Flow Loop Experiments Using Polyalphaolefin Nanofluids

Experiments were performed using a flow-loop apparatus to explore the performance of nanofluids in cooling applications. The experiments were performed using exfoliated graphite nanoparticle fibers suspended in polyalphaolefin at mass concentrations of 0.6 and 0.3 %. The experimental setup consisted of a test section containing a plain offset fin cooler apparatus (gap or nongap fin), which was connected to a flow loop consisting of a gear pump, a shell and tube heat exchanger (that was cooled or heated by a constant temperature bath chiller/heater), and a reservoir. Experiments were conducted using nanofluid and polyalphaolefin for two different fin strip layouts. Heat transfer data were obtained by parametrically varying the operating conditions (heat flux and flow rates). The heat transfer data for nanofluids were compared with the heat transfer data for neat polyalphaolefin fluid under similar conditions. The change in surface morphology of the fins was investigated using scanning electron micrography. The nanofluid properties were measured using rheometry for the viscosity, differential scanning calorimetry for the specific heat, and laser flash apparatus for the thermal diffusivity. It was observed that the viscosity was ∼10 times higher for nanofluids compared with polyalphaolefin and increased with temperature (in contrast, the viscosity of polyalphaolefin decreased with temperature). The specific heat of nanofluids was found to be 50% higher for nanofluids compared with polyalphaolefin and increased with temperature. The thermal diffusivity was found to be 4 times higher for nanofluids compared with polyalphaolefin and increased with temperature. It was found that, in general, the convective heat transfer was enhanced by ∼10% using nanofluids compared with using polyalphaolefin. Scanning electron micrography measurements show that the nanofluids deposit nanoparticles on the surface, which act as enhanced heat transfer surfaces (nanofins).

[1]  E. Grulke,et al.  Heat transfer properties of nanoparticle-in-fluid dispersions (nanofluids) in laminar flow , 2005 .

[2]  A. Mujumdar,et al.  Heat transfer characteristics of nanofluids: a review , 2007 .

[3]  Y. Xuan,et al.  Investigation on Convective Heat Transfer and Flow Features of Nanofluids , 2003 .

[4]  W. Roetzel,et al.  Pool boiling characteristics of nano-fluids , 2003 .

[5]  Yulong Ding,et al.  Heat transfer of aqueous suspensions of carbon nanotubes (CNT nanofluids) , 2006 .

[6]  O. K. Crosser,et al.  Thermal Conductivity of Heterogeneous Two-Component Systems , 1962 .

[7]  A. R. Wieting,et al.  Empirical correlations for heat transfer and flow friction characteristics of rectangular offset-fin plate-fin heat exchangers , 1975 .

[8]  P. F. Vassallo,et al.  Pool boiling heat transfer experiments in silica–water nano-fluids , 2004 .

[9]  R. Prasher,et al.  Brownian-motion-based convective-conductive model for the effective thermal conductivity of nanofluids , 2006 .

[10]  J. H. Kim,et al.  Effect of nanoparticles on critical heat flux of water in pool boiling heat transfer , 2003 .

[11]  E. N. Sieder,et al.  Heat Transfer and Pressure Drop of Liquids in Tubes , 1936 .

[12]  J. Eastman,et al.  Novel Thermal Properties of Nanostructured Materials , 1999 .

[13]  Jerry E. Beam,et al.  Comparison of hydraulic and thermal performance of PAO and Coolanol 25R liquid coolants , 1994 .

[14]  J. Maxwell.  A Treatise on Electricity and Magnetism , 1873, Nature.

[15]  B. Wang,et al.  Surface and Size Effects on the Specific Heat Capacity of Nanoparticles , 2006 .

[16]  Saeed Zeinali Heris,et al.  Experimental investigation of oxide nanofluids laminar flow convective heat transfer , 2006 .

[18]  Yulong Ding,et al.  Experimental investigation into convective heat transfer of nanofluids at the entrance region under laminar flow conditions , 2004 .

[19]  J. Eastman,et al.  Measuring Thermal Conductivity of Fluids Containing Oxide Nanoparticles , 1999 .

[20]  A. Kuznetsov,et al.  The onset of convection in a horizontal nanofluid layer of finite depth , 2010 .

[21]  A. Nikolov,et al.  Spreading of nanofluids on solids , 2003, Nature.

[22]  Young I Cho,et al.  HYDRODYNAMIC AND HEAT TRANSFER STUDY OF DISPERSED FLUIDS WITH SUBMICRON METALLIC OXIDE PARTICLES , 1998 .

[23]  D. Banerjee,et al.  Enhancement of specific heat capacity of high-temperature silica-nanofluids synthesized in alkali chloride salt eutectics for solar thermal-energy storage applications , 2011 .

[24]  Ralph L. Webb,et al.  Heat transfer and friction in the offset stripfin heat exchanger , 1987 .

[25]  A. Kuznetsov,et al.  The Onset of Double-Diffusive Nanofluid Convection in a Layer of a Saturated Porous Medium , 2010 .

[26]  D. Cahill,et al.  Thermal conductivity of nanoparticle suspensions , 2006 .

[27]  Lanchao Lin,et al.  Heat transfer correlations for plain fin array cooler , 2002 .

[28]  W. Kaplan,et al.  Ordered Liquid Aluminum at the Interface with Sapphire , 2005, Science.

[29]  D. Cahill,et al.  Nanofluids for thermal transport , 2005 .

[30]  Nandy Putra,et al.  Pool boiling of nano-fluids on horizontal narrow tubes , 2003 .