Variable optical attenuator and dynamic mode group equalizer for few mode fibers.

Variable optical attenuation (VOA) for three-mode fiber is experimentally presented, utilizing an amplitude spatial light modulator (SLM), achieving up to -28dB uniform attenuation for all modes. Using the ability to spatially vary the attenuation distribution with the SLM, we also achieve up to 10dB differential attenuation between the fiber's two supported mode group (LP₀₁ and LP₁₁). The spatially selective attenuation serves as the basis of a dynamic mode-group equalizer (DME), potentially gain-balancing mode dependent optical amplification. We extend the experimental three mode DME functionality with a performance analysis of a fiber supporting 6 spatial modes in four mode groups. The spatial modes' distribution and overlap limit the available dynamic range and performance of the DME in the higher mode count case.

[1]  J. M. O. Daniel,et al.  Spatial mode switchable, wavelength tunable erbium doped fiber laser incorporating a spatial light modulator , 2014, OFC 2014.

[2]  A. Gnauck,et al.  Mode-multiplexed 6×20-GBd QPSK transmission over 1200-km DGD-compensated few-mode fiber , 2012, OFC/NFOEC.

[3]  A. Gnauck,et al.  32-bit/s/Hz spectral efficiency WDM transmission over 177-km few-mode fiber , 2013, 2013 Optical Fiber Communication Conference and Exposition and the National Fiber Optic Engineers Conference (OFC/NFOEC).

[4]  Gang-Ding Peng,et al.  Mode-division multiplexed transmission with inline few-mode fiber amplifier. , 2012, Optics express.

[5]  Laurent Bigot,et al.  Modeling and characterization of a few-mode EDFA supporting four mode groups for mode division multiplexing. , 2012, Optics express.

[6]  Francesco Poletti,et al.  Accurate modal gain control in a multimode erbium doped fiber amplifier incorporating ring doping and a simple LP₀₁ pump configuration. , 2012, Optics express.

[7]  H. Bulow,et al.  Optical-Mode Demultiplexing by Optical MIMO Filtering of Spatial Samples , 2012, IEEE Photonics Technology Letters.

[8]  D. M. Marom,et al.  Optimization of Spatial Aperture-Sampled Mode Multiplexer for a Three-Mode Fiber , 2012, IEEE Photonics Technology Letters.

[9]  Roland Ryf,et al.  Geometric requirements for photonic lanterns in space division multiplexing. , 2012, Optics express.

[10]  J. R. Salazar-Gil,et al.  Mode-selective photonic lanterns for space-division multiplexing. , 2014, Optics express.

[11]  L Grüner-Nielsen,et al.  First demonstration and detailed characterization of a multimode amplifier for Space Division Multiplexed transmission systems. , 2011, Optics express.

[12]  H. Fujita,et al.  A 5-V operated MEMS variable optical attenuator by SOI bulk micromachining , 2004, IEEE Journal of Selected Topics in Quantum Electronics.

[13]  M Kuschnerov,et al.  Three mode Er3+ ring-doped fiber amplifier for mode-division multiplexed transmission. , 2013, Optics express.

[14]  Nicolas K. Fontaine.  Characterization of space-division multiplexing fibers using swept-wavelength interferometry , 2015, 2015 Optical Fiber Communications Conference and Exhibition (OFC).

[15]  B. Guan,et al.  A Six-Mode Erbium-Doped Fiber Amplifier , 2012 .

[16]  S. Randel,et al.  Low-loss mode coupler for mode-multiplexed transmission in few-mode fiber , 2012, OFC/NFOEC.