Scaling of Miniature Piston Engine Performance Part 2: Energy Losses

Previous work based on measurements of the overall performance of small, (<10  cc displacement) two-stroke piston engines has shown that power and efficiency decrease more rapidly with size in miniature (<10  cc displacement) than in larger-scale engines. The present work seeks explanations for these trends by using energy balance analyses to identify and quantify the principal loss mechanisms in miniature engines. Energy losses in order of decreasing importance are found to be: incomplete combustion, heat transfer, sensible enthalpy in the exhaust, and friction. This ordering is almost opposite to that observed in conventional-scale engines. The results show that the scale-dependence of thermal and mechanical efficiency drive the drop in overall efficiency but that the biggest problem is incomplete combustion that consumes 50–60% of the fuel energy. Power output decreases somewhat less rapidly than efficiency because delivery ratio increases with decreasing scale in the set of engines investigated here. ...

[1]  C. R. Ferguson.  Internal Combustion Engines: Applied Thermosciences , 1986 .

[2]  C. S. Wang,et al.  Heat transfer in internal combustion engines , 1985 .

[3]  Eran Sher,et al.  Scavenging the two-stroke engine , 1990 .

[4]  Alfred Jante.  Scavenging and Other Problems of Two-Stroke Cycle Spark-Ignition Engines , 1968 .

[5]  Todd D. Fansler,et al.  The Scavenging Flow Field in a Crankcase-Compression Two-Stroke Engine - A Three-Dimensional Laser-Velocimetry Survey , 1992 .

[6]  Sungho Chang,et al.  Performance test and simulation of a reciprocating engine for long endurance miniature unmanned aerial vehicles , 2005 .

[7]  P. S. Myers,et al.  Experimental Instantaneous Heat Fluxes in a Diesel Engine and Their Correlation , 1969 .

[8]  C. Finol,et al.  Thermal modelling of modern engines: A review of empirical correlations to estimate the in-cylinder heat transfer coefficient , 2006 .

[9]  Eran Sher,et al.  Miniaturization limitations of HCCI internal combustion engines , 2009 .

[10]  Paul J. Litke,et al.  Comparison of In-Cylinder Pressure Measurement Methods in a Small Spark Ignition Engine , 2014 .

[11]  Jaal Ghandhi,et al.  Scavenging Measurements in a Direct-Injection Two-Stroke Engine , 2003 .

[12]  G. Lavoie,et al.  A Fundamental Model for Predicting Fuel Consumption, NOx and HC Emissions of the Conventional Spark-Ignited Engine , 1980 .

[13]  John B. Heywood,et al.  SIMULATION STUDIES OF THE EFFECTS OF TURBOCHARGING AND REDUCED HEAT TRANSFER ON SPARK-IGNITION ENGINE OPERATION , 1980 .

[14]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[15]  John F Thomas,et al.  Experimental Evaluation of a 4-cc Glow-Ignition Single-Cylinder Two-Stroke Engine , 2014 .

[16]  John B. Heywood,et al.  The Contribution of Different Oil Consumption Sources to Total Oil Consumption in a Spark Ignition Engine , 2004 .

[17]  Meng-Jing Wu,et al.  Numerical simulation of the combustion of hydrogen–air mixture in micro-scaled chambers. Part I: Fundamental study , 2005 .

[18]  Charles P. Roberts,et al.  STUDY OF MINIATURE ENGINE-GENERATOR SETS , 1953 .

[19]  Eran Sher,et al.  Scaling-Down of Miniature Internal Combustion Engines: Limitations and Challenges , 2005 .

[20]  Eiichi Watanabe,et al.  A Study of the Delivery Ratio Characteristics of Crankcase-Scavenged Two-Stroke Cycle Engines , 1969 .

[21]  Sejin Kwon,et al.  Heat transfer and quenching analysis of combustion in a micro combustion vessel , 2002 .

[22]  John B. Heywood,et al.  Two-Stroke Cycle Engine: It's Development, Operation and Design , 1999 .

[23]  Vittorio Manente.  Characterization of Glow Plug and HCCI Combustion Processes in a Small Volume at High Engine Speed - Load Range, Emission Characteristics and Optical Diagnostics , 2007 .

[24]  J. K. Martin,et al.  Velocity field characteristics in motored two-stroke ported engines. (Reannouncement with new availability information) , 1992 .

[25]  B. Chehroudi,et al.  Intake-Port Flow Behavior in a Motored and Fired Two-Stroke Research Engine , 1995 .

[26]  Christopher P. Cadou,et al.  Investigation of Combustion Processes in Miniature Internal Combustion Engines , 2013 .

[27]  Shyam Menon,et al.  The Scaling of Performance and Losses in Miniature Internal Combustion Engines , 2010 .

[28]  R. G. Kenny,et al.  Single cycle gas testing method for two-stroke engine scavenging , 1985 .

[29]  Shyam Menon,et al.  Performance Measurement and Scaling in Small Internal Combustion Engines , 2003 .

[30]  Myer Kutz,et al.  Mechanical Engineers' Handbook: Energy and Power , 2006 .

[31]  A. Carlos Fernandez-Pello,et al.  Micropower generation using combustion: Issues and approaches , 2002 .

[32]  Jeffrey H. Lang,et al.  MICRO-HEAT ENGINES, GAS TURBINES, AND ROCKET ENGINES -THE MIT MICROENGINE PROJECT- , 1997 .

[33]  W. J. D. Annand,et al.  Heat Transfer in the Cylinders of Reciprocating Internal Combustion Engines , 1963 .

[34]  G. P. Blair,et al.  The Unsteady Gas Exchange Characteristics of a Two-Cycle Engine , 1976 .

[35]  Benjamin Pinkel,et al.  Correlation of Cooling Data from an Air-Cooled Cylinder and Several Multicylinder Engines , 1940 .

[36]  J. M. Pastor,et al.  Experimental facility and methodology for systematic studies of cold startability in direct injection Diesel engines , 2009 .

[38]  P. Ronney,et al.  Combustion in microscale heat-recirculating burners , 2001 .

[39]  B. Pinkel.  Heat-Transfer Processes in Air-Cooled Engine Cylinders , 1938 .

[40]  R. G. Kenny,et al.  Experimental Assessment of Scavenging Efficiency of Two-Stroke Cycle Engines , 1980 .

[41]  Ronald D. Matthews.  Relationship of brake power to various energy efficiencies and other engine parameters: the efficiency rule , 1983 .

[42]  Mark Short,et al.  Submillimeter‐scale combustion , 2004 .

[43]  N. Buchanan,et al.  Internal-Combustion Engines , 1945 .

[44]  Ronald D. Matthews,et al.  A New Technique for Thermodynamic Engine Modeling , 1983 .