A comprehensive understanding of enhanced condensation heat transfer using phase separation concept

[1]  S. Suresh,et al.  Investigating the combined effect of square microgrooves and CNT coating on condensation heat transfer , 2019, Applied Surface Science.

[2]  Jinliang Xu,et al.  Switchable heat transfer in nano Janus-interface-system , 2018, International Journal of Heat and Mass Transfer.

[3]  K. Leong,et al.  Condensation heat transfer and pressure drop characteristics of R-134a in horizontal smooth tubes and enhanced tubes fabricated by selective laser melting , 2018, International Journal of Heat and Mass Transfer.

[4]  Jinliang Xu,et al.  R245fa condensation heat transfer in a phase separation condenser , 2018, Experimental Thermal and Fluid Science.

[5]  Jinliang Xu,et al.  Microscale phase separation condensers with varied cross sections of each fluid phase: Heat transfer enhancement and pressure drop reduction , 2018 .

[6]  A. K. Khatua,et al.  Measurement of enhanced heat transfer coefficient with perforated twisted tape inserts during condensation of R-245fa , 2016 .

[7]  Jinliang Xu,et al.  Transcritical pressure Organic Rankine Cycle (ORC) analysis based on the integrated-average temperature difference in evaporators , 2015 .

[8]  Jinliang Xu,et al.  Condensation heat transfer of R245fa in tubes with and without lyophilic porous-membrane-tube insert , 2015 .

[9]  Jinliang Xu,et al.  Froude number dominates condensation heat transfer of R245fa in tubes: Effect of inclination angles , 2015 .

[10]  Jinliang Xu,et al.  The phase separation concept condensation heat transfer in horizontal tubes for low-grade energy utilization , 2014 .

[11]  Chi-Chuan Wang,et al.  Dynamic Response of a 50 kW Organic Rankine Cycle System in Association with Evaporators , 2014 .

[12]  Zhen Wang,et al.  Performance analysis of waste heat recovery with a dual loop organic Rankine cycle (ORC) system for diesel engine under various operating conditions , 2014 .

[13]  Jinliang Xu,et al.  Numerical simulation of the modulated flow pattern for vertical upflows by the phase separation concept , 2013 .

[14]  Weiqi Wang,et al.  Flow pattern modulation in a horizontal tube by the passive phase separation concept , 2012 .

[15]  Li Zhang,et al.  Experimental study on condensation heat transfer characteristics of steam on horizontal twisted elliptical tubes , 2012 .

[16]  Wei Liu,et al.  Numerical studies on heat transfer and flow characteristics for laminar flow in a tube with multiple regularly spaced twisted tapes , 2012 .

[17]  George Papadakis,et al.  Low­grade heat conversion into power using organic Rankine cycles - A review of various applications , 2011 .

[18]  S. Quoilin,et al.  Performance and design optimization of a low-cost solar organic Rankine cycle for remote power generation , 2011 .

[19]  Vahid Hejazi,et al.  Experimental investigation of twisted tape inserts performance on condensation heat transfer enhancement and pressure drop , 2010 .

[20]  D. Brüggemann,et al.  Exergy based fluid selection for a geothermal Organic Rankine Cycle for combined heat and power generation , 2010 .

[21]  Somchai Wongwises,et al.  The effects of corrugation pitch on the condensation heat transfer coefficient and pressure drop of R-134a inside horizontal corrugated tube , 2010 .

[22]  S. Thoroddsen,et al.  Satellite Formation during Coalescence of Unequal Size Drops. , 2009, Physical review letters.

[23]  Jian-Fei Zhang,et al.  A performance evaluation plot of enhanced heat transfer techniques oriented for energy-saving , 2009 .

[24]  M. Akhavan-Behabadi,et al.  Augmentation of heat transfer by twisted tape inserts during condensation of R-134a inside a horizontal tube , 2008 .

[25]  K. S. Lee,et al.  Experimental study on condensation heat transfer enhancement and pressure drop penalty factors in four microfin tubes , 2005 .

[26]  Anupam Dewan,et al.  Review of passive heat transfer augmentation techniques , 2004 .

[27]  J. Thome,et al.  Condensation in Horizontal Tubes, Part 1: Two-Phase Flow Pattern Map , 2003 .

[28]  T. Newell,et al.  Heat transfer and pressure drop during condensation of refrigerant 134a in an axially grooved tube , 1999 .

[29]  J. Chato,et al.  Condensation in Smooth Horizontal Tubes , 1998 .

[30]  J. Taborek,et al.  Prediction of Horizontal Tubeside Condensation of Pure Components Using Flow Regime Criteria , 1980 .

[31]  M. Shah.  A general correlation for heat transfer during film condensation inside pipes , 1979 .

[32]  D. Chisholm,et al.  Pressure gradients due to friction during the flow of evaporating two-phase mixtures in smooth tubes and channels , 1973 .

[33]  S. L. Smith.  Void Fractions in Two-Phase Flow: A Correlation Based upon an Equal Velocity Head Model , 1969 .

[34]  Zhen-qian Chen,et al.  Experimental investigation on flow condensation in horizontal tubes filled with annular metal foam , 2018 .

[35]  Xiao-dong Wang,et al.  Numerical simulation of modulated heat transfer tube in laminar flow regime , 2014 .

[36]  Rao,et al.  Flow Loss in Screens: A Fresh Look at Old Correlation , 2013 .

[37]  S. A. Anderson,et al.  On-site chiller testing , 1990 .

[38]  J. Thome,et al.  Convective Boiling and Condensation , 1972 .

[39]  J. P. Holman,et al.  Experimental methods for engineers , 1971 .