Heat and moisture transfer in application scale parallel-plates enthalpy exchangers with novel membrane materials

Parallel-plates enthalpy exchangers are one of the most commonly encountered energy recovery devices that are used to simultaneously transfer both sensible heat and moisture between fresh air and exhaust ventilation air. For such equipments, the water vapor sorption properties of the plate materials have tremendous impacts on system performance. In this investigation, three different materials, namely, common paper, CA (cellulose acetate) membrane and a modified CA membrane) are selected as the plate materials for three enthalpy exchangers. Sorption curves and contact angles of these three materials are measured to reflect their hydrophilicity. The steady-state sensible and latent effectiveness of the three exchangers are tested in a special test rig, and the test results are compared with the model predictions. A heat and moisture transfer model for the enthalpy exchangers is proposed. The effects of the varying operating conditions like air flow rates, temperature, and humidity on the sensible and latent effectiveness are evaluated. Both the numerical and experimental results indicate that the moisture resistance through plates is co-determined by thickness, sorption slope, and sorption potential. Moisture diffusivity in various materials is in the same order. So when the plate thickness is fixed, the higher the sorption slopes are, the higher the latent performance is. Of the three exchangers, the exchanger with the modified CA membrane material has the highest performance due to small thickness, steep sorption slope, and large sorption potentials. The paper exchanger has a latent effectiveness of 0.4, while the membranes have latent effectiveness of greater than 0.7.

[1]  M. Douglas LeVan,et al.  Water transport properties of Nafion membranes. Part I. Single-tube membrane module for air drying , 2003 .

[2]  Jianlei Niu,et al.  Energy requirements for conditioning fresh air and the long-term savings with a membrane-based energy recovery ventilator in Hong Kong , 2001 .

[3]  Prabal Talukdar,et al.  An experimental data set for benchmarking 1-D, transient heat and moisture transfer models of hygroscopic building materials. Part I: Experimental facility and material property data , 2007 .

[4]  Edward L Cussler,et al.  Diffusion: Mass Transfer in Fluid Systems , 1984 .

[5]  Li-Zhi Zhang,et al.  Synthesis and characterization of a PVA/LiCl blend membrane for air dehumidification , 2008 .

[6]  J. E. Janssen,et al.  Ventilation for acceptable indoor air quality , 1989 .

[7]  Ross Taylor,et al.  Multicomponent mass transfer , 1993 .

[8]  Y. Jaluria,et al.  An Introduction to Heat Transfer , 1950 .

[9]  E. Cussler,et al.  Membrane Modules for Building Ventilation , 2002 .

[10]  Li-Zhi Zhang.  Investigation of moisture transfer effectiveness through a hydrophilic polymer membrane with a field and laboratory emission cell , 2006 .

[11]  J. Niu,et al.  Effectiveness Correlations for Heat and Moisture Transfer Processes in an Enthalpy Exchanger With Membrane Cores , 2002 .

[12]  Yi Jiang,et al.  HEAT AND MASS TRANSFER IN A MEMBRANE-BASED ENERGY RECOVERY VENTILATOR , 1999 .

[13]  J. Niu,et al.  Membrane-based Enthalpy Exchanger: material considerations and clarification of moisture resistance , 2001 .

[14]  R. Wessling,et al.  Water Transport in Ionic Polymers , 1989 .

[15]  K. Sirkar,et al.  Removal of water vapor and VOCs from nitrogen in a hydrophilic hollow fiber gel membrane permeator , 1996 .