Simulation and measurement of quasi-optical multipliers

The lumped-element finite-difference time-domain method is used to analyze quasi-optical multipliers based on diode loaded slot antennas. The method is validated firstly for a passive microstrip-fed structure then for the diode loaded case in both small- and large-signal regimes. The diode model is separately validated using a series diode mounted on a microstrip line. Input return loss and radiation patterns show good agreement with measurements and the concept of effective conversion loss is introduced and results show reasonable agreement between measurement and simulation. A new diode arrangement is introduced where dual offset diodes are placed in the slot instead of the conventional central diode. The diode position can then act as an extra design parameter. The performance of the two structures has been compared; currently best performance is still obtained for the central-diode structure. Finally, a fully quasi-optical structure is simulated with plane-wave excitation. Central and dual-diode structures are again compared and the diode position and input plane-wave field strengths are optimized. Slot voltage distributions, radiation patterns, and effective quasi-optical conversion losses are presented.

[1]  Luca Roselli,et al.  Optimum mesh grading for finite-difference method , 1996 .

[2]  A. Taflove,et al.  Numerical Solution of Steady-State Electromagnetic Scattering Problems Using the Time-Dependent Maxwell's Equations , 1975 .

[3]  K. Yee.  Numerical solution of initial boundary value problems involving maxwell's equations in isotropic media , 1966 .

[4]  N. Camilleri.  A Quasi-Optical Multiplying Slot Array , 1985 .

[5]  C. Durney,et al.  Extending the two-dimensional FDTD method to hybrid electromagnetic systems with active and passive lumped elements , 1992 .

[6]  S. Gedney.  An anisotropic perfectly matched layer-absorbing medium for the truncation of FDTD lattices , 1996 .

[7]  Gabriel M. Rebeiz,et al.  CPW-fed active slot antennas , 1994 .

[8]  P.H. Siegel,et al.  A Simple Quasi-Optical Mixer for 100-120 GHz , 1977, 1977 IEEE MTT-S International Microwave Symposium Digest.

[9]  Y. Yoshimura.  A Microstripline Slot Antenna (Short Papers) , 1972 .

[10]  T. Itoh,et al.  A layered negative resistance amplifier and oscillator using a FET and a slot antenna , 1991, 1991 IEEE MTT-S International Microwave Symposium Digest.

[11]  J. Chramiec,et al.  Microwave and Millimeter-Wave Diode Frequency Multipliers , 1995 .

[12]  Jonas Zmuidzinas,et al.  Quasi-optical slot antenna SIS mixers , 1991 .

[13]  S.,et al.  Numerical Solution of Initial Boundary Value Problems Involving Maxwell’s Equations in Isotropic Media , 1966 .

[14]  Kai Chang,et al.  Integrated active antennas and spatial power combining , 1996 .

[15]  R. Luebbers,et al.  A finite-difference time-domain near zone to far zone transformation (electromagnetic scattering) , 1991 .

[16]  Jack R. East,et al.  Current saturation in submillimeter-wave varactors , 1992 .

[17]  L. Roselli,et al.  Analysis of Dual Slot Antennas for Quasi-Optical Applications using Lumped Element (LE)-FDTD Method , 1998, 1998 28th European Microwave Conference.

[18]  P. Ciampolini,et al.  Accurate and efficient circuit simulation with lumped-element FDTD technique , 1996 .

[19]  L. Roselli,et al.  On the accuracy of the finite-difference method using mesh grading , 1995, Proceedings of 1995 IEEE MTT-S International Microwave Symposium.

[20]  Wolfgang J. R. Hoefer,et al.  A Graded Mesh FD-TD Algorithm for Eigenvalue Problems , 1987, 1987 17th European Microwave Conference.