Full-face excavation of large tunnels in difficult conditions

Abstract Following a few preliminary remarks on the tunneling methods at the beginning of the 20th century, the successful applications of the full-face method also in difficult conditions are underlined. The attention is posed on the use of a systematic reinforcement of the face and of the ground, by means of fiber-glass elements. A selection of tunnels where this method was used successfully is reported with the purpose of illustrating the wide spectrum of ground conditions where it has been applied. Then, following a description of the main concepts behind the method, the attention moves from the so-called “heavy method”, where deformations are restrained, to the “light method”, where deformations are allowed with the intention to decrease the stresses acting on the primary and final linings. The progress in the application of the “light method” is underlined, up to the development of a novel technique, which relies on the use of a yielding support composed of top head steel sets with sliding joints and special deformable elements inserted in the primary lining. The well-known case study of the Saint Martin La Porte access adit, along the Lyon-Turin Base Tunnel, is described. In this tunnel, a yield-control support system combined with full-face excavation has been adopted successfully in order to cope with the large deformations experienced during face advance through the Carboniferous formation. The monitoring results obtained during excavation are illustrated, together with the modeling studies performed when paying attention to the rock mass time-dependent behavior.