Influence of Die Profiles and Cracks on Joint Buttons on the Joint Quality and Mechanical Strengths of High Strength Aluminium Alloy Joint

Currently, self-piercing riveting (SPR) is a major technology used by manufacturers to join aluminium body structures to reduce vehicle weight. Normally, for SPR of one specific stack more than one die, rivet, and velocity combination can be applied. Which parameter combination is chosen is depending on the surrounding joints. In order to increase productivity and reduce the number of robots used, it is preferred to use the same rivet/die combination for as many joints as possible. This means for the same stack, different die may be used. To see the influence of die profiles on joint quality, a DF die, which would generate severe cracks and a DC die, which would generate no cracks or only small cracks, were used to join two stacks with a high strength aluminium alloy, AA6008T61, as the bottom layer. The joint quality was analyzed, and the static and fatigue strengths of these stacks were studied. Results showed that cracks on joint buttons might reduce static and fatigue lap shear strength but had no obvious influence on static and fatigue T peel strength for the joints studied.