Three-phase soft-switching-based interleaved boost converter with high reliability

One of the most important problems related to DC-DC converters is the phenomena of power switch failures. Therefore, applying soft-switching technique to these kinds of converters without adding extra active switch would improve their reliability. In this study, a new high reliable topology with the facility of the soft-switching operation for three-phase interleaved boost converter is proposed. The proposed structure is implemented by adding three inductors to the conventional structure. Automatically, the used power switches in the suggested topology, are turned on under zero voltage condition. In addition, the diodes are turned off under zero current condition. Using this method, the switching losses of semiconductors are reduced. Moreover, there is no additional active switch in the proposed topology. These two advantages cause the reliability of proposed topology to be significantly improved. The comparison results with other similar topologies are presented. Based on comparison results, it is shown that the reliability of the proposed topology is much better than others. Simulation and experimental results are compared with verifying the desired operation of the proposed structure.

[1]  Gevork B. Gharehpetian,et al.  Reliability assessment of single-stage/two-stage PFC converters , 2009, 2009 Compatibility and Power Electronics.

[2]  Gang Yao,et al.  Soft Switching Circuit for Interleaved Boost Converters , 2007, IEEE Transactions on Power Electronics.

[3]  Hosein Farzanehfard,et al.  Novel Family of PWM Soft-Single-Switched DC–DC Converters With Coupled Inductors , 2009, IEEE Transactions on Industrial Electronics.

[4]  M. Kazimierczuk,et al.  Zero-current-transition two-switch flyback pulse-width modulated DC-DC converter , 2011 .

[5]  Po-Wa Lee,et al.  Steady-state analysis of an interleaved boost converter with coupled inductors , 2000, IEEE Trans. Ind. Electron..

[6]  G. Joos,et al.  A zero voltage transition boost converter employing a soft switching auxiliary circuit with reduced conduction losses , 2004, IEEE Transactions on Power Electronics.

[7]  Hirofumi Matsuo,et al.  Novel Solar-Cell Power Supply System Using a Multiple-Input DC-DC Converter , 2006, IEEE Trans. Ind. Electron..

[8]  David M. Otten,et al.  High efficiency power factor correction using interleaving techniques , 1992, [Proceedings] APEC '92 Seventh Annual Applied Power Electronics Conference and Exposition.

[9]  Satılmış Ürgün Zero-voltage transition–zero-current transition pulsewidth modulation DC–DC buck converter with zero-voltage switching‣zero-current switching auxiliary circuit , 2012 .

[10]  John Dalsgaard Sørensen,et al.  Physics of failure as a basis for solder elements reliability assessment in wind turbines , 2012, Reliab. Eng. Syst. Saf..

[11]  Rong-Jong Wai,et al.  High-Performance Stand-Alone Photovoltaic Generation System , 2008, IEEE Transactions on Industrial Electronics.

[12]  Ehsan Adib,et al.  Family of zero-voltage transition pulse width modulation converters with low auxiliary switch voltage stress , 2011 .

[13]  Jose Renes Pinheiro,et al.  A ZCT auxiliary commutation circuit for interleaved boost converters operating in critical conduction mode , 2002 .

[14]  S.K. Mazumder,et al.  A Ripple-Mitigating and Energy-Efficient Fuel Cell Power-Conditioning System , 2007, IEEE Transactions on Power Electronics.

[15]  Peter Tavner,et al.  Reliability of wind turbine subassemblies , 2009 .

[16]  Hamid A. Toliyat,et al.  Partial-Resonant Buck–Boost and Flyback DC–DC Converters , 2014, IEEE Transactions on Power Electronics.

[17]  Caisheng Wang,et al.  Power Management of a Stand-Alone Wind/Photovoltaic/Fuel Cell Energy System , 2008, IEEE Transactions on Energy Conversion.

[18]  Tohid Rahimi,et al.  EMI consideration of high reliability electrical power subsystem (EPS) of satellite , 2015, The 6th Power Electronics, Drive Systems & Technologies Conference (PEDSTC2015).

[19]  P.N. Enjeti,et al.  Development of an equivalent circuit model of a fuel cell to evaluate the effects of inverter ripple current , 2004, Nineteenth Annual IEEE Applied Power Electronics Conference and Exposition, 2004. APEC '04..

[20]  Nikos D. Hatziargyriou,et al.  Integrating distributed generation into electric power systems: A review of drivers, challenges and opportunities , 2007 .

[21]  Mehran Sabahi,et al.  Reliability Evaluation of Conventional and Interleaved DC–DC Boost Converters , 2015, IEEE Transactions on Power Electronics.

[22]  Xu Yang,et al.  Zero-Voltage Switching PWM Three-Level Full-Bridge DC–DC Converter With Wide ZVS Load Range , 2013 .

[23]  Rong-Jong Wai,et al.  Grid-Connected Photovoltaic Generation System , 2008, IEEE Transactions on Circuits and Systems I: Regular Papers.

[24]  Yung-Ruei Chang,et al.  High-Efficiency Power Conversion System for Kilowatt-Level Stand-Alone Generation Unit With Low Input Voltage , 2008, IEEE Transactions on Industrial Electronics.

[25]  Fred C. Lee,et al.  An experimental comparison of conducted EMI emissions between a zero-voltage transition circuit and a hard switching circuit , 1996, PESC Record. 27th Annual IEEE Power Electronics Specialists Conference.

[26]  B.-R. Lin,et al.  Implementation of a parallel zero-voltage switching DC-DC converter with fewer active switches , 2012 .

[27]  Sudip K. Mazumder,et al.  Effects of Electrical Feedbacks on Planar Solid Oxide Fuel Cell , 2007 .

[28]  R. Seyezhai,et al.  Design and analysis of Interleaved Boost Converter for renewable energy source , 2012, 2012 International Conference on Computing, Electronics and Electrical Technologies (ICCEET).

[29]  Yao-Ching Hsieh,et al.  An Interleaved Boost Converter With Zero-Voltage Transition , 2009, IEEE Transactions on Power Electronics.

[30]  Chung-Yuen Won,et al.  Auxiliary Switch Control of a Bidirectional Soft-Switching DC/DC Converter , 2013, IEEE Transactions on Power Electronics.

[31]  Gevork B. Gharehpetian,et al.  Reliability Considerations for Parallel Performance of Semiconductor Switches in High-Power Switching Power Supplies , 2009, IEEE Transactions on Industrial Electronics.

[32]  Haci Bodur,et al.  A new zero-voltage transition pulse width modulated boost converter , 2011 .

[33]  T. Meynard,et al.  Interactions Between Fuel Cells and Power Converters: Influence of Current Harmonics on a Fuel Cell Stack , 2007, IEEE Transactions on Power Electronics.

[34]  J.A. Ortega,et al.  Moving towards a more electric aircraft , 2007, IEEE Aerospace and Electronic Systems Magazine.

[35]  Dehong Xu,et al.  Seamless Transfer Control Strategy for Fuel Cell Uninterruptible Power Supply System , 2013, IEEE Transactions on Power Electronics.

[36]  Ali Davoudi,et al.  Reliability Analysis Framework for Structural Redundancy in Power Semiconductors , 2013, IEEE Transactions on Industrial Electronics.