Comments on "A shield-based three-port de-embedding method for microwave on-wafer characterization of deep-submicrometer silicon MOSFETs"

A general three-port S-parameter de-embedding method using shield-based test structures for microwave on-wafer characterization is presented in this paper. This method does not require any physical equivalent-circuit assumption for the surrounding parasitics of a device-under-test. We use one open and three thru dummy devices to remove the parasitic components connected to the gate, drain, and source terminals of a MOSFET. By shielding the lossy silicon substrate, the cross-coupling from port to port can be significantly mitigated, and thus, the parasitics of probe pads and interconnects at each port can be separately subtracted. The MOS transistor and its corresponding dummy structures fabricated in a 0.18-/spl mu/m CMOS process were characterized up to 20 GHz. Compared with the two-port cascade-based de-embedding method, the proposed three-port de-embedding procedure can further eliminate the parasitics associated with the dangling leg in the source terminal. The impacts of the accuracy of the de-embedding technique on device modeling and simulation are also discussed.

[1]  M. J. Deen,et al.  A general procedure for high-frequency noise parameter de-embedding of MOSFETs by taking the capacitive effects of metal interconnections into account , 2001, ICMTS 2001. Proceedings of the 2001 International Conference on Microelectronic Test Structures (Cat. No.01CH37153).

[2]  G. Gonzalez.  Microwave Transistor Amplifiers: Analysis and Design , 1984 .

[3]  E. Vandamme,et al.  Improved three-step de-embedding method to accurately account for the influence of pad parasitics in silicon on-wafer RF test-structures , 2001 .

[4]  Kee Soo Nam,et al.  A novel approach to extracting small-signal model parameters of silicon MOSFET's , 1997 .

[5]  H. Cho,et al.  A three-step method for the de-embedding of high-frequency S-parameter measurements , 1991 .

[6]  J.A.M. Geelen,et al.  An improved de-embedding technique for on-wafer high-frequency characterization , 1991, Proceedings of the 1991 Bipolar Circuits and Technology Meeting.

[7]  T. Kolding,et al.  Test Structures and Techniques for On-Wafer CMOS TRL Calibration , 2001 .

[8]  M. J. Deen,et al.  A general noise and S-parameter deembedding procedure for on-wafer high-frequency noise measurements of MOSFETs , 2001 .

[9]  T. E. Kolding.  Shield-based microwave on-wafer device measurements , 2001 .

[10]  T. E. Kolding,et al.  Simple noise deembedding technique for on-wafer shield-based test fixtures , 2003 .

[11]  Troels Emil Kolding.  A Four-Step Method for De-Embedding Gigahertz , 2000 .

[12]  Seonghearn Lee,et al.  A new parameter extraction technique for small-signal equivalent circuit of polysilicon emitter bipolar transistors , 1994 .

[13]  Hans-Martin Rein,et al.  Methods for measurement and simulation of weak substrate coupling in high-speed bipolar ICs , 2002 .

[14]  S. C. Wang,et al.  A Practical Method to Extract Extrinsic Parameters for the Silicon MOSFET Small- Signal Model , 2004 .

[15]  Troels Emil Kolding.  General accuracy considerations of microwave on-wafer silicon device measurements , 2000, 2000 IEEE MTT-S International Microwave Symposium Digest (Cat. No.00CH37017).

[16]  T. E. Kolding.  Impact of test-fixture forward coupling on on-wafer silicon device measurements , 2000 .

[17]  R. J. Havens,et al.  A calibrated lumped-element de-embedding technique for on-wafer RF characterization of high-quality inductors and high-speed transistors , 2003 .