Force measurements during vibration testing

Experimental measurements of force into a ``rigid`` test item representing a typical system level vibration test were conducted to evaluate several methods of force measurements. The methods evaluated included: (1) Direct measurement with force gages between the test item and the fixturing; (2) Measurement of the force at the shaker/fixture interface and correcting the force required to drive the fixturing using two methods, (a) mass subtraction and (b) SWAT (sum of weighted accelerations technique), (3) Force deduced from voltage and current needed to drive the test item. All of the methods worked over a limited frequency range of five to a few hundred Hertz. The widest bandwidth was achieved with force at the shaker/fixture interface with SWAT corrections and from the voltage and current measurements.