Microstructural characterization of thermal barrier coatings on high pressure turbine blades

Abstract Thermal barrier coated high pressure turbine blades were characterized before and after the service by microstructural analysis and Cr3+ photostimulated luminescence piezo-spectroscopy. Thermal barrier coatings, in this study, consisted of electron beam physical vapor deposited yttria partially stabilized zirconia (YSZ; ZrO2–8 wt.% Y2O3), vapor-deposited aluminide bond coat and Ni-base superalloy. Compressive residual stress in thermally grown oxide, measured by Cr3+ photostimulated luminescence piezo-spectroscopy, was observed to be in the order of 2.5∼3.0 GPa and varied slightly as a function of substrate geometry. X-Ray diffraction and scanning electron microscopy equipped with energy dispersive X-ray spectroscopy were utilized to investigate the microstructural development of thermal barrier coatings. The as-deposited non-equilibrium tetragonal (t′) phase in the YSZ coatings was observed to decompose after the service, but the monoclinic (m) phase was only found in the YSZ coatings with concave substrate curvature on the pressure side of the HPT blade. Also, a significant sintering of ZrO2–8 wt.% Y2O3 coating after the service was observed in the microstructure. Localized spallation of YSZ occurred within the thermally grown oxide (mostly α-Al2O3) and within the ZrO2–8 wt.% Y2O3 coating for pressure and suction sides of the serviced high pressure turbine blade near the tip, respectively.

[1]  D. Clarke,et al.  Piezospectroscopic Determination of Residual Stresses in Polycrystalline Alumina , 1994 .

[2]  David R. Clarke,et al.  Nondestructive evaluation of the oxidation stresses through thermal barrier coatings using Cr3+ piezospectroscopy , 1996 .

[3]  R. A. Miller,et al.  Phase stability in plasma-sprayed, partially stabilized zirconia-yttria , 1981 .

[4]  K. Stern.  Metallurgical and ceramic protective coatings , 1996 .

[5]  H. G. Scott,et al.  Phase relationships in the zirconia-yttria system , 1975 .

[6]  David R. Clarke,et al.  Determination of the Piezospectroscopic Coefficients for Chromium‐Doped Sapphire , 1995 .

[7]  Robert A. Miller,et al.  Current status of thermal barrier coatings — An overview , 1987 .

[8]  Y. Sohn,et al.  Microstructural development in physical vapour-deposited partially stabilized zirconia thermal barrier coatings , 1994 .

[9]  E. Jordan,et al.  Nondestructive evaluation of residual stress for thermal barrier coated turbine blades by Cr3+ photoluminescence piezospectroscopy , 2000 .

[10]  D. Clarke,et al.  Wrinkling of α-alumina films grown by thermal oxidation—I. Quantitative studies on single crystals of Fe–Cr–Al alloy , 1998 .

[11]  Y. Sohn,et al.  Isothermal oxidation of physical vapor deposited partially stabilized zirconia thermal barrier coatings , 1994, Journal of materials engineering and performance (Print).

[12]  David R. Clarke,et al.  Stress Measurement in Single‐Crystal and Polycrystalline Ceramics Using Their Optical Fluorescence , 1993 .

[13]  David R. Clarke,et al.  Observation of Subcritical Spall Propagation of a Thermal Barrier Coating , 1998 .