DC link capacitors for traction SRM drives in high temperature automotive environments: A review of current issues and solutions

Recent years have seen an increase in research into switched reluctance machines for automotive traction applications, driven by the cost and scarcity of permanent magnet materials. Such machines increase the demands on the DC link capacitor, which must maintain high reliability and long life while storing large amounts of charge at high voltages. The aim of this paper is to provide an overview of this field at the present time, which is currently lacking in the literature, and provide impetus for future research. The limitations of current technology are identified, both in terms of dielectric materials, control and circuit topology. Current dielectrics and their suitability for this application are assessed and compared. Then methods are illustrated which could reduce the requirements of the DC link capacitor from the perspective of control and circuit topology, which benefit the system design in cost, weight and efficiency.

[1]  Davide Montanari,et al.  Film Capacitors for Automotive and Industrial Applications , 2009 .

[2]  Johann W. Kolar,et al.  A 120 °C Ambient Temperature Forced Air-Cooled Normally-off SiC JFET Automotive Inverter System , 2014, IEEE Transactions on Power Electronics.

[3]  W. J. Fleming,et al.  Overview of automotive sensors , 2001 .

[4]  Seog-Weon Chang,et al.  Reliability evaluation and failure analysis for high voltage ceramic capacitor , 2001, Advances in Electronic Materials and Packaging 2001 (Cat. No.01EX506).

[5]  C.W. Brice,et al.  Simulation of industrial AC drive system under fault conditions , 2003, Eighteenth Annual IEEE Applied Power Electronics Conference and Exposition, 2003. APEC '03..

[6]  R. Grinberg,et al.  Advanced DC link capacitor technology application for a stiff voltage-source inverter , 2005, 2005 IEEE Vehicle Power and Propulsion Conference.

[7]  Seung-Ki Sul,et al.  DC-Link Voltage Stabilization for Reduced DC-Link Capacitor Inverter , 2014, IEEE Transactions on Industry Applications.

[8]  A.M.R. Amaral,et al.  An automatic technique to obtain the equivalent circuit of aluminum electrolytic capacitors , 2008, 2008 34th Annual Conference of IEEE Industrial Electronics.

[9]  G. Friedrich,et al.  A PWM strategy dedicated to RMS current reduction in DC link capacitor of an embedded three phase inverter , 2011, Proceedings of the 2011 14th European Conference on Power Electronics and Applications.

[10]  P.N. Enjeti,et al.  A Real Time Method to Estimate Electrolytic Capacitor Condition in PWM Adjustable Speed Drives and Uninterruptible Power Supplies , 2005, 2005 IEEE 36th Power Electronics Specialists Conference.

[11]  Yves Danto,et al.  High temperature reliability testing of aluminum and tantalum electrolytic capacitors , 2002, Microelectron. Reliab..

[12]  Jih-Sheng Lai,et al.  A low-inductance DC bus capacitor for high power traction motor drive inverters , 2002, Conference Record of the 2002 IEEE Industry Applications Conference. 37th IAS Annual Meeting (Cat. No.02CH37344).

[13]  J.D. Prymak.  New tantalum capacitors in power supply applications , 1998, Conference Record of 1998 IEEE Industry Applications Conference. Thirty-Third IAS Annual Meeting (Cat. No.98CH36242).

[14]  Leon M. Tolbert,et al.  Evaluation of a current source active power filter to reduce the dc bus capacitor in a hybrid electric vehicle traction drive , 2009, 2009 IEEE Energy Conversion Congress and Exposition.

[15]  Bozena Kaminska,et al.  High temperature polymer capacitors for aerospace applications , 2010, 2010 Design, Automation & Test in Europe Conference & Exhibition (DATE 2010).

[16]  J.C. Balda,et al.  Lifetime of Electrolytic Capacitors in Regenerative Induction Motor Drives , 2005, 2005 IEEE 36th Power Electronics Specialists Conference.

[17]  Dan Pitica,et al.  Accelerated ageing tests for predicting capacitor lifetimes , 2011, 2011 IEEE 17th International Symposium for Design and Technology in Electronic Packaging (SIITME).

[18]  W. J. Sarjeant,et al.  Capacitive components for power electronics , 2001, Proc. IEEE.

[19]  M.N. Anwar,et al.  An analytical method for selecting DC-link-capacitor of a voltage stiff inverter , 2002, Conference Record of the 2002 IEEE Industry Applications Conference. 37th IAS Annual Meeting (Cat. No.02CH37344).