Estimating Latent Heat Flux from a Vineyard using Scintillometry

The combination of a near-infrared and a microwave scintillometer were used to estimate the line-averaged, latent heat flux density (λEs) from a well-irrigated, vineyard valley during summer. The 2 km scintillometer beam passed over the valley floor at a height (z) of 30 m. Eddy covariance towers instrumented at 3 ill above the valley surface provided an independent check of vineyard evaporation. A formula for free convective λEe compared favourably to the eddy covariance values, λEe at low wind speeds and under clear skies. As the convective boundary layer (CBL) developed and passed through the scintillometer beam it caused additional scintilla- tions, in which case λEe >> λEe. During unstable conditions the comparisons were in close agreement. However λEs tended to overestimate λEe as the wind speed increased. For near-neutral conditions the scintillometer gave unrealistically large values of λE s. The additional scintillations originated from the strong entrainment of advected dry and warm air into the newly formed surface boundary layer. During calm overcast days, cold days and during the early morning periods when the surface fluxes were small, the signal strength of the infrared scintillometer approached the system noise.

[1]  A. E. Green,et al.  Path-averaged surface fluxes determined from infrared and microwave scintillometers , 2001 .

[2]  R. A. Bohlander,et al.  Turbulence-induced millimeter-wave scintillation compared with micrometeorological measurements , 1988 .

[3]  H. Panofsky,et al.  Atmospheric Turbulence: Models and Methods for Engineering Applications , 1984 .

[4]  B. Hurk,et al.  The scintillation method tested over a dry vineyard area , 1995 .

[5]  R. Stull An Introduction to Boundary Layer Meteorology , 1988 .

[6]  R. S. Lawrence,et al.  Refractive-index and absorption fluctuations in the infrared caused by temperature, humidity, and pressure fluctuations , 1980 .

[7]  M. Herben,et al.  Evaporation derived from optical and radio-wave scintillation. , 1983, Applied optics.

[8]  B. Hurk,et al.  A verification of some methods to determine the fluxes of momentum, sensible heat, and water vapour using standard deviation and structure parameter of scalar meteorological quantities , 1993 .

[9]  W. Kohsiek,et al.  Measuring CT2, CQ2, and CTQ in the unstable surface layer, and relations to the vertical fluxes of heat and moisture , 1982 .

[10]  Reginald J. Hill,et al.  Implications of Monin–Obukhov Similarity Theory for Scalar Quantities , 1989 .

[11]  G. R. Ochs,et al.  A saturation-resistant optical scintillometer to measure Cn2† , 1978 .

[12]  L.J.M. Kroon,et al.  Fluxes in the Surface Layer Under Advective Conditions , 1991 .

[13]  K. J. Sene,et al.  Parameterisations for energy transfers from a sparse vine crop , 1994 .

[14]  P. Mason Atmospheric boundary layer flows: Their structure and measurement , 1995 .

[15]  W. Kohsiek A comparison between line-averaged observation of Cn2 from scintillation of a CO2 laser beam and time-averaged in situ observations , 1985 .

[16]  G. R. Ochs,et al.  Measuring surface-layer fluxes of heat and momentum using optical scintillation , 1992 .