On the use of non-conformal grids for economic LES of wind flow and convective heat transfer for a wall-mounted cube

Generating economical, high-resolution and high-quality computational grids for Large Eddy Simulation (LES) of wind flow and convective heat transfer (CHT) around surface-mounted obstacles is not straightforward. When the grid size is used as filter, LES grids should ideally consist of cubic cells, while CHT requires a very high near-wall resolution to resolve the thin viscous sublayer and buffer layer that represent the largest resistance to CHT. To avoid very high cell numbers and the need for excessive computational resources, non-conformal grids can be considered. This paper provides a detailed evaluation of the performance of non-conformal grids with cubic cells, for wind flow and CHT around a wall-mounted cubic obstacle. LES results on non-conformal versus conformal grids are compared with each other and with wind-tunnel measurements of wind speed and surface temperature. Moreover, sensitivity analysis is performed concerning the impact of overall grid resolution, subdomain size and grid refinement ratio. Average absolute deviations between LES on non-conformal versus conformal grids are about 0.9% (0.5 °C) for surface temperature on all cube surfaces. Comparison with experiments shows for the non-conformal grid an average and maximum absolute deviation for surface temperature of 2.0% (1.1 °C) and 7.6% (3.6 °C), respectively. The sensitivity analysis shows minor impact of subdomain size on convective heat transfer coefficients (CHTC) where, on average, absolute deviations of less than 2.2% are observed. This study shows that non-conformal grids can strongly reduce the total cell count (here by a factor up to 30.2) without significantly compromising the accuracy of results.

[1]  Theodore Stathopoulos,et al.  Computational wind engineering: Past achievements and future challenges , 1997 .

[2]  J. McWilliams,et al.  A grid nesting method for large-eddy simulation of planetary boundary-layer flows , 1996 .

[3]  Luís Eça,et al.  A procedure for the estimation of the numerical uncertainty of CFD calculations based on grid refinement studies , 2014, J. Comput. Phys..

[4]  P. Wesseling,et al.  Local Grid Refinement in Large-Eddy Simulation , 1997 .

[5]  Theodore Stathopoulos,et al.  Application of computational fluid dynamics in building performance simulation for the outdoor environment: an overview , 2011 .

[6]  Miss A.O. Penney.  (b) , 1974, The New Yale Book of Quotations.

[7]  M. Mcpherson,et al.  Introduction to fluid mechanics , 1997 .

[8]  Jörg Franke,et al.  The COST 732 Best Practice Guideline for CFD simulation of flows in the urban environment: a summary , 2011 .

[9]  J. Srebric,et al.  Numerical simulation of convective heat transfer coefficients at the external surfaces of building arrays immersed in a turbulent boundary layer , 2013 .

[10]  J. B. Perot,et al.  An analysis of the fractional step method , 1993 .

[11]  Hugh W. Coleman,et al.  Comprehensive Approach to Verification and Validation of CFD Simulations—Part 2: Application for Rans Simulation of a Cargo/Container Ship , 2001 .

[12]  Patrick J. Roache,et al.  Verification and Validation in Computational Science and Engineering , 1998 .

[13]  Bje Bert Blocken,et al.  Review of external convective heat transfer coefficient models in building energy simulation programs: implementation and uncertainty , 2013 .

[14]  T. Stathopoulos,et al.  CFD simulation of the atmospheric boundary layer: wall function problems , 2007 .

[15]  U. Ghia,et al.  Procedure for Estimation and Reporting of Uncertainty Due to Discretization in CFD Applications , 2007 .

[16]  M. Wolfshtein.  The velocity and temperature distribution in one-dimensional flow with turbulence augmentation and pressure gradient , 1969 .

[17]  W. Rodi.  Comparison of LES and RANS calculations of the flow around bluff bodies , 1997 .

[18]  J. Dukowicz,et al.  Approximate factorization as a high order splitting for the implicit incompressible flow equations , 1992 .

[19]  S. Armfield,et al.  The Fractional-Step Method for the Navier-Stokes Equations on Staggered Grids , 1999 .

[20]  S. Murakami,et al.  Comparison of various revised k–ε models and LES applied to flow around a high-rise building model with 1:1:2 shape placed within the surface boundary layer , 2008 .

[21]  Bert Blocken,et al.  50 years of Computational Wind Engineering: Past, present and future , 2014 .

[22]  Timothy G. Trucano,et al.  Verification and Validation in Computational Fluid Dynamics , 2002 .

[23]  M. Popovac.  Modelling and simulation of turbulence and heat transfer in wall-bounded flows , 2006 .

[24]  P. Colella,et al.  A second-order projection method for the incompressible navier-stokes equations , 1989 .

[25]  A. D. Young,et al.  An Introduction to Fluid Mechanics , 1968 .

[26]  E. Meinders.  Experimental study of heat transfer in turbulent flows over wall-mounted cubes. , 1998 .

[27]  I. Celik,et al.  Random Flow Generation Technique for Large Eddy Simulations and Particle-Dynamics Modeling , 2001 .

[28]  Ismail Celik,et al.  Index of resolution quality for large eddy simulations , 2005 .

[29]  Yoshihide Tominaga,et al.  AIJ guidelines for practical applications of CFD to pedestrian wind environment around buildings , 2008 .

[30]  J. Smagorinsky,et al.  GENERAL CIRCULATION EXPERIMENTS WITH THE PRIMITIVE EQUATIONS , 1963 .

[31]  J. Palyvos.  A survey of wind convection coefficient correlations for building envelope energy systems’ modeling , 2008 .

[32]  Bje Bert Blocken,et al.  Computational Fluid Dynamics for urban physics: Importance, scales, possibilities, limitations and ten tips and tricks towards accurate and reliable simulations , 2015 .

[33]  P. Moin,et al.  Application of a Fractional-Step Method to Incompressible Navier-Stokes Equations , 1984 .

[34]  U. Piomelli,et al.  Effect of discontinuous filter width in large-eddy simulations of plane channel flow , .

[35]  S. Murakami,et al.  COMPARISON OF VARIOUS TURBULENCE MODELS APPLIED TO A BLUFF BODY , 1993 .

[36]  R. Martinuzzi,et al.  Experimental Study of the Local Convection Heat Transfer From a Wall-Mounted Cube in Turbulent Channel Flow , 1999 .

[37]  D. Grawe,et al.  BEST PRACTICE GUIDELINE FOR THE CFD SIMULATION OF FLOWS IN THE URBAN ENVIRONMENT , 2007 .

[38]  Sinisa Krajnovic,et al.  Large-Eddy Simulation of the Flow Around a Bluff Body , 2002 .

[39]  Dominique Derome,et al.  CFD analysis of forced convective heat transfer coefficients at windward building facades: influence of building geometry , 2015 .

[40]  C. Baker.  Wind engineering—Past, present and future , 2007 .

[41]  Bje Bert Blocken,et al.  Quality assessment of Large-Eddy Simulation of wind flow around a high-rise building : validation and solution verification , 2013 .

[42]  Joel H. Ferziger,et al.  A fluid mechanicians view of wind engineering: Large eddy simulation of flow past a cubic obstacle , 1997 .

[43]  Hugh W. Coleman,et al.  Comprehensive Approach to Verification and Validation of CFD Simulations—Part 1: Methodology and Procedures , 2001 .

[44]  T. Shih,et al.  A new k-ϵ eddy viscosity model for high reynolds number turbulent flows , 1995 .

[45]  Dominique Derome,et al.  High-resolution CFD simulations for forced convective heat transfer coefficients at the facade of a low-rise building , 2009 .

[46]  Jan Carmeliet,et al.  CFD analysis of convective heat transfer at the surfaces of a cube immersed in a turbulent boundary layer , 2010 .

[47]  U. Piomelli,et al.  Effect of grid discontinuities on large-eddy simulation statistics and flow fields , 2008 .