Design and optimization of a solar air heater with offset strip fin absorber plate

Solar air heaters are becoming more and more popular in space heating and industrial processes due to their cost effectiveness and easy maintenance. However, how to increase thermal efficiency of solar air heaters becomes a major challenge. In this paper, the design of a solar air heater with offset strip fins was optimized by numerical modeling. Then, a series of experiments based on ASHRAE Standard 93-2003 was conducted to test the detailed thermal performance of the heater in the light of time constant, thermal efficiency, incident angle modifier and the synthetical resistance coefficient. Results indicate that the instantaneous thermal efficiency exceeded 0.40 even when the heater was running at low airflow rate (100m3h−1) under the typical space heating application where the solar irradiance on the collecting area was 600Wm−2, indoor air temperature 14°C, outdoor air temperature −5°C, and solar incidence angle 20°. Such a design would only require fan power of approximately 20W. The work would be useful for developing energy efficient and cost effective solar air heaters.

[1]  Chii-Dong Ho,et al.  The influences of recycle on performance of baffled double-pass flat-plate solar air heaters with internal fins attached , 2009 .

[2]  Angelika Bayer,et al.  Solar Engineering Of Thermal Processes , 2016 .

[3]  I. T. Toğrul,et al.  Thermal efficiency of an air solar collector with extended absorption surface and increased convection , 2002 .

[4]  Ephraim M Sparrow,et al.  Effect of Finite Width on Heat Transfer and Fluid Flow about an Inclined Rectangular Plate , 1979 .

[5]  S. C. Solanki,et al.  Thermohydraulic performance of solar air heaters with roughened absorber plates , 1997 .

[6]  A. P. Omojaro,et al.  Experimental performance of single and double pass solar air heater with fins and steel wire mesh as absorber , 2010 .

[7]  Vladimir Vukovic,et al.  Calibration and validation of a solar thermal system model in Modelica , 2012 .

[8]  Donatien Njomo,et al.  Sensitivity analysis of thermal performances of flat plate solar air heaters , 2006 .

[9]  Giovanni Tanda,et al.  Performance of solar air heater ducts with different types of ribs on the absorber plate , 2011 .

[10]  Tao Liu,et al.  Analytical and experimental studies on the thermal performance of cross-corrugated and flat-plate solar air heaters , 2007 .

[11]  V. Gnielinski.  New equations for heat and mass transfer in turbulent pipe and channel flow , 1976 .

[12]  Azharul Karim,et al.  Performance investigation of flat plate, v-corrugated and finned air collectors , 2006 .

[13]  R. M. Manglik,et al.  Heat transfer and pressure drop correlations for the rectangular offset strip fin compact heat exchanger , 1995 .

[14]  Shinsuke Kato,et al.  Development of an optimal design aid system based on building information modeling , 2011 .

[15]  Sukhmeet Singh,et al.  Low cost solar air heater , 2012 .

[16]  E. V. Dubrovsky.  Experimental investigation of highly effective plate-fin heat exchanger surfaces , 1995 .

[17]  Xudong Yang,et al.  Experimental analysis on thermal performance of a solar air collector with a single pass , 2012 .

[18]  Paisarn Naphon,et al.  Effect of porous media on the performance of the double-pass flat plate solar air heater☆ , 2005 .

[19]  W. Swinbank.  Long‐wave radiation from clear skies , 1963 .

[20]  R. Doremus,et al.  Handbook of glass properties , 1986 .

[21]  Vice President,et al.  AMERICAN SOCIETY OF HEATING, REFRIGERATION AND AIR CONDITIONING ENGINEERS INC. , 2007 .

[22]  Fatih Koçyiğit,et al.  Energy and exergy analysis of a new flat-plate solar air heater having different obstacles on absorber plates , 2010 .

[23]  A. El-sebaii,et al.  Investigation of thermal performance of-double pass-flat and v-corrugated plate solar air heaters , 2011 .

[24]  J. Lienhard.  A heat transfer textbook , 1981 .

[25]  S. Singh,et al.  A review of solar dryers developed for grape drying , 2009 .

[26]  Robert J. Moffat,et al.  Describing the Uncertainties in Experimental Results , 1988 .

[27]  Sunil Kumar Singal,et al.  Effective efficiency of solar air heaters having different types of roughness elements on the absorber plate , 2007 .

[28]  M. A. Wazed,et al.  Design and fabrication of a cost effective solar air heater for Bangladesh , 2010 .

[29]  Adel A. Hegazy.  Thermohydraulic performance of air heating solar collectors with variable width, flat absorber plates , 2000 .

[30]  S. Youcef-Ali,et al.  Numerical and experimental study of a solar equipped with offset rectangular plate fin absorber plate , 2006 .

[31]  S. Youcef-Ali,et al.  Study and optimization of the thermal performances of the offset rectangular plate fin absorber plates, with various glazing , 2005 .

[32]  Azharul Karim,et al.  Performance evaluation of a v-groove solar air collector for drying applications , 2006 .

[33]  Siddhartha,et al.  Thermal performance optimization of a flat plate solar air heater using genetic algorithm , 2010 .

[34]  H. Buchberg,et al.  Natural Convection in Enclosed Spaces—A Review of Application to Solar Energy Collection , 1974 .

[35]  A. Cortés,et al.  Improvement of the efficiency of a bare solar collector by means of turbulence promoters , 1990 .

[36]  Paolo Fornasini,et al.  The Uncertainty in Physical Measurements: An Introduction to Data Analysis in the Physics Laboratory , 2008 .