Towards Prognostics of Electrolytic Capacitors

A remaining useful life prediction algorithm and degradation model for electrolytic capacitors is presented. Electrolytic capacitors are used in several applications ranging from power supplies on critical avionics equipment to power drivers for electro-mechanical actuators. These devices are known for their low reliability and given their criticality in electronics subsystems they are a good candidate for component level prognostics and health management research. Prognostics provides a way to assess remaining useful life of a capacitor based on its current state of health and its anticipated future usage and operational conditions. In particular, experimental results of an accelerated aging test under electrical stresses are presented. The capacitors used in this test form the basis for a remaining life prediction algorithm where a model of the degradation process is suggested. This preliminary remaining life prediction algorithm serves as a demonstration of how prognostics methodologies could be used for electrolytic capacitors.

[1]  S. Parler,et al.  Heat generation during pulse operation of prototype aluminium electrolytic capacitors , 1995 .

[2]  Gautam Biswas,et al.  Experimental Studies of Ageing in Electrolytic Capacitors , 2010 .

[3]  M.H. Azarian,et al.  Failure prognostics of multilayer ceramic capacitors in temperature-humidity-bias conditions , 2008, 2008 International Conference on Prognostics and Health Management.

[4]  Gautam Biswas,et al.  A prognosis case study for electrolytic capacitor degradation in DC-DC converters , 2009 .

[5]  Gautam Biswas,et al.  Integrated diagnostic/prognostic experimental setup for capacitor degradation and health monitoring , 2010, 2010 IEEE AUTOTESTCON.

[6]  Washington Y. Ochieng,et al.  Failure Modes and Models for Integrated GPS/INS Systems , 2007, Journal of Navigation.

[7]  S. Ikonopisov,et al.  Theory of electrical breakdown during formation of barrier anodic films , 1977 .

[8]  M. Pecht,et al.  Prognostics of ceramic capacitor temperature‐humidity‐bias reliability using Mahalanobis distance analysis , 2007 .

[9]  R. Orsagh,et al.  Prognostic health management for avionics system power supplies , 2005, 2005 IEEE Aerospace Conference.

[10]  H. J. de Wit,et al.  The Dielectric Breakdown of Anodic Aluminum Oxide , 1976 .

[11]  Robert F. Stengel,et al.  Optimal Control and Estimation , 1994 .

[12]  Justin Judkins,et al.  Electronic prognostics for switched mode power supplies , 2007, Microelectron. Reliab..

[13]  J. Albella,et al.  Pressure build-up in aluminium electrolytic capacitors under stressed voltage conditions , 1986 .

[14]  Gautam Biswas,et al.  PHYSICS OF FAILURE MODELS FOR CAPACITOR DEGRADATION IN DC-DC CONVERTERS , 2010 .

[15]  Kai Goebel,et al.  Comparison of prognostic algorithms for estimating remaining useful life of batteries , 2009 .

[16]  J.B. Judkins,et al.  A Prognostic Sensor for Voltage Regulated Switch-Mode Power Supplies , 2007, 2007 IEEE Aerospace Conference.

[17]  Chris Chatfield,et al.  The Analysis of Time Series: An Introduction , 1981 .

[18]  Gautam Biswas,et al.  Prognostic Techniques for Capacitor Degradation and Health Monitoring , 2011 .