Using laser altimetry to detect topographic change at Long Valley caldera, California

Long Valley caldera, California, is a site of extensive volcanism, persistent seismicity, and uplift of a resurgent dome, currently at a rate of approximately 3 cm/year. Airborne laser altimetry was used to determine the surface topography of the region in 1993. A repeat mission occurred in 1995. Three different laser altimeters were flown, dubbed ATLAS, SLICER and RASCAL. Data processing consists of the combination of the aircraft trajectory and attitude data with the laser range, the determination of an atmospheric delay, laser pulse timing errors, laser system biases, and data geolocation to obtain the position of the laser spot on the ground. Results showed that using the ATLAS and SLICER instruments, the elevation of an overflown lake is determined to precisions of 3.3 cm and 2.9 cm from altitudes of 500 m and 3 km above the ground, and approximately 10 cm using the RASCAL instrument from 500 m above ground. Comparison with tide gauge data showed the laser measurements are able to resolve centimeter- level changes in the lake elevation over time. Repeat pass analysis of tracks over flat surfaces indicate no systematic biases affect the measurement procedure of the ATLAS and SLICER instruments. Comparison of GPS and laser-derived elevations of easily-identifiable features in the caldera confirm the horizontal accuracy of the measurement is within the diameter of the laser footprint, and vertical accuracy is within the error inherent in the measurement. Crossover analysis shows that the standard error of the means at track intersection points within the caldera and dome (i.e., where zero and close to the maximum amount of uplift is expected) are about 1 cm, indicating elevation change at the 3 cm/year level should be detectable. We demonstrate one of the powerful advantages of scanning laser altimetry over other remote sensing techniques; the straightforward creation of precise digital elevation maps of overflown terrain. Initial comparison of the 1993 - 1995 data indicates uplift occurred, but filtering is required to remove vegetation effects. Although research continues to utilize the full potential of laser altimetry data, the results constitute a successful demonstration that the technique may be used to perform geodetic monitoring of surface topographic change.

[1]  R. A. Bailey,et al.  Active tectonic and magmatic processes beneath Long Valley Caldera, eastern California: An overview , 1985 .

[2]  J. C. Savage,et al.  Earthquake Swarm in Long Valley Caldera, California, January 1983: Evidence for Dike Inflation , 1984 .

[3]  R. Denlinger,et al.  Deformation of Long Valley Caldera, Mono County, California, from 1975 to 1982 , 1984 .

[4]  Giovanni Alberti,et al.  The TOPSAR interferometric radar topographic mapping instrument , 1992, IEEE Trans. Geosci. Remote. Sens..

[5]  D. Marquardt.  An Algorithm for Least-Squares Estimation of Nonlinear Parameters , 1963 .

[6]  James Abshire,et al.  The Geoscience Laser Altimetry/Ranging System , 1987, IEEE Transactions on Geoscience and Remote Sensing.

[7]  John B. Rundle,et al.  Shallow and peripheral volcanic sources of inflation revealed by modeling two‐color geodimeter and leveling data from Long Valley Caldera, California, 1988–1992 , 1995 .

[8]  J W Head,et al.  Topography of the northern hemisphere of Mars from the Mars Orbiter Laser Altimeter. , 1998, Science.

[9]  T. D. Clem,et al.  Airborne lidar for profiling of surface topography , 1991 .

[10]  D. B. Coyle,et al.  Vegetation and topography mapping with an airborne laser altimeter using a high-efficiency laser and a scannable field-of-view telescope , 1996 .

[11]  Richard E. Lingenfelter,et al.  Apollo laser altimetry and inferences as to lunar structure , 1974 .

[12]  C. Miller,et al.  Holocene eruptions at the Inyo volcanic chain, California: Implications for possible eruptions in Long Valley caldera , 1985 .

[13]  J. C. Savage,et al.  Deformation near the Long Valley Caldera, eastern California, 1982–1986 , 1987 .

[14]  John Langbein,et al.  Continuous monitoring of surface deformation at Long Valley Caldera, California, with GPS , 1997 .

[15]  Chester S. Gardner,et al.  Ranging performance of satellite laser altimeters , 1992, IEEE Trans. Geosci. Remote. Sens..

[16]  D. Hill,et al.  An episode of reinflation of the Long Valley Caldera, eastern California: 1989–1991 , 1993 .

[17]  D.L. Rabine,et al.  Development and test of a raster scanning laser altimeter for high resolution airborne measurements of topography , 1996, IGARSS '96. 1996 International Geoscience and Remote Sensing Symposium.

[18]  K. Sieh,et al.  Range front faulting and volcanism in the Mono Basin, eastern California , 1989 .

[19]  David E. Smith,et al.  The Mars Observer laser altimeter investigation , 1992 .

[20]  M. T. Boies,et al.  The Near-Earth Asteroid Rendezvous Laser Altimeter , 1997 .

[21]  D. B. Coyle,et al.  Optimization of an airborne laser altimeter for remote sensing of vegetation and tree canopies , 1994, Proceedings of IGARSS '94 - 1994 IEEE International Geoscience and Remote Sensing Symposium.

[22]  D. Harding,et al.  Observations of the Earth's topography from the Shuttle Laser Altimeter (SLA): Laser-pulse Echo-recovery measurements of terrestrial surfaces , 1998 .

[23]  Kenneth C. Jezek,et al.  Greenland ice sheet thickness changes measured by laser altimetry , 1994 .

[24]  Jeffrey R. Ridgway,et al.  The development of a deep-towed gravity meter, and its use in marine geophysical surveys of offshore southern California and an airborne laser altimeter survey of Long Valley, California , 1997 .

[25]  Timothy H. Dixon,et al.  Inflation of Long Valley Caldera from one year of continuous GPS observations , 1995 .

[26]  J. Garvin.  Topographic characterization and monitoring of volcanoes via airborne laser altimetry , 1996, Geological Society, London, Special Publications.