Axial-flow microturbine with electromagnetic generator: design, CFD simulation, and prototype demonstration

We have developed a MEMS power conversion device that combines an axial-flow turbine with an axial-flux electromagnetic generator. This device can generate electrical power when placed in an air-stream, and is aimed at applications such as flow sensing and power generation for remote sensors. Recent experimental performance data are presented for prototypes, and compared with CFD (computational fluid dynamics) simulations. The current devices have a volume of approximately 0.5 cm/sup 3/, generate 1 mW of output power at a pressure drop of 8 mbar and a flow rate of 35 litres per minute, and will operate at pressure drops down to a few mbar.

[1]  T. G. Wiegele.  Micro-turbo-generator design and fabrication: a preliminary study , 1996, IECEC 96. Proceedings of the 31st Intersociety Energy Conversion Engineering Conference.

[2]  J.-L. Schanen,et al.  Design of a permanent magnet planar synchronous micromotor , 2000, Conference Record of the 2000 IEEE Industry Applications Conference. Thirty-Fifth IAS Annual Meeting and World Conference on Industrial Applications of Electrical Energy (Cat. No.00CH37129).

[3]  Anantha Chandrakasan,et al.  Vibration-to-electric energy conversion , 2001, IEEE Trans. Very Large Scale Integr. Syst..

[4]  F. Profumo,et al.  A comparison between the axial flux and the radial flux structures for PM synchronous motors , 2001, Conference Record of the 2001 IEEE Industry Applications Conference. 36th IAS Annual Meeting (Cat. No.01CH37248).

[5]  R. B. Yates,et al.  Development of an electromagnetic micro-generator , 2001 .

[6]  K.P. Pullen,et al.  Design, fabrication and characterization of an axial-flow turbine for flow sensing , 2003, TRANSDUCERS '03. 12th International Conference on Solid-State Sensors, Actuators and Microsystems. Digest of Technical Papers (Cat. No.03TH8664).

[7]  Alan H. Epstein,et al.  Millimeter-Scale, MEMS Gas Turbine Engines , 2003 .

[8]  Andrew S. Holmes,et al.  Laser profiling of 3D microturbine blades , 2003, International Symposium on Laser Precision Microfabrication.

[9]  P. Miao,et al.  Analysis and Optimisation of MEMS Electrostatic On-Chip Power Supply for Self-Powering of Slow-Moving Sensors , 2003 .

[10]  Phil T. Rumsby,et al.  Laser Profiling of 3-D Microturbine Blades , 2004 .