Design and Testing of Three Earthing Systems for Micro-Grid Protection during the Islanding Mode

This paper presents and tests three earthing systems (TT, TN and IT) for Micro-Grid (MG) protection against various fault types when the MG transferred to the islanding mode. The main contribution of this work is including the models of all micro sources which interfaced to the MG by power electronic inverters. Inverters in turns are provided with current limiters and this also included with the inverter models to exactly simulate the real situation in the MG during fault times. Results proved that the most suitable earthing system for MG protection during the islanding mode is the TN earthing system. That system leads to a suitable amount of fault current sufficient to activate over current pro-tection relays. With using TN earthing system, touch voltages at the faulted bus and all other consumer’s buses are less than the safety limited values during islanding mode. For the two others earthing systems (TT and IT), fault currents are small and nearly equal to the over load currents which make over current protection relay can not differentiate between fault currents and overload currents. All models of micro sources, earthing systems, inverters and control schemes are built using Matlab?/Simulink? environment.

[1]  M Kamel Rashad,et al.  Effect of Micro Sources Failure on Dynamic Performance of the Micro- Grid During and Subsequent to Islanding Process , 2010 .

[2]  Christophe Prévé.  Protection of Electrical Networks: Prévé/Protection , 2006 .

[3]  Rashad M. Kamel,et al.  Micro-grid transient dynamic response enhancement during and subsequent to huge and multiple disturbances by connecting it with nearby micro-grids , 2011 .

[4]  Rashad M. Kamel,et al.  Micro-grid Dynamic Response Enhancement Using New Proportional Integral Wind Turbine Pitch Controller and Neuro-fuzzy Photovoltaic Maximum Power Point Tracking Controller , 2009 .

[5]  Rashad M. Kamel,et al.  Carbon Emissions Reduction and Power Losses Saving besides Voltage Profiles Improvement Using Micro Grids , 2010 .

[6]  Rashad M. Kamel,et al.  A NOVEL PI PITCH CONTROLLER AND ENERGY CAPACITOR SYSTEM FOR REDUCING WIND POWER FLUCTUATIONS AND KEEPING MICRO-GRID STABLE SUBSEQUENT ISLANDING OCCURRENCE , 2010 .

[7]  Rashad M. Kamel,et al.  Effect of Wind Generation System Rating on Transient Dynamic Performance of the Micro-Grid during Islanding Mode , 2010 .

[8]  Kai Strunz,et al.  A BENCHMARK LOW VOLTAGE MICROGRID NETWORK , 2005 .

[9]  B Kermanshahi,et al.  Optimal Size and Location of Distributed Generations for Minimizing Power Losses in a Primary Distribution Network , 2009 .

[10]  B Kermanshahi,et al.  DESIGN AND IMPLEMENTATION OF MODELS FOR ANALYZING THE DYNAMIC PERFORMANCE OF DISTRIBUTED GENERATORS IN THE MICRO GRID PART I: MICRO TURBINE AND SOLID OXIDE FUEL CELL , 2010 .

[11]  Massimo Ceraolo,et al.  Control techniques of Dispersed Generators to improve the continuity of electricity supply , 2002, 2002 IEEE Power Engineering Society Winter Meeting. Conference Proceedings (Cat. No.02CH37309).

[12]  S. R. Wall,et al.  Performance of inverter interfaced distributed generation , 2001, 2001 IEEE/PES Transmission and Distribution Conference and Exposition. Developing New Perspectives (Cat. No.01CH37294).

[13]  Rashad M. Kamel,et al.  Wind power smoothing using fuzzy logic pitch controller and energy capacitor system for improvement Micro-Grid performance in islanding mode , 2010 .