The finite element analysis of sheet forming processes needs precise and reproducible data of the tribological conditions, which influence the material flow during the process. In this work the friction coefficient and its dependency on the hardness and surface topography of the blank are investigated. The selected materials are four steels with different surface qualities and coatings, FeP04, ZStE340, DP450 and TRIP800, which are joined by laser welding. Moreover, each material both with and without weld seam, was tested at three different values of normal contact pressure in a strip drawing test. The topography of both the base material and the weld line was obtained by measuring the surface roughness and implementing the data in a surface analysis software. Micro-hardness profiles along the tailored welded blanks were also determined. The strip drawing test was used to measure the friction coefficient between sheet metal and tool both in the case of tailored welded blanks and base material. The comparison between the results obtained for base materials and tailored welded blanks shows that the presence of the weld seam causes a clear increase of the friction between blank and tool.
[1]
H. Kudo,et al.
Direct Observation of Contact Behaviour to Interpret the Pressure Dependence of the Coefficient of Friction in Sheet Metal Forming
,
1995
.
[2]
Hisashi Kusuda,et al.
Formability of tailored blanks
,
1997
.
[3]
H. Tsuda,et al.
Weight Reduction and Improvement of Safety Level in Impacts with High Strength Steels Tailored Blanks Technology
,
2003
.
[4]
M. Geiger,et al.
Three-dimensional characterization of surfaces for sheet metal forming
,
1998
.
[5]
Robert John Lark,et al.
The use of tailored blanks in the manufacture of construction components
,
2001
.
[6]
J. Jeswiet,et al.
Tensile testing for weld deformation properties in similar gage tailor welded blanks using the rule of mixtures
,
2001
.