Sub-6dB Aluminum Scandium Nitride Acoustic Delay Lines

This work reports an acoustic delay line (ADL) based on aluminum scandium nitride. In order to reduce the fabrication difficulty and AlScN defects at the bottom electrode edges, a floating bottom electrode is utilized in this acoustic delay line design. ADLs are fabricated with up to 200 µm flat delay gap by Al0.7Sc0.3N and AlN thin film. The increase of piezoelectric coefficient resulting from the 30% Sc doping enhances the electromechanical coupling by more than a factor of 2, compared to AlN. This design achieves an insertion loss of sub-6db without patterned bottom electrodes. With Al0.7Sc0.3N thin film, an insertion loss of 5.8 dB and a fractional bandwidth (FBW) of 6.0% are obtained at 650 MHz. Compared to the same design AlN device, insertion loss reduced by 27% and fractional bandwidth increased by 9%. This design gives an alternative to low-loss ADLs which does not require consideration of alignment between top and bottom layers.

[1]  A. Mazzalai,et al.  High Quality Co-Sputtering AlScN Thin Films for Piezoelectric Lamb-Wave Resonators , 2022, Journal of microelectromechanical systems.

[2]  A. Mazzalai,et al.  Al0.7Sc0.3N butterfly-shaped laterally vibrating resonator with a figure-of-merit (kt2·Qm) over 146 , 2022, Applied Physics Letters.

[3]  A. Mazzalai,et al.  Low Loss Al0.7Sc0.3N Thin Film Acoustic Delay Lines , 2022, IEEE Electron Device Letters.

[4]  Tao Wu,et al.  High Figure-of-Merit Lamb Wave Resonators Based on Al0.7Sc0.3N Thin Film , 2021, IEEE Electron Device Letters.

[5]  R. Olsson,et al.  Al0.68Sc0.32N Lamb wave resonators with electromechanical coupling coefficients near 10.28% , 2021 .

[6]  B. Wagner,et al.  AlScN-based MEMS magnetoelectric sensor , 2020 .

[7]  Ruochen Lu,et al.  Low-Loss 5-GHz First-Order Antisymmetric Mode Acoustic Delay Lines in Thin-Film Lithium Niobate , 2020, IEEE Transactions on Microwave Theory and Techniques.

[8]  Ruochen Lu,et al.  A Unidirectional Transducer Design for Scaling GHz AlN-Based RF Microsystems , 2020, IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control.

[9]  Ming-Huang Li,et al.  Low Phase Noise RF Oscillators Based on Thin-Film Lithium Niobate Acoustic Delay Lines , 2020, Journal of Microelectromechanical Systems.

[10]  Bangtao Chen,et al.  Over 12% of Coupling Coefficient Demonstrated by 3GHz Sc0.12Al0.88N Based Laterally Coupled Alternating Thickness (LCAT) Mode Resonators , 2019, 2019 IEEE International Ultrasonics Symposium (IUS).

[11]  T. Itoh,et al.  Scandumu aluminium nitride vibration energy harvester with a stres compensation , 2017, 2017 19th International Conference on Solid-State Sensors, Actuators and Microsystems (TRANSDUCERS).

[12]  Wen Wang,et al.  Optimal design on SAW sensor for wireless pressure measurement based on reflective delay line , 2007 .

[13]  Ikmo Park,et al.  A novel wireless, passive CO2 sensor incorporating a surface acoustic wave reflective delay line , 2007 .

[14]  V. M. Makarov,et al.  Low-loss SAW filters using new SPUDT structures , 1997, 1997 IEEE Ultrasonics Symposium Proceedings. An International Symposium (Cat. No.97CH36118).

[15]  Marc Solal,et al.  SPUDT-based filters: design principles and optimization , 1995, 1995 IEEE Ultrasonics Symposium. Proceedings. An International Symposium.