Coreless Transmitting Coils With Conductive Magnetic Shield for Wide-Range Ubiquitous IPT

New coreless transmitting (Tx) coils with a conductive material plate for wide-range ubiquitous inductive power transfer (IPT) zones, i.e., U-IPT zones, where electric devices can be wirelessly charged during operation, are proposed in this paper. Because commercialized IPT systems are only available for short distances of several centimeters and one-to-one charging, the demand is increasing for U-IPT zones in which long-distance wireless charging with three-dimensional (3-D) free-positioning and simultaneous charging of multiple receiving (Rx) coils can be achieved. To satisfy this demand, U-IPT zones should be constructed to have a uniform magnetic field distribution in a wide space, which also poses no risk to the human body. In addition, to generate a uniform magnetic field in a wide 3-D space, such as a single room, the system requires the installation of many Tx coils above the ceilings and behind the walls of the room, and these coils should be capable of high electrical performance to support the efficiency of the entire IPT system and should be of excellent mechanical quality. Therefore, a U-IPT zone should meet the following four criteria: human safety, free-positioning of Rx coils, magnetic field uniformity, and economization. By virtue of a conductive material plate that cancels out the undesired direction of magnetic flux generated from the return wires, the proposed coreless Tx coil does not need any heavy ferromagnetic cores, which can cause nonuniformity of the magnetic field distribution and difficult construction. A prototype coreless Tx coil with the dimensions of 1 m × 1 m × 10 cm was fabricated and experimentally verified for a 1 m × 1 m U-IPT zone. The experimental results showed that 74%, 83%, and 76% high magnetic field uniformity could be achieved for $z_{1}= {{25}}$ cm, 50 cm, and 75 cm, respectively, and a 3-D omnidirectional wireless power delivery was achieved, while the guideline of the International Commission on Non-Ionizing Radiation Protection for human safety was satisfied throughout the entire U-IPT zone. Moreover, the weight of the entire system was only 9 kg, enabling easy installation. In the multiple wireless charging experiments, 47 W of power was consumed in total by load resistors, each of them connected to nine Rx coils, respectively, with 32% power efficiency at $z_{1}= {{20}}$ cm.

[1]  J. Huh,et al.  Narrow-Width Inductive Power Transfer System for Online Electrical Vehicles , 2011, IEEE Transactions on Power Electronics.

[2]  Chun T. Rim,et al.  Six Degrees of Freedom Mobile Inductive Power Transfer by Crossed Dipole Tx and Rx Coils , 2016, IEEE Transactions on Power Electronics.

[3]  Seungyoung Ahn,et al.  Low frequency electromagnetic field reduction techniques for the On-Line Electric Vehicle (OLEV) , 2010, 2010 IEEE International Symposium on Electromagnetic Compatibility.

[4]  John Boys,et al.  An AC processing pickup for IPT systems , 2009, 2009 IEEE Energy Conversion Congress and Exposition.

[5]  A. W. Green,et al.  10 kHz inductively coupled power transfer-concept and control , 1994 .

[6]  Aiguo Patrick Hu,et al.  A Frequency Control Method for Regulating Wireless Power to Implantable Devices , 2008, IEEE Transactions on Biomedical Circuits and Systems.

[7]  S. Y. Choi,et al.  Asymmetric Coil Sets for Wireless Stationary EV Chargers With Large Lateral Tolerance by Dominant Field Analysis , 2014, IEEE Transactions on Power Electronics.

[8]  Chunting Chris Mi,et al.  Feasibility study on bipolar pads for efficient wireless power chargers , 2014, 2014 IEEE Applied Power Electronics Conference and Exposition - APEC 2014.

[9]  Byunghun Lee,et al.  Characterization of novel Inductive Power Transfer Systems for On-Line Electric Vehicles , 2011, 2011 Twenty-Sixth Annual IEEE Applied Power Electronics Conference and Exposition (APEC).

[10]  Junji Hirai,et al.  Decentralized control of machines with the use of inductive transmission of power and signal , 1994, Proceedings of 1994 IEEE Industry Applications Society Annual Meeting.

[11]  J. Huh,et al.  Finite-Width Magnetic Mirror Models of Mono and Dual Coils for Wireless Electric Vehicles , 2013, IEEE Transactions on Power Electronics.

[12]  Gyu-Hyeong Cho,et al.  Active EMF cancellation method for I-type pickup of On-Line Electric Vehicles , 2011, 2011 Twenty-Sixth Annual IEEE Applied Power Electronics Conference and Exposition (APEC).

[13]  Tommaso Campi,et al.  Magnetic shielding of wireless power transfer systems , 2014, 2014 International Symposium on Electromagnetic Compatibility, Tokyo.

[14]  Chunting Chris Mi,et al.  Wireless Power Transfer for Electric Vehicle Applications , 2015, IEEE Journal of Emerging and Selected Topics in Power Electronics.

[15]  Xun Liu,et al.  A Novel Single-Layer Winding Array and Receiver Coil Structure for Contactless Battery Charging Systems With Free-Positioning and Localized Charging Features , 2011, IEEE Transactions on Industrial Electronics.

[16]  Wentai Liu,et al.  Design and analysis of an adaptive transcutaneous power telemetry for biomedical implants , 2005, IEEE Transactions on Circuits and Systems I: Regular Papers.

[17]  Vincenzo Cirimele,et al.  Performance evaluation of wireless power transfer systems for electric vehicles using the opposition method , 2015, 2015 IEEE 1st International Forum on Research and Technologies for Society and Industry Leveraging a better tomorrow (RTSI).

[18]  Eun S. Lee,et al.  A Modularized IPT With Magnetic Shielding for a Wide-Range Ubiquitous Wi-Power Zone , 2018, IEEE Transactions on Power Electronics.

[19]  H. Chung,et al.  Evaluation of the shielding effects on printed-circuit-board transformers using ferrite plates and copper sheets , 2002 .

[20]  Sungwoo Lee,et al.  High performance inductive power transfer system with narrow rail width for On-Line Electric Vehicles , 2010, 2010 IEEE Energy Conversion Congress and Exposition.

[21]  Joungho Kim,et al.  Suppression of leakage magnetic field from a wireless power transfer system using ferrimagnetic material and metallic shielding , 2012, 2012 IEEE International Symposium on Electromagnetic Compatibility.

[22]  Sungwoo Lee,et al.  On-Line Electric Vehicle using inductive power transfer system , 2010, 2010 IEEE Energy Conversion Congress and Exposition.

[23]  Chun T. Rim,et al.  Dipole-Coil-Based Wide-Range Inductive Power Transfer Systems for Wireless Sensors , 2016, IEEE Transactions on Industrial Electronics.

[24]  Hao Hu,et al.  Misalignment Sensitivity of Strongly Coupled Wireless Power Transfer Systems , 2017, IEEE Transactions on Power Electronics.

[25]  Chun T. Rim,et al.  Comparisons of magnetic field shaping methods for ubiquitous wireless power transfer , 2015, 2015 IEEE PELS Workshop on Emerging Technologies: Wireless Power (2015 WoW).

[26]  Jacobus Daniel van Wyk,et al.  Sliding transformers for linear contactless power delivery , 1997, IEEE Trans. Ind. Electron..

[27]  J. Huh,et al.  New Cross-Segmented Power Supply Rails for Roadway-Powered Electric Vehicles , 2013, IEEE Transactions on Power Electronics.

[28]  P. D. Mitcheson,et al.  Maximizing DC-to-Load Efficiency for Inductive Power Transfer , 2013, IEEE Transactions on Power Electronics.

[29]  G. Covic,et al.  A New Concept: Asymmetrical Pick-Ups for Inductively Coupled Power Transfer Monorail Systems , 2006, IEEE Transactions on Magnetics.

[30]  John T Boys,et al.  A Series-Tuned Inductive-Power-Transfer Pickup With a Controllable AC-Voltage Output , 2011, IEEE Transactions on Power Electronics.

[31]  Grant Covic,et al.  Inductive Power Transfer , 2013, Proceedings of the IEEE.

[32]  Dong-Ho Cho,et al.  Coil Design and Shielding Methods for a Magnetic Resonant Wireless Power Transfer System , 2013, Proceedings of the IEEE.

[33]  Gyu-Hyeong Cho,et al.  Two-Dimensional Inductive Power Transfer System for Mobile Robots Using Evenly Displaced Multiple Pickups , 2014, IEEE Transactions on Industry Applications.

[34]  Joungho Kim,et al.  Design of conductive shield for wireless power transfer system for electric vehicle considering automotive body , 2015, 2015 IEEE International Symposium on Electromagnetic Compatibility (EMC).

[35]  A Menciassi,et al.  Wireless powering for a self-propelled and steerable endoscopic capsule for stomach inspection. , 2009, Biosensors & bioelectronics.

[36]  Y. Perriard,et al.  Design of a Contactless Energy-Transfer System for Desktop Peripherals , 2011, IEEE Transactions on Industry Applications.

[37]  Suyong Choi,et al.  Ultra-slim S-type Inductive Power Transfer System for Roadway Powered Electric Vehicles , 2014 .

[38]  Mutsuo Nakaoka,et al.  Leakage magnetic field reduction from Wireless Power Transfer system embedding new eddy current-based shielding method , 2015, 2015 International Conference on Electrical Drives and Power Electronics (EDPE).

[39]  Franklin Bien,et al.  Efficiency improvement for magnetic resonance based wireless power transfer with axial-misalignment , 2012 .

[40]  Chun T. Rim,et al.  Optimal shaped dipole-coil design and experimental verification of inductive power transfer system for home applications , 2016, 2016 IEEE Applied Power Electronics Conference and Exposition (APEC).

[41]  Grant Covic,et al.  Multiphase Pickups for Large Lateral Tolerance Contactless Power-Transfer Systems , 2010, IEEE Transactions on Industrial Electronics.

[42]  Tianjia Sun,et al.  Integrated omnidirectional wireless power receiving circuit for wireless endoscopy , 2012 .

[43]  Gyu-Hyeong Cho,et al.  Omni-directional inductive power transfer system for mobile robots using evenly displaced multiple pick-ups , 2012, 2012 IEEE Energy Conversion Congress and Exposition (ECCE).

[44]  Joungho Kim,et al.  Magnetic field design for high efficient and low EMF wireless power transfer in on-line electric vehicle , 2011, Proceedings of the 5th European Conference on Antennas and Propagation (EUCAP).

[45]  Bo-Hyung Cho,et al.  An energy transmission system for an artificial heart using leakage inductance compensation of transcutaneous transformer , 1996 .

[46]  Yaping Du,et al.  Principles of power-frequency magnetic field shielding with flat sheets in a source of long conductors , 1996 .

[47]  E. Waffenschmidt Homogeneous Magnetic Coupling for Free Positioning in an Inductive Wireless Power System , 2015, IEEE Journal of Emerging and Selected Topics in Power Electronics.

[48]  A.P. Hu,et al.  Wireless Power Supply for Implantable Biomedical Device Based on Primary Input Voltage Regulation , 2007, 2007 2nd IEEE Conference on Industrial Electronics and Applications.