Optimization study of purge cycle in proton exchange membrane fuel cell system

Abstract In PEMFC ( proton exchange membrane fuel cell ) systems operating in dead-end mode, hydrogen purges are needed to remove accumulated inert gases and liquid water from the anode side of the fuel cell stack. Hydrogen purges were studied using different humidity levels, purge times, and purge triggering criteria. The purged gas volume and composition were accurately measured with fast data acquisition and an advanced experimental set-up. The experiments were done with constant current density with aim of keeping the anode gas recirculation rate constant. Fuel utilization per pass varied as the hydrogen content on the anode side changed. This study demonstrates how the optimized purge strategy changes with a changing humidity level. It also shows that high fuel efficiency (>99%) is easily reached and that with optimized purge strategy a very high fuel efficiency (99.9%) can be reached. It was also shown that concentration polarization due to accumulation of inert gases on the anode side is two times higher than values obtained by theoretical calculations. This result is significant for purge strategy and system design.

[1]  B. Wetton,et al.  A simple, analytic model of polymer electrolyte membrane fuel cell anode recirculation at operating , 2011 .

[2]  J. Ihonen,et al.  The use of on-line hydrogen sensor for studying inert gas effects and nitrogen crossover in PEMFC system , 2011 .

[3]  S. Pitchumani,et al.  Experimental analysis of spatio-temporal behavior of anodic dead-end mode operated polymer electroly , 2011 .

[4]  Min-Soo Kim,et al.  Characterization of nitrogen gas crossover through the membrane in proton-exchange membrane fuel cel , 2011 .

[5]  Xiaoping Wang,et al.  Buildup of nitrogen in direct hydrogen polymer-electrolyte fuel cell stacks. , 2007 .

[6]  Anna G. Stefanopoulou,et al.  Correlating Nitrogen Accumulation With Temporal Fuel Cell Performance , 2010 .

[7]  D. Wilkinson,et al.  A critical review of two-phase flow in gas flow channels of proton exchange membrane fuel cells , 2010 .

[8]  M. Péra,et al.  PEFC Stack Operating in Anodic Dead End Mode , 2004 .

[9]  Mariagiovanna Minutillo,et al.  Behaviour modelling of a PEMFC operating on diluted hydrogen feed , 2008 .

[10]  R. Seyezhai,et al.  Modeling and control of a PEM fuel cell based hybrid multilevel inverter , 2011 .

[11]  Felix N. Büchi,et al.  Heterogeneous Cell Ageing in Polymer Electrolyte Fuel Cell Stacks , 2009 .

[12]  Anna G. Stefanopoulou,et al.  Parameterization and prediction of temporal fuel cell voltage behavior during flooding and drying conditions , 2008 .

[13]  Saeed Asghari,et al.  An investigation into the effect of anode purging on the fuel cell performance , 2010 .

[14]  Suk Won Cha,et al.  Experimental study on enhancing the fuel efficiency of an anodic dead-end mode polymer electrolyte m , 2010 .

[15]  Luis M. Fernández,et al.  PEM fuel cell modeling using system identification methods for urban transportation applications , 2011 .

[16]  Jason B. Siegel,et al.  Nitrogen Front Evolution in Purged Polymer Electrolyte Membrane Fuel Cell with Dead-Ended Anode , 2010 .