Effect of operating parameters on dynamic response of water-to-gas membrane humidifier for proton exchange membrane fuel cell vehicle

Abstract An analytic multi-dimensional dynamic model of a membrane type humidifier has been developed for the study of transient responses of the humidifier under proton exchange membrane fuel cell vehicle operating conditions. The dynamic responses of heat and mass transfer and fluid flow in a membrane humidifier are mathematically formulated and modeled with a newly developed pseudo-multi-dimensional concept. The model is used to analyze the performance of the humidifier under various operating conditions and the dynamic response of the humidifier under transient operating conditions. The simulation results show that, in the case of the water-to-gas type membrane humidifier modeled in this study, the time constant of water diffusion in the membrane is less than 1 s. Thus, the delay of the response of the humidifier induced by the vapor diffusion in the membrane is not significant in vehicle operation. However, it is also found that the dynamic behavior is mainly due to the thermal resistance and heat capacity of the membrane humidifier.

[1]  In-Hwan Oh,et al.  An analytical model of Nafion™ membrane humidifier for proton exchange membrane fuel cells , 2009 .

[2]  James Larminie,et al.  Fuel Cell Systems Explained , 2000 .

[3]  A. Eisenberg,et al.  Physical properties and supermolecular structure of perfluorinated ion‐containing (nafion) polymers , 1977 .

[4]  Yi Jiang,et al.  HEAT AND MASS TRANSFER IN A MEMBRANE-BASED ENERGY RECOVERY VENTILATOR , 1999 .

[5]  Song-Yul Choe,et al.  Dynamic modeling and analysis of a shell-and-tube type gas-to-gas membrane humidifier for PEM fuel cell applications , 2008 .

[6]  T. Nguyen,et al.  Effect of direct liquid water injection and interdigitated flow field on the performance of proton exchange membrane fuel cells , 1998 .

[7]  I. Oh,et al.  Characteristics of membrane humidifiers for polymer electrolyte membrane fuel cells , 2005 .

[8]  A. D. Young,et al.  An Introduction to Fluid Mechanics , 1968 .

[9]  Kyoungdoug Min,et al.  Two dimensional dynamic modeling of a shell-and-tube water-to-gas membrane humidifier for proton exchange membrane fuel cell , 2010 .

[10]  D. Chu,et al.  Performance of polymer electrolyte membrane fuel cell (PEMFC) stacks. Part I. Evaluation and simulation of an air-breathing PEMFC stack , 1999 .

[11]  Richard Edwin Sonntag,et al.  Fundamentals of Thermodynamics , 1998 .

[12]  R. Rautenbach,et al.  Separation of organic binary mixtures by pervaporation , 1980 .

[13]  G. Trägårdh,et al.  Heat transfer in pervaporation , 1996 .

[14]  Huei Peng,et al.  A Thermodynamic Model of Membrane Humidifiers for PEM Fuel Cell Humidification Control , 2005 .

[15]  T. Fuller,et al.  Water and Thermal Management in Solid‐Polymer‐Electrolyte Fuel Cells , 1993 .

[16]  Frank P. Incropera,et al.  Fundamentals of Heat and Mass Transfer , 1981 .

[17]  Shimshon Gottesfeld,et al.  Determination of water diffusion coefficients in perfluorosulfonate ionomeric membranes , 1991 .

[18]  Zongqiang Mao,et al.  Hydrogen–air pemfc operation with extraordinarily low gas pressures and internal humidification—conception and experimental prototype stack , 1999 .

[19]  Felix N. Büchi,et al.  Operating Proton Exchange Membrane Fuel Cells Without External Humidification of the Reactant Gases Fundamental Aspects , 1997 .

[20]  Ralph E. White,et al.  A water and heat management model for proton-exchange-membrane fuel cells , 1993 .

[21]  J. Weidner,et al.  Diffusion of water in Nafion 115 membranes , 2000 .

[22]  Stefan Pischinger,et al.  Compressor Expander Units for Fuel Cell Systems , 2000 .