Part II: fracture strength and elastic modulus as a function of porosity for hydroxyapatite and other brittle materials.

[1]  U. Henriksen,et al.  A study of bonding and failure mechanisms in fuel pellets from different biomass resources , 2011 .

[2]  Akh Kwan,et al.  Wet packing of crushed rock fine aggregate , 2009 .

[3]  Fei Ren,et al.  Resonant ultrasound spectroscopy measurement of Young's modulus, shear modulus and Poisson's ratio as a function of porosity for alumina and hydroxyapatite , 2009 .

[4]  M. Kanatzidis,et al.  The high-temperature elastic moduli of polycrystalline PbTe measured by resonant ultrasound spectroscopy , 2008 .

[5]  Nam H. Kim,et al.  Introduction to Finite Element Analysis and Design , 2008 .

[6]  W. Clegg,et al.  The effect of porosity in thermal shock , 2008, Journal of Materials Science.

[7]  W. Sharpe,et al.  Fracture Strength of Single-Crystal Silicon Carbide Microspecimens at 24 $^{\circ}\hbox{C}$ and 1000 $^{\circ}\hbox{C}$ , 2008, Journal of Microelectromechanical Systems.

[8]  Aibing Yu,et al.  Simulation of the packing of cohesive particles , 2007, Comput. Phys. Commun..

[9]  J. Valverde,et al.  Adhesion force between fine particles with controlled surface properties , 2006 .

[10]  Franco Nori,et al.  Wet granular materials , 2006, cond-mat/0601660.

[11]  W. Sharpe,et al.  Fracture strength of silicon carbide microspecimens , 2005, Journal of Microelectromechanical Systems.

[12]  F. Ren,et al.  Three-Dimensional Microstructural Characterization of Porous Hydroxyapatite Using Confocal Laser Scanning Microscopy , 2005 .

[13]  Robert J. Flatt,et al.  DISPERSION FORCES IN CEMENT SUSPENSIONS , 2004 .

[14]  C. Baudín,et al.  Statistical analysis of the fracture behaviour of porous ceramic Raschig rings , 2004 .

[15]  Naoyuki Nomura,et al.  Mechanical properties of porous titanium compacts prepared by powder sintering , 2003 .

[16]  Runyu Yang,et al.  On the relationship between porosity and interparticle forces , 2003 .

[17]  T. Ohji,et al.  Fabrication and characterisation of porous silicon nitride ceramics using Yb2O3 as sintering additive , 2003 .

[18]  T. Ohji,et al.  Effect of Agglomeration on Mechanical Properties of Porous Zirconia Fabricated by Partial Sintering , 2002 .

[19]  J. Rödel,et al.  Evolution of defect size and strength of porous alumina during sintering , 2000 .

[20]  Engen Libowitzky,et al.  Correlation of O-H stretching frequencies and O-H…O hydrogen bond lengths in minerals , 1999 .

[21]  Roy W. Rice,et al.  Porosity of Ceramics: Properties and Applications , 1998 .

[22]  A. Barabasi,et al.  What keeps sandcastles standing? , 1997, Nature.

[23]  Michel W. Barsoum,et al.  Fundamentals of Ceramics , 1996 .

[24]  A. Evans,et al.  Mechanical Properties of Partially Dense Alumina Produced from Powder Compacts , 1994 .

[25]  R. P. Ingel,et al.  Elastic Anisotropy in Zirconia Single Crystals , 1988 .

[26]  W. Gunsser,et al.  Zahlenwerte und Funktionen aus Naturwissenschaften und Technik , 1987, September.

[27]  E. Case,et al.  Characterization of microcracks in YCrO3 using small-angle neutron scattering and elasticity measurements , 1984 .

[28]  E. Case,et al.  Microcracking in Large-grain Al2O3 , 1981 .

[29]  R. Bradt,et al.  Grain Size/Microcracking Relations for Pseudobrookite Oxides , 1978 .

[30]  E. Fisher,et al.  Single-Crystal Elastic Moduli and the hcp --> bcc Transformation in Ti, Zr, and Hf , 1964 .

[31]  R. M. Spriggs.  Expression for Effect of Porosity on Elastic Modulus of Polycrystalline Refractory Materials, Particularly Aluminum Oxide , 1961 .

[32]  J. B. Wachtman,et al.  Elastic Constants of Synthetic Single‐Crystal Corundum at Room Temperature , 1960 .

[33]  野村 昭一郎.  W.D.Kingery: Property Measurements at High Temperatures. John Wiley and Sons, Inc., New York, Chapman and Hall, Limited, London. 1959年, 416頁, 18×26cm, 6,600円. , 1960 .

[34]  D. Millard.  Relationship between strength and porosity for coal compacts , 1959 .

[35]  Eugene Ryshkewitch,et al.  Compression Strength of Porous Sintered Alumina and Zirconia , 1953 .

[36]  Weimin Han,et al.  Introduction to Finite Element Analysis , 2013 .

[37]  Eugen Libowitzky,et al.  Korrelation von O*H-Streckfrequenzen und O*H{ctdot};O-Wasserstoffbrückenlängenin Mineralen , 1999 .

[38]  F. Monteiro,et al.  Glass-reinforced hydroxyapatite composites: secondary phase proportions and densification effects on biaxial bending strength. , 1999, Journal of biomedical materials research.

[39]  R. German.  Sintering theory and practice , 1996 .

[40]  D. J. Green,et al.  Mechanical properties of a partially sintered alumina , 1995 .

[41]  D. J. Green,et al.  Strength and Young's Modulus Behavior of a Partially Sintered Porous Alumina , 1995 .

[42]  G. Gritzner,et al.  Preparation and properties of niobia- and tantala-doped orthorhombic zirconia , 1995 .

[43]  A. Ruys,et al.  Sintering effects on the strength of hydroxyapatite. , 1995, Biomaterials.

[44]  Hiroaki Yanagida,et al.  Microstructure dependence of mechanical and dielectric strengths—i. porosity , 1991 .

[45]  K. Phani,et al.  Young's modulus of porous brittle solids , 1987 .

[46]  R. German.  Powder metallurgy science , 1984 .

[47]  W. D. Kingery,et al.  Introduction to Ceramics , 1976 .

[48]  W. Duckworth.  Discussion of Ryshkewitch Paper , 1953 .