Influences of bubble formation on different types of heat exchanger fouling

Abstract In this paper, a systematic comparison is performed to investigate fouling of suspended particles under forced convective and subcooled flow boiling heat transfer. For this purpose, two different types of fouling are separately considered: crystallization fouling of dissolved CaSO4 particles in water and particulate fouling of suspended Al2O3 particles in n–heptane. The effect of hydraulic parameters such as fluid velocity and also bubble generation under subcooled flow boiling are studied. Results of the experiments demonstrate that creation of boiling condition in the heat exchanger has opposite influence in these two types of fouling. It means that bubble generation on the heat transfer surface promotes scale formation under crystallization fouling. This is due to the fact that increased bubble generation creates higher supersaturation beneath the vapor bubble, therefore, increasing the crystal concentration in the boundary layer. On the other hand, boiling condition inhibits the scale formation under particulate fouling because the suspended particles are repelled from the boundary layer by the strong turbulences created by the swarm of bubbles.

[1]  Hans Müller-Steinhagen,et al.  Calcium sulphate scale formation during subcooled flow boiling , 1997 .

[2]  H. Müller-Steinhagen,et al.  Heat Exchanger Fouling and Cleaning in the Dihydrate Process for the Production of Phosphoric Acid , 2007 .

[3]  I. Barin,et al.  Thermochemical properties of inorganic substances , 1973 .

[4]  T. Bott,et al.  The deposition of haematite particles from flowing water , 1988 .

[5]  Luís F. Melo,et al.  Particle Transport in Fouling Caused by Kaolin- Water Suspensions on Copper Tubes* , 1988 .

[6]  N. Al‐Mutairi.  Fouling Studies and Control in Heat Exchangers , 2007 .

[7]  S. M. Peyghambarzadeh,et al.  Application of asymptotic model for the prediction of fouling rate of calcium sulfate under subcooled flow boiling , 2012 .

[8]  Martha Salcudean,et al.  Bubble behavior in subcooled flow boiling of water at low pressures and low flow rates , 2002 .

[9]  Wei Li.  Modeling liquid-side particulate fouling in internal helical-rib tubes , 2007 .

[10]  S. G. Yiantsios,et al.  Deposition of micron-sized particles on flat surfaces: effects of hydrodynamic and physicochemical conditions on particle attachment efficiency , 2003 .

[11]  Christian Jallut,et al.  Particulate fouling of corrugated plate heat exchangers. Global kinetic and equilibrium studies , 1998 .

[12]  S. G. Yiantsios,et al.  LIQUID-SIDE FOULING OF HEAT EXCHANGERS. AN INTEGRATED R & D APPROACH FOR CONVENTIONAL AND NOVEL DESIGNS , 1997 .

[13]  J. Fernández-Seara,et al.  Laboratory Practices with the Wilson Plot Method , 2007 .

[14]  Norman Epstein,et al.  Fine particle deposition in smooth parallel-plate channels , 1979 .

[15]  Mohammad Jamialahmadi,et al.  Measurement and prediction of the rate of deposition of flocculated asphaltene particles from oil , 2009 .

[16]  H. Müller-Steinhagen,et al.  Crystallization of Calcium Sulfate Dihydrate from Phosphoric Acid , 2008 .

[17]  Chongfang Ma,et al.  Experimental Study of Fouling on Heat Transfer Surface During Forced Convective Heat Transfer , 2008 .

[18]  C. Rindt,et al.  Experimental Investigation of CaSO4 Crystallization on a Flat Plate , 2006 .

[19]  D. Lister,et al.  Modeling of Particulate Fouling on Heat Exchanger Surfaces: Influence of Bubbles on Iron Oxide Deposition , 2009 .

[20]  P. Adomeit,et al.  Deposition of fine particles from a turbulent liquid flow: Experiments and numerical predictions , 1996 .

[21]  F. Fahiminia.  Initial fouling rate and delay time studies of aqueous calcium sulphate sealing under sensible heating conditions , 2007 .

[22]  Hans Müller-Steinhagen,et al.  Mathematical modelling of mixed salt precipitation during convective heat transfer and sub-cooled flow boiling , 2005 .

[23]  Derek H. Lister,et al.  The fouling of alloy‐800 heat exchange surfaces by magnetite particles , 2000 .

[24]  H. Müller-Steinhagen,et al.  Comparison of Crystallization Fouling in Plate and Double-Pipe Heat Exchangers , 2001 .

[25]  Tülay A. Özbelge,et al.  Heat transfer enhancement in water—feldspar upflows through vertical annuli , 1996 .

[26]  Norman Epstein,et al.  Elements of particle deposition onto nonporous solid surfaces parallel to suspension flows , 1997 .

[27]  B. D. Bowen,et al.  Fine particle deposition in laminar and turbulent flows , 1995 .

[28]  Mohammad Jamialahmadi,et al.  Mixed salt crystallisation fouling , 2000 .

[29]  Roya Sheikholeslami,et al.  Effect of Thermohydraulic Conditions on Fouling of Calcium Oxalate and Silica , 2005 .

[30]  W. Li,et al.  Fouling in enhanced tubes using cooling tower water: Part I: long-term fouling data , 2000 .

[31]  Kuzman Ražnjević,et al.  Handbook of Thermodynamic Tables and Charts , 1976 .

[32]  C. Brennen.  Cavitation and Bubble Dynamics , 1995 .

[33]  S. Klimas,et al.  Deposition of magnetite particles from flowing suspensions under flow‐boiling and single‐phase forced‐convective heat transfer , 2000 .

[34]  A. Buchelli,et al.  Modeling Fouling Effects in LDPE Tubular Polymerization Reactors. 1. Fouling Thickness Determination , 2005 .

[35]  R. B. Ritter,et al.  Crystalline Fouling Studies , 1983 .

[36]  G. Demopoulos.  Aqueous Precipitation and Crystallization for the Production of Particulate Solids with Desired Properties , 2009 .