CMOS Power Amplifier Integrated Circuit With Dual-Mode Supply Modulator for Mobile Terminals

A CMOS power amplifier integrated circuit with an optimized dual-mode supply modulator is presented. The dual-mode supply modulator, based on a hybrid buck converter consisting of a wideband linear amplifier and a highly efficient switching amplifier, provides two operation modes: envelope tracking (ET) for high average output power and average power tracking (APT) for low output power. For the APT mode, the linear amplifier is switched off and the switching amplifier operates as a normal buck converter to supply DC voltage to the power amplifier according to the average output power. The optimum switch sizes of the switching amplifier were analyzed and applied for each operation mode for higher efficiency. An integrated circuit with a power amplifier and the dual-mode supply modulator was designed and fabricated using a 0.18-μm CMOS process for LTE applications at a frequency of 0.78 GHz. For the 16-QAM uplink LTE signal, the measured efficiency with an ET mode is as high as 45.4%, which is 7.0% higher than that from the stand-alone power amplifier at an average output power of 24 dBm. An efficiency of 14.1% was achieved with an APT mode at an average output power of 9 dBm. This is 3.2% higher than that with the ET mode.

[1]  Jinsung Choi,et al.  Optimization for Envelope Shaped Operation of Envelope Tracking Power Amplifier , 2011, IEEE Transactions on Microwave Theory and Techniques.

[2]  Pedro Alou,et al.  Three-Level Cell Topology for a Multilevel Power Supply to Achieve High Efficiency Envelope Amplifier , 2012, IEEE Transactions on Circuits and Systems I: Regular Papers.

[3]  Kevin Chen,et al.  Circuits and System Design of RF Polar Transmitters Using Envelope-Tracking and SiGe Power Amplifiers for Mobile WiMAX , 2011, IEEE Transactions on Circuits and Systems I: Regular Papers.

[4]  Yan Li,et al.  Design of High Efficiency Monolithic Power Amplifier With Envelope-Tracking and Transistor Resizing for Broadband Wireless Applications , 2012, IEEE Journal of Solid-State Circuits.

[5]  Thomas H. Lee,et al.  The Design of CMOS Radio-Frequency Integrated Circuits: RF CIRCUITS THROUGH THE AGES , 2003 .

[6]  Jinsung Choi,et al.  A Polar Transmitter With CMOS Programmable Hysteretic-Controlled Hybrid Switching Supply Modulator for Multistandard Applications , 2009, IEEE Transactions on Microwave Theory and Techniques.

[7]  Philip K. T. Mok,et al.  A Two-Phase Switching Hybrid Supply Modulator for RF Power Amplifiers With 9% Efficiency Improvement , 2010, IEEE Journal of Solid-State Circuits.

[8]  G.A. Rincon-Mora,et al.  A high-efficiency linear RF power amplifier with a power-tracking dynamically adaptive buck-boost supply , 2004, IEEE Transactions on Microwave Theory and Techniques.

[9]  Bumman Kim,et al.  Envelope-Tracking Two-Stage Power Amplifier With Dual-Mode Supply Modulator for LTE Applications , 2013, IEEE Transactions on Microwave Theory and Techniques.

[10]  P. M. Asbeck,et al.  A Wideband CMOS/GaAs HBT Envelope Tracking Power Amplifier for 4G LTE Mobile Terminal Applications , 2012, IEEE Transactions on Microwave Theory and Techniques.

[11]  Dongsu Kim,et al.  Highly Efficient Dual-Switch Hybrid Switching Supply Modulator for Envelope Tracking Power Amplifier , 2012, IEEE Microwave and Wireless Components Letters.

[12]  George B. Norris,et al.  High efficiency CDMA RF power amplifier using dynamic envelope tracking technique , 2000, 2000 IEEE MTT-S International Microwave Symposium Digest (Cat. No.00CH37017).

[13]  Paul N. Whatmough,et al.  System-Efficiency Analysis of Power Amplifier Supply-Tracking Regimes in Mobile Transmitters , 2009, IEEE Transactions on Circuits and Systems I: Regular Papers.

[14]  D.J. Allstot,et al.  A Class-G Supply Modulator and Class-E PA in 130 nm CMOS , 2009, IEEE Journal of Solid-State Circuits.

[15]  Fadhel M. Ghannouchi,et al.  Envelope Tracked Pulse Gate Modulated GaN HEMT Power Amplifier for Wireless Transmitters , 2015, IEEE Transactions on Circuits and Systems I: Regular Papers.

[16]  L.E. Larson,et al.  Design of wide-bandwidth envelope-tracking power amplifiers for OFDM applications , 2005, IEEE Transactions on Microwave Theory and Techniques.

[17]  Didier Belot,et al.  A transmitter architecture for nonconstant envelope modulation , 2006, IEEE Transactions on Circuits and Systems II: Express Briefs.

[18]  Dongsu Kim,et al.  A Dual Power-Mode Multi-Band Power Amplifier With Envelope Tracking for Handset Applications , 2013, IEEE Transactions on Microwave Theory and Techniques.

[19]  Min-Chul Lee,et al.  A 2 W CMOS Hybrid Switching Amplitude Modulator for EDGE Polar Transmitters , 2007, IEEE Journal of Solid-State Circuits.

[20]  Jinsung Choi,et al.  Optimized Envelope Tracking Operation of Doherty Power Amplifier for High Efficiency Over an Extended Dynamic Range , 2009, IEEE Transactions on Microwave Theory and Techniques.

[21]  Peter M. Asbeck,et al.  A Combined Series-Parallel Hybrid Envelope Amplifier for Envelope Tracking Mobile Terminal RF Power Amplifier Applications , 2012, IEEE Journal of Solid-State Circuits.

[22]  Dongsu Kim,et al.  Envelope-Tracking CMOS Power Amplifier Module for LTE Applications , 2013, IEEE Transactions on Microwave Theory and Techniques.

[23]  Feipeng Wang,et al.  A Monolithic High-Efficiency 2.4-GHz 20-dBm SiGe BiCMOS Envelope-Tracking OFDM Power Amplifier , 2007, IEEE Journal of Solid-State Circuits.

[24]  Bumman Kim,et al.  Highly Efficient RF Transmitter Over Broad Average Power Range Using Multilevel Envelope-Tracking Power Amplifier , 2015, IEEE Transactions on Circuits and Systems I: Regular Papers.

[25]  Yan Li,et al.  A SiGe Envelope-Tracking Power Amplifier With an Integrated CMOS Envelope Modulator for Mobile WiMAX/3GPP LTE Transmitters , 2011, IEEE Transactions on Microwave Theory and Techniques.