression Ratio Diesel Engines , 2008 .

[16]  Xavier Tauzia,et al.  Influence of high rates of supplemental cooled EGR on NOx and PM emissions of an automotive HSDI diesel engine using an LP EGR loop , 2008 .

[17]  William M. Silvis,et al.  An Algorithm for Calculating the Air/Fuel Ratio from Exhaust Emissions , 1997 .

[18]  Usman Asad,et al.  Efficiency & Stability Improvements of Diesel Low Temperature Combustion through Tightened Intake Oxygen Control , 2010 .

[19]  J. Brettschneider Extension of the Equation for Calculation of the Air-Fuel Equivalence Ratio , 1997 .

[20]  Rowland S. Benson Chapter 1 – Description of Internal Combustion Engines , 1979 .

[21]  U. Asad Advanced Diagnostics, Control and Testing of Diesel Low Temperature Combustion , 2009 .

[22]  J. G. Hawley,et al.  Diesel engine exhaust gas recirculation--a review on advanced and novel concepts , 2004 .