Simulation of SiC High Power Devices

The impact of SiC on high power devices and their applications is analysed using simulations in a very wide range of design voltages. First, a detailed presentation of the anisotropic form of the basic equations and of the physical models for 4H-SiC used in the simulations is given. Following that the application ranges of unipolar and bipolar devices in the domains of voltage and frequency are predicted in the case of IGBTs versus MOSFETs and PiN versus Schottky rectifiers based on comparisons of the on-state voltage and of the total losses. The application limit of the MOSFETs compared to IGBTs and of the Schottky rectifiers compared to PiN rectifiers is predicted to be about 4.5 and 2.5 kV, respectively, in the case of the 4H-SiC polytype. The impact of technological limitations of SiC is illustrated by the case of low channel mobility. The merits of SiC as compared to Si are illustrated by the case of a SiC rectifier operating together with a Si IGBT. Dramatically reduced turn-on losses are demonstrated. The superiority of SiC from the point of view of dynamic avalanche is predicted and illlustrated. Finally, some novel SiC switch structures are introduced in response to the reliability problems encountered in ordinary trench MOSFETs.

[1]  John W. Palmour,et al.  Improved oxidation procedures for reduced SiO2/SiC defects , 1996 .

[2]  A. Porst,et al.  Ultimate limits of an IGBT (MCT) for high voltage applications in conjunction with a diode , 1994, Proceedings of the 6th International Symposium on Power Semiconductor Devices and Ics.

[3]  T. Urushidani,et al.  High-voltage (>1 kV) SiC Schottky barrier diodes with low on-resistances , 1993, IEEE Electron Device Letters.

[4]  B. J. Baliga,et al.  Comparison of 6H-SiC, 3C-SiC, and Si for power devices , 1993 .

[5]  Wolfgang J. Choyke,et al.  Static Dielectric Constant of SiC , 1970 .

[6]  J. Halbritter,et al.  Oxidation and 6H-SiC-SiO2 interfaces , 1995 .

[7]  U. Lindefelt,et al.  Detailed band structure for 3C-, 2H-, 4H-, 6H-SiC, and Si around the fundamental band gap. , 1996, Physical review. B, Condensed matter.

[8]  W. J. Choyke,et al.  Absorption of Light in Alpha SiC near the Band Edge , 1957 .

[9]  Andre Stesmans,et al.  Elimination of SiC/SiO2 interface states by preoxidation ultraviolet‐ozone cleaning , 1996 .

[10]  S. Adachi,et al.  Optical Constants of 6H?SiC Single Crystals , 1994 .

[11]  J. Palmour,et al.  Conductivity Anisotropy in Epitaxial 6H and 4H Sic , 1994 .

[12]  A. Agarwal,et al.  A critical look at the performance advantages and limitations of 4H-SiC power UMOSFET structures , 1996, 8th International Symposium on Power Semiconductor Devices and ICs. ISPSD '96. Proceedings.

[13]  R. Helbig.  Progress in new materials for power electronics: SiC , 1993, [1993] Proceedings of the 5th International Symposium on Power Semiconductor Devices and ICs.

[14]  U. Lindefelt.  Heat generation in semiconductor devices , 1994 .

[15]  H. Grüning,et al.  Der feldgesteuerte Thyristor (FCTh) — ein Leistungsschalter mit weitgehend optimalen Eigenschaften für den Einsatz im oberen Leistungsbereich , 1989 .

[16]  S. Selberherr.  Analysis and simulation of semiconductor devices , 1984 .

[17]  R. E. Oakley,et al.  Silicon carbide JFET radiation response , 1992 .

[18]  Richard Dalven,et al.  Temperature coefficient of the energy gap of β-silicon carbide , 1965 .

[19]  B. J. Baliga,et al.  Analysis of silicon carbide power device performance , 1991, [1991] Proceedings of the 3rd International Symposium on Power Semiconductor Devices and ICs.

[20]  J. Palmour,et al.  High Power and High Frequency Silicon Carbide Devices , 1994 .

[21]  Critical nature of oxide/interface quality for SiC power devices , 1995 .

[22]  W. Suttrop,et al.  Nitrogen donors in 4H‐silicon carbide , 1993 .

[23]  Chen,et al.  Determination of the electron effective-mass tensor in 4H SiC. , 1996, Physical review. B, Condensed matter.

[24]  H. Mitlehner,et al.  SiC devices: physics and numerical simulation , 1994 .

[25]  B. J. Baliga,et al.  Silicon-carbide high-voltage (400 V) Schottky barrier diodes , 1992, IEEE Electron Device Letters.

[26]  U. Lindefelt.  Equations for electrical and electrothermal simulation of anisotropic semiconductors , 1994 .

[27]  P. Ivanov,et al.  Recent developments in SiC single-crystal electronics , 1992 .

[28]  J. Palmour,et al.  4H-SiC MESFET with 2.8 W/mm power density at 1.8 GHz , 1994, IEEE Electron Device Letters.

[29]  A.W. Morse,et al.  The mixed mode 4H-SiC SIT as an S-band microwave power transistor , 1996, 1996 54th Annual Device Research Conference Digest.

[30]  Tore Undeland,et al.  Power Electronics: Converters, Applications and Design , 1989 .

[31]  Takahiro Tanaka,et al.  Site effect on the impurity levels in 4 H , 6 H , and 1 5 R SiC , 1980 .

[32]  J. Dziewior,et al.  Auger coefficients for highly doped and highly excited silicon , 1977 .

[33]  Bo Breitholtz,et al.  Heat generation in Si bipolar power devices: The relative importance of various contributions , 1996 .

[34]  S. R. Smith,et al.  Determination of the band offsets of the 4H–SiC/6H–SiC heterojunction using the vanadium donor (0/+) level as a reference , 1995 .

[35]  Sota Kobayashi,et al.  Effects of Channel Mobility on SiC Power Metal-Oxide-Semiconductor Field Effect Transistor Performance , 1996 .