Centrifuge testing and numerical analysis of box culverts installed in induced trenches

Induced trench construction is routinely used for circular conduits, but its application for box culverts is less common. To understand the complex soil–structure interaction issues related to the design of induced trench box culverts, centrifuge tests were performed to measure earth pressures on a model box culvert installed in several induced trench configurations. These tests were modelled with FLAC and good agreement was achieved. A parametric study performed with FLAC identified a preferred compressible zone geometry having a width of 1.2 times the culvert width and a thickness of 0.5 times the culvert height. For this geometry, the earth pressure on the top was 0.28 times the overburden, the lateral earth pressure on the sides was 0.47 times the mid-height overburden, and the contact pressure at the base was 0.73 times the overburden plus the pressure from the dead load of the culvert. The average base contact pressures for the induced trench geometry were 35% lower than those for the corresponding ...

[1]  Howard F. Peckworth Concrete pipe handbook , 1958 .

[2]  Frazier Parker,et al.  Effects of frictional forces acting on sidewalls of buried box culverts , 2008 .

[3]  A Marston,et al.  THE THEORY OF EXTERNAL LOADS ON CLOSED CONDUITS IN THE LIGHT OF THE LATEST EXPERIMENTS , 1930 .

[4]  Makoto Kawamura,et al.  Centrifugal model test for reducing the earth pressure on the culvert by using the flexible material , 1994 .

[5]  Chai H. Yoo,et al.  Design Loading on Deeply Buried Box Culverts , 2005 .

[6]  Bryan E. Little,et al.  American Association of State Highway and Transportation Officials. Highway Drainage Guidelines American Association of State Highway and Transportation Officials. LRFD Bridge Design Specifications , 2000 .

[7]  Richard L. Handy Anatomy of an Error , 2004 .

[8]  John H. Scarino Reappraisal of Marston’s Formula , 2003 .

[9]  Raveed Aslam Centrifuge modelling of piled embankments , 2008 .

[10]  John S. Horvath,et al.  Expanded Polystyrene (EPS) geofoam: An introduction to material behavior , 1994 .

[11]  Benjamin L. McGuiganB.L. McGuigan,et al.  Field monitoring and analysis of twin 3660 mm inside diameter induced trench culverts installed under 21.7 m of fill , 2011 .

[12]  Arun J. Valsangkar,et al.  Earth pressures on twin positive projecting and induced trench box culverts under high embankments , 2011 .

[13]  J. A. Sladen,et al.  The induced trench method—a critical review and case history , 1988 .

[14]  Arun J. Valsangkar,et al.  Performance of an Induced Trench Installation , 2005 .

[15]  J. M. Duncan,et al.  Nonlinear Analysis of Stress and Strain in Soils , 1970 .

[16]  L Miller,et al.  Performance of Induced Trench Culverts in New Brunswick , 2007 .

[17]  Arun J. Valsangkar,et al.  Field performance, centrifuge testing, and numerical modelling of an induced trench installation , 2008 .

[18]  Jan Vaslestad,et al.  LOAD REDUCTION ON RIGID CULVERTS BENEATH HIGH FILLS: LONG-TERM BEHAVIOR , 1993 .

[19]  M G Spangler,et al.  FIELD MEASUREMENTS OF THE SETTLEMENT RATIOS OF VARIOUS HIGHWAY CULVERTS , 1950 .