论文信息 - Full system verification of CAN network at high speed transmission rate using VHDL-AMS

Full system verification of CAN network at high speed transmission rate using VHDL-AMS

This paper considers the full system verification of a large size CAN network (up to 24 nodes) at high transmission rate (500 Kbps and 1.0Mbps). The entire CAN physical layer is simulated by using behavior modeling language (VHDL-AMS) in comparison to measurement. The modeling of measurement environment of the CAN network is discussed, showing how to get the measurement and simulation results well matched. This demonstrates that the simulation solution is reliable, which is highly desired and very important for the verification requirement in CAN physical layer design. With the developed CAN measurement system, application layer is also proven working properly when implementing different non-standard topologies at high speed transmission rate.

Thang Nguyen | Georg Pelz | Martin Duregger

[1] M. Valle,et al. A mixed-mode behavioral model of a Controller-Area-Network bus transceiver: a case study , 2007, 2007 IEEE International Behavioral Modeling and Simulation Workshop.

[2] Joachim Haase,et al. Sensitivity analysis of passive CAN bus components to investigate signal integrity of CAN network physical layer , 2008, 2008 IEEE International Behavioral Modeling and Simulation Workshop.

[3] Georg Pelz,et al. In-vehicle network verification from application to physical layer , 2004 .

[4] W. Lawrenz,et al. Validation of in-vehicle-protocol network topologies , 2007, Second International Conference on Systems (ICONS'07).

[5] Georg Pelz,et al. Mechatronic Systems: Modelling and Simulation with HDLs , 2003 .

[6] Thorsten Gerke,et al. Development and Verification of In-Vehicle Networks in a Virtual Environment , 2005 .

[7] Jean Oudinot,et al. Full Transceiver Circuit Simulation using VHDL-AMS , 2002, ESM.