Sample preparation and image acquisition using optical‐reflective microscopy in the measurement of fiber orientation in thermoplastic composites

A complete sample preparation procedure used to determine three‐dimensional fiber orientation from optical micrographs of glass fiber‐reinforced thermoplastic composites is presented. Considerations for elimination of irregularities in the elliptical footprints, contrast enhancement between fibers and surrounding polymer matrix, controlled‐etching that allows the identification of small shadows where fiber recedes into the matrix, and topographical reconstruction of the elliptical footprint are described in the procedure. This procedure has produced high‐quality optical micrographs employed to obtain accurate fiber orientation data for thermoplastic composites using the method of ellipses. The optimal definition of the nonelliptical footprints’ borders allows an accurate measurement of orientation in small sampling areas.

[1]  P. Wapperom,et al.  Unambiguous orientation in short fiber composites over small sampling area in a center-gated disk , 2012 .

[2]  B. Hayes,et al.  Optical Microscopy of Fiber-Reinforced Composites , 2010 .

[3]  M. Mozetič,et al.  The Role of Crystallinity on Polymer Interaction with Oxygen Plasma , 2009 .

[4]  P. Hine,et al.  Fiber orientation structures and mechanical properties of injection molded short glass fiber reinforced ribbed plates , 2004 .

[5]  K. Chung,et al.  Measurement and numerical simulation of three-dimensional fiber orientation states in injection-molded short-fiber-reinforced plastics , 2003 .

[6]  C. Y. Wang,et al.  The effect of sample preparation on the mechanical properties of nylon 66 , 2003 .

[7]  C N Eberhardt,et al.  Microscopy techniques for materials science , 2002 .

[8]  B. Mlekusch,et al.  Fibre orientation in short-fibre-reinforced thermoplastics I. Contrast enhancement for image analysis , 1999 .

[9]  W. Blumenthal,et al.  Determination of Non-Symmetric 3-D Fiber-Orientation Distribution and Average Fiber Length in Short-Fiber Composites , 1997 .

[10]  A. Clarke,et al.  Large‐area, high‐resolution image analysis of composite materials , 1997 .

[11]  Charles L. Tucker,et al.  Stereological measurement and error estimates for three-dimensional fiber orientation , 1992 .

[12]  Charles L. Tucker,et al.  Fiber orientation in simple injection moldings. Part II: Experimental results , 1992 .

[13]  Charles L. Tucker,et al.  Fiber orientation in simple injection moldings. Part I: Theory and numerical methods , 1991 .

[14]  F. Egitto.  Plasma etching and modification of organic polymers , 1990 .