Fibre Reinforcement for Shrinkage Crack Control in Prestressed, Precast Segmental Bridges

In prestressed precast segmental concrete bridges, conventional longitudinal reinforcement serves only as shrinkage crack controllers. The presence of this reinforcement, however, has restricted the ability to reduce the cross-section of the segments when high strength concrete is used because of the minimum dimensions required to accomodate the reinforcement. Research on fibre reinforced concrete (FRC) indicated that the addition of steel fibres to concrete significantly improved the tensile behaviour and the crack control characteristics of the concrete. This research investigates the feasibility of fibres to replace the conventional shrinkage reinforcement, allowing for the design of thinner and lighter structures with comparable or better crack control characteristics. Extensive work was conducted to investigate the effectiveness of hooked-end steel fibres to control cracks. Seven types of material tests were performed: uniaxial tension test, cylinder compression test, modulus of rupture test, splitting test, free and autogenous shrinkage test, and restrained shrinkage test. In addition, ten 890×890×70 mm concrete panels were tested under in-plane pure-shear loading using the Panel Element Tester. The parameters of study were the fibre volume content (0.5%, 1.0%, and 1.5%), the concrete compressive strength (50 and 80 MPa), and the fibre geometry and tensile strength. In addition to the experimental study, a model was developed to investigate the behaviour of a 1D restrained FRC member subjected to shrinkage.

[1]  Gordon B. Batson,et al.  Steel fiber reinforced concrete , 1976 .

[2]  E. Tazawa,et al.  Experimental study on mechanism of autogenous shrinkage of concrete , 1995 .

[3]  D. Mitchell,et al.  Prestressed concrete structures , 1991 .

[4]  F. Vecchio.  The Response of Reinforced Concrete to In-Plane Shear and Normal Stresses , 1982 .

[5]  Surendra P. Shah,et al.  MODEL TO PREDICT CRACKING IN FIBRE REINFORCED CONCRETE DUE TO RESTRAINED SHRINKAGE , 1989 .

[6]  D. Mitchell,et al.  Prestressed Concrete Basics , 1994 .

[7]  E. Bentz.  Sectional analysis of reinforced concrete members , 2000 .

[8]  Hideo Koide,et al.  A practical method for uniaxial tension test of concrete , 2003 .

[9]  P. Rossi.  Ultra-High Performance Fiber-Reinforced Concretes , 2001 .

[10]  Eivind Hognestad,et al.  A STUDY OF COMBINED BENDING AND AXIAL LOAD IN REINFORCED CONCRETE MEMBERS; A REPORT OF AN INVESTIGATION CONDUCTED BY THE ENGINEERING EXPERIMENT STATION, UNIVERSITY OF ILLINOIS, UNDER AUSPICES OF THE ENGINEERING FOUNDATION, THROUGH THE REINFORCED CONCRETE RESEARCH COUNCIL. , 1951 .

[11]  Chanakya Arya,et al.  Eurocodes 2: Design of concrete structures , 2009 .

[12]  Antoine E. Naaman,et al.  SELF-CONSOLIDATING HIGH PERFORMANCE FIBER REINFORCED CONCRETE : SCHPFRC , 2006 .

[13]  J. J. Brooks,et al.  Creep and Shrinkage of Concrete as Affected by Admixtures and Cement replacement materials , 1992, SP-135: Creep and Shrinkage of Concrete: Effect of Materials and Environment.

[14]  W. F. Price,et al.  The Petronas towers, Kuala Lumpur: Beneficial use of high strength concrete , 1997 .

[15]  Stephen J. Foster,et al.  FE Analysis of Steel Fiber Reinforced Concrete Beams Failing in Shear: Variable Engagement Model , 2006 .

[16]  Michael P. Collins,et al.  Effect of Concrete Strength and Minimum Stirrups on Shear Strength of Large Members , 2001 .

[17]  Bhushan Lal Karihaloo,et al.  CARDIFRC - Development and mechanical properties. Part I: Development and workability , 2005 .

[18]  Y Malier,et al.  THE BRIDGE OF JOIGNY , 1991 .

[19]  Farhad Ansari,et al.  HIGH-STRENGTH CONCRETE IN UNIAXIAL TENSION , 2000 .

[20]  Patrik Groth.  Cracking in concrete : crack prevention with air-cooling and crack distribution with steel fibre reinforcement , 1996 .

[21]  J. P. Romualdi,et al.  Tensile Strength of Concrete Affected by Uniformly Distributed and Closely Spaced Short Lengths of Wire Reinforcement , 1964 .

[22]  S. Foster,et al.  Variable Engagement Model for the Design of Fibre Reinforced Concrete Structures , 2003 .

[23]  Elmo C. Higginson,et al.  Effect of Steam Curing on the Important Properties of Concrete , 1961 .

[24]  R. Gettu.  Direct tension test and interpretation , 2003 .

[25]  B. Vijaya Rangan,et al.  Fiber Reinforced Concrete Properties , 1971 .

[26]  J. J. Shideler,et al.  Early Strength of Concrete as Affected by Steam Curing Temperatures , 1949 .

[27]  Konstantin Kovler,et al.  Testing system for determining the mechanical behaviour of early age concrete under restrained and free uniaxial shrinkage , 1994 .

[28]  L. Hsu,et al.  Stress-strain behavior of steel-fiber high-strength concrete under compression , 1994 .

[29]  Ananth Ramaswamy,et al.  Mechanical Properties of Steel Fiber-Reinforced Concrete , 2007 .

[30]  T. H. Wee,et al.  STRESS-STRAIN RELATIONSHIP OF HIGH-STRENGTH FIBER CONCRETE IN COMPRESSION , 1999 .

[31]  V. Li,et al.  An experimental study of synthetic fibre reinforced cementitious composites , 1987 .

[32]  James K. Wight,et al.  Flexural Toughness of Steel Fiber Reinforced Concrete@@@متانة الخرسانة المسلحة بالألياف المعدنية , 1994 .

[33]  Matthew A. Miltenberger,et al.  SHRINKAGE CRACKING CHARACTERISTICS OF CONCRETE USING RING SPECIMENS , 2003 .

[34]  Frank J. Vecchio,et al.  Crack shear-slip in reinforced concrete elements , 2004 .