Effect of cavity surface roughness and wettability on the filling flow in micro injection molding
暂无分享,去创建一个
[1] F. Fang,et al. Filling of high aspect ratio micro features of a microfluidic flow cytometer chip using micro injection moulding , 2018 .
[2] Hiroshi Ito,et al. Replication of Micro-/Nanostructures , 2018 .
[3] G. Zitzenbacher,et al. Calculation of the Contact Angle of Polymer Melts on Tool Surfaces from Viscosity Parameters , 2017, Polymers.
[4] G. Lucchetta,et al. Effect of vacuum venting and mold wettability on the replication of micro-structured surfaces , 2017 .
[5] I. Fassi,et al. Effect of Surface Roughness in Micro Injection Moulding Process of Thin Cavities , 2016 .
[6] Bin Li,et al. A method of measuring tool tip vibration in turning operations , 2016 .
[7] P. M. Kristiansen,et al. On The Role of Wetting, Structure Width, and Flow Characteristics in Polymer Replication on Micro‐ and Nanoscale , 2016 .
[8] Z. Huang,et al. Influence of tool surface on wall sliding of polymer melts , 2015 .
[9] D. Drummer,et al. Investigation on the Achievable Flow Length in Injection Moulding of Polymeric Materials with Dynamic Mould Tempering , 2013, TheScientificWorldJournal.
[10] M. Gilchrist,et al. Replication of micro/nano-scale features by micro injection molding with a bulk metallic glass mold insert , 2012 .
[11] Y. Lam,et al. Effects of Mold Surface Roughness on Compressible Flow of Micro-Injection Molding , 2012 .
[12] S. Hatzikiriakos. Wall slip of molten polymers , 2012 .
[13] Hiroshi Ito,et al. Effects of mold surface conditions on flow length in injection molding process , 2011 .
[14] T. Pham,et al. Determination of the heat transfer coefficient from short‐shots studies and precise simulation of microinjection molding , 2010 .
[15] Y. Lam,et al. Mold surface roughness effects on cavity filling of polymer melt in micro injection molding , 2008 .
[16] Y. Lam,et al. Effects of surface roughness on microinjection molding , 2007 .
[17] Abdelhakim Bendada,et al. Analysis of thermal contact resistance between polymer and mold in injection molding , 2004 .
[18] Shinill Kang,et al. The Effect of Wettability of Nickel Mold Insert on the Surface Quality of Molded Microlenses , 2003 .
[19] Robert N. Wenzel,et al. Surface Roughness and Contact Angle. , 1949 .