Multiwalled carbon nanotube film for strain sensing

We have studied the possibility of using multiwalled carbon nanotube (MWCNT) films as strain sensors. The MWCNT films were prepared by a solution/filtration method and were bonded directly onto specimens by a nonconductive adhesive. For comparison, conventional foil strain gages were also bonded to the structure on the opposite side. The specimens then underwent a uniaxial tensile load-unload cycle to evaluate them as strain sensors. To ensure good electrical contact between carbon nanotube film and the wires, a thin layer of copper was thermally deposited on both ends of the film as electrodes, and the wires were connected to the electrodes by silver ink. Wheatstone bridges were used to convert the resistance changes of the MWCNTs to voltage output. Results indicated that the output voltages were proportional to the strain readings from the stain indicator. The effect of temperature on the resistance was measured and the MWCNT film resistance was found to be independent of temperature over the range 273-363 K. The optimal film dimension for strain sensing was evaluated as well. Dynamic tests suggest that the MWCNTs were able to extract the structural signature. Our results indicate that MWCNT film is potentially useful for structural health monitoring and vibration control applications.

[1]  Nader Jalili,et al.  Reinforcement of Piezoelectric Polymers with Carbon Nanotubes: Pathway to Next-generation Sensors , 2006 .

[2]  N. Kotov,et al.  Multifunctional layer-by-layer carbon nanotube–polyelectrolyte thin films for strain and corrosion sensing , 2007 .

[3]  Meijie Tang,et al.  Reversible electromechanical characteristics of carbon nanotubes underlocal-probe manipulation , 2000, Nature.

[4]  Markus Brink,et al.  Tuning carbon nanotube band gaps with strain. , 2003, Physical review letters.

[5]  Peter Bøggild,et al.  Direct measurement of resistance of multiwalled carbon nanotubes using micro four-point probes , 2005 .

[6]  Gehan A. J. Amaratunga,et al.  Reversible electromechanical characteristics of individual multiwall carbon nanotubes , 2005 .

[7]  M. Knite,et al.  Polyisoprene-carbon nano-composites for application in multifunctional sensors , 2007 .

[8]  P. Ajayan,et al.  Reliability and current carrying capacity of carbon nanotubes , 2001 .

[9]  S. Iijima.  Helical microtubules of graphitic carbon , 1991, Nature.

[10]  Satish Nagarajaiah,et al.  Nanotube film based on single-wall carbon nanotubes for strain sensing , 2004 .

[11]  D. Mendoza.  Electrical properties of carbon nanofibers synthesized using carbon disulfide as precursor , 2006 .

[12]  H. Wagner,et al.  Direction-sensitive strain-mapping with carbon nanotube sensors , 2002 .

[13]  Mark J. Schulz,et al.  A carbon nanotube strain sensor for structural health monitoring , 2006 .

[14]  R. Yadav,et al.  Synthesis of bamboo-shaped carbon-nitrogen nanotubes using acetonitrile-ferrocene precursor. , 2004, Journal of nanoscience and nanotechnology.

[15]  Young-Woo Son,et al.  Electrical switching in metallic carbon nanotubes. , 2005, Physical review letters.